Oscillation theorems for differential equations with a nonlinear damping term

In this paper, we are concerned with a class of nonlinear second-order differential equations with a nonlinear damping term. Passage to more general class of equations allows us to remove a restrictive condition usually imposed on the nonlinearity, and, as a consequence, our results apply to wider classes of nonlinear differential equations. Two illustrative examples are considered.     

初-边值问题驻波解的渐近稳定性

本文考虑一带有人工粘性的二维定常等熵无旋平面流方程组的初-边值问题. 在一定的假设下,我们证明其驻波解是渐近稳定的.     

Global Smooth Solutions of the Equations of a Viscous,Heat - Conducting,One - Dimensional Gas with Density - Dependent Viscosity

We consider initial boundary value problems for the equations of the one-dimensional motion of a viscous, heat-conducting gas with density-dependent viscosity that decreases (to zero) with decreasing density. We prove that if the viscosity does not decrease to zero too rapidly, then smooth solutions exist globally in time.     

Dynamic mechanical thermal analysis transitions of partially and fully substituted cellulose fatty esters

The main transitions of cellulose fatty esters with different degrees of substitution (DSs) were investigated with dynamic mechanical thermal analysis. Two distinct main relaxations were observed in partially substituted cellulose esters (PSCEs). They were attributed to the glass‐transition temperature and to the chain local motion of the aliphatic substituents. The temperatures of both transitions decreased when DS or the number of carbon atoms (n) of the acyl substituent increased. Conversely, all the transitions of fully substituted cellulose esters occurred within a narrow temperature range, and they did not vary significantly with n. This phenomenon was explained by the formation of a crystalline phase of the fatty substituents. The presence of few residual OH groups in PSCEs was responsible for a large increase in the storage bending modulus, and it eliminated the effect of n on damping. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 281–288, 2003     

Vibration analysis of a beam with PCLD Patch

An analytical approach for vibration response analysis of a beam with single passive constrained layer damping (PCLD) patch is presented. The governing equation of motion of the beam is firstly derived on the basis of an energy approach and the Lagrange equation. The noval contribution is that a third admissible function is introduced to represent the longitudinal displacements of the constraining layer in the PCLD patch when the assumed-modes method is applied for discretizing the governing equation. In conventional analytical approaches, only two admissible functions are used together with a longitudinal static equilibrium equation of a section of base beam or constraining layer. Comparison of the computational results from the proposed analytical approach and the conventional analytical approach as well as a commercial FEM code reveals that the proposed analytical approach can describe the vibration responses of the damped beam more accurately for commonly used viscoelastic material (VEM) layer in the PCLD patch while the conventional analytical approach, in general, overestimates the damping effects of the PCLD patch. The advantages and disadvantages of the proposed analytical approach and conventional analytical approach are discussed through some case studies.     

Viscoelastic properties of nanostructured natural rubber/polystyrene interpenetrating polymer networks

The effects of the blend ratio and initiating system on the viscoelastic properties of nanostructured natural rubber/polystyrene‐based interpenetrating polymer networks (IPNs) were investigated in the temperature range of ?80 to 150 °C. The studies were carried out at different frequencies (100, 50, 10, 1, and 0.1 Hz), and their effects on the damping and storage and loss moduli were analyzed. In all cases, tan δ and the storage and loss moduli showed two distinct transitions corresponding to natural rubber and polystyrene phases, which indicated that the system was not miscible on the molecular level. However, a slight inward shift was observed in the IPNs, with respect to the glass‐transition temperatures (T_g's) of the virgin polymers, showing a certain degree of miscibility or intermixing between the two phases. When the frequency increased from 0.1 to 100 Hz, the T_g values showed a positive shift in all cases. In a comparison of the three initiating systems (dicumyl peroxide, benzoyl peroxide, and azobisisobutyronitrile), the dicumyl peroxide system showed the highest modulus. The morphology of the IPNs was analyzed with transmission electron microscopy. The micrographs indicated that the system was nanostructured. An attempt was made to relate the viscoelastic behavior to the morphology of the IPNs. Various models, such as the series, parallel, Halpin–Tsai, Kerner, Coran, Takayanagi, and Davies models, were used to model the viscoelastic data. The area under the linear loss modulus curve was larger than that obtained by group contribution analysis; this showed that the damping was influenced by the phase morphology, dual‐phase continuity, and crosslinking of the phases. Finally, the homogeneity of the system was further evaluated with Cole–Cole analysis. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1680–1696, 2003     

快度中心区强子物质输运系数和粘滞流体演化

用Chapman-Enskog方法计算了相对论性重离子碰撞快度中心区产生的π介子物质的输运系数,并建立了相应的粘滞流体力学方程,进而讨论了粘滞对π介子物质演化过程的影响.结果表明,粘滞将减缓快度中心区π介子物质的冷却速度.     

Stress and heat flux stabilization for viscous compressible medium equations with a nonmonotone state function

We study a system of quasilinear equations describing one-dimensional flow of a viscous compressible heat-conducting medium with a nonmonotone state function and mass force. The large-time behavior of solutions is considered for arbitrarily large initial data. In spite of possible nonuniqueness and discontinuity of the stationary solution, we prove L²-stabilization for the stress and heat flux as t → ∞ along with corresponding global energy estimates for them. The new method of proof utilizes a combination of energy type equalities for the stress and heat flux. Consequently, H¹-stabilization of the velocity and temperature along with global estimates for their derivatives are valid as well.     

Effect of Pressure on Fluid Damping in MEMS Torsional Resonators with Flow Ranging from Continuum to Molecular Regime

High quality factor of dynamic structures at micro and nano scale is exploited in various applications of micro electro-mechanical systems (MEMS) and nano electro-mechanical system. The quality factor of such devices can be very high in vacuum. However, when vacuum is not desirable or not possible, the tiny structures must vibrate in air or some other gas at pressure levels that may vary from atmospheric to low vacuum. The interaction of the surrounding fluid with the vibrating structure leads to dissipation, thus bringing down the quality factor. Depending on the ambient fluid pressure or the gap between the vibrating and the fixed structure, the fluid motion can range from continuum flow to molecular flow giving a wide range of dissipation. The relevant fluid flow characteristics are determined by the Knudsen number which is the ratio of the mean free path of the gas molecule to the characteristic flow length of the device. This number is very small for continuum flow and reasonably big for molecular flow. In this paper, we study the effect of fluid pressure on the quality factor by carrying out experiments on a MEMS device that consists of a double gimbaled torsional resonator. Such devices are commonly used in optical cross-connects and switches. We only vary fluid pressure to make the Knudsen number go through the entire range of continuum flow, slip flow, transition flow, and molecular flow. We experimentally determine the quality factor of the torsional resonator at different air pressures ranging from 760 Torr to 0.001 Torr. The variation of this pressure over six orders of magnitude ensures required rarefaction to range over all flow conditions. Finally, we get the variation of quality factor with pressure. The result indicates that the quality factor, Q, follows a power law, Q ∝P ^–r , with different values of the exponent r in different flow regimes. In the second part of the paper, we propose the use of effective viscosity for considering velocity slip conditions in solving Navier–Stokes equation numerically. This concept is validated with analytical results for a simple case and then compared with the experimental results presented in this paper. The study shows that the effective viscosity concept can be used effectively even for the molecular regime if the air-gap to length ratio is sufficiently small (h ₀/L<0.01). As this ratio increases, the range of validity decreases.     

Extension of multigrid methodology to supersonic/hypersonic 3-D viscous flows

A multigrid acceleration technique developed for solving the three-dimensional Navier–Stokes equations for subsonic/transonic flows has been extended to supersonic/hypersonic flows. An explicit multistage Runge–Kutta type of time-stepping scheme is used as the basic algorithm in conjunction with the multigrid scheme. Solutions have been obtained for a blunt conical frustum at Mach 6 to demonstrate the applicability of the multigrid scheme to high-speed flows. Computations have also been performed for a generic High-Speed Civil Transport configuration designed to cruise at Mach 3. These solutions demonstrate both the efficiency and accuracy of the present scheme for computing high-speed viscous flows over configurations of practical interest.