Experimental evidence of energy pumping in acousticsMise en évidence expérimentale de pompage énergétique en acoustique

This Note presents an experimental vibro-acoustic set-up that aims to reproduce the energy pumping phenomenon between an acoustic medium and an essentially nonlinear oscillator. It shows a one-way irreversible transfer of energy between the first acoustic mode in a tube and a thin visco-elastic membrane. To cite this article: B. Cochelin et al., C. R. Mecanique 334 (2006).     

Incorporation of pyrimidine fluorophores into poly(methylmethacrylate) polymer structures

Three polymethyl methacrylate based copolymers bearing arylvinylpyrimidine chromophores have been synthesized in four steps. Spectral properties of the copolymers have been studied in solution, powder and thin films and compared with the corresponding free chromophores. The copolymers exhibit strong emission solvatochromism and act as polarity sensors. They also exhibit halochromism: when adding acid, a bathochromic shift is observed in absorption whereas a red-shifted fluorescence is observed with increased intensity for the methoxy-substituted macromolecule.     

Monte Carlo method of radiative transfer applied to a turbulent flame modeling with LES

Radiative transfer plays an important role in the numerical simulation of turbulent combustion. However, for the reason that combustion and radiation are characterized by different time scales and different spatial and chemical treatments, the radiation effect is often neglected or roughly modelled. The coupling of a large eddy simulation combustion solver and a radiation solver through a dedicated language, CORBA, is investigated. Two formulations of Monte Carlo method (Forward Method and Emission Reciprocity Method) employed to resolve RTE have been compared in a one-dimensional flame test case using three-dimensional calculation grids with absorbing and emitting media in order to validate the Monte Carlo radiative solver and to choose the most efficient model for coupling. Then the results obtained using two different RTE solvers (Reciprocity Monte Carlo method and Discrete Ordinate Method) applied on a three-dimensional flame holder set-up with a correlated-k distribution model describing the real gas medium spectral radiative properties are compared not only in terms of the physical behavior of the flame, but also in computational performance (storage requirement, CPU time and parallelization efficiency). To cite this article: J. Zhang et al., C. R. Mecanique 337 (2009).     

Influence of another, ruthenium containing, electroactive component on the apparent heterogeneous electron transfer rate constant of a ferrocene containing molecular wire in a Self-Assembled Monolayer of 11-hydroxyundecanethiol on gold

The co-adsorption of three thiol compounds on gold, two of them being electroactive, yields a Self-Assembled Monolayer (SAM) the behaviour of which was studied by impedance spectroscopy. The two redox active thiols have been chosen to have a good miscibility in a supporting inert component, non-degenerate first-oxidation redox couples, and distinct heterogeneous electron transfer rate constant. However, in the ternary monolayer, the slowest process was found to be concentration dependent on the other redox site. This unexpected behaviour should thus be taken into account when using multi-component SAM as a support for integrated devices.     

Reversible photomagnetic properties of the molecular compound [{Cu(bipy)2}2{Mo(CN)8}]·9H2O·CH3OH

The optical and photomagnetic properties of [{Cu^II(bipy)₂}₂{Mo^IV(CN)₈}]·9H₂O·CH₃OH (1) have been reinvestigated. A comparison between spectra in solution and in the solid state revealed the presence of an intervalence band (or Metal–Metal Charge Transfer, hereafter noted MMCT) at 570 nm. The photomagnetic properties have been performed in a Superconducting QUantum Interference Device at 10 K with irradiation in the range of the MMCT: 488 nm, 520 nm and 647 nm at 10 K. An important increase of the magnetic signal has been measured after 1 h of irradiation at 488 nm, whereas a weaker increase has been obtained for the irradiation at 520 nm in the same conditions. Moreover, after an excitation at 488 nm, an irradiation at 647 nm has induced a decrease of the magnetic moment, which corresponds to a partial deexcitation. The complete characterization of the photoproduct has been realised after an irradiation of 4 h at 488 nm. The photomagnetic properties have shown an increase of the paramagnetism of 1 at low temperature. After a thermal heating at 300 K, the material goes back to its initial state before irradiation. It is the first time that a fully reversible photomagnetic behaviour for the compound [{Cu^II(bipy)₂}₂{Mo^IV(CN)₈}]·9H₂O·CH₃OH has been described. The observed properties have been discussed in terms of an electron transfer mechanism Mo → Cu.     

The ACES/PHARAO space mission

Proposed in 1997, the ACES/PHARAO experiment is a space mission in fundamental physics with two atomic clocks on the International Space Station, a network of ultra-stable clocks on the ground, and space-to-ground time transfer systems. The ACES flight instruments are near completion and launch in space is planned for the first half of 2017 for a mission duration of three years. A key element of the satellite payload is a cold-atom clock designed for microgravity environment, PHARAO, operating with laser-cooled cesium atoms. Here we first report on the design and tests of the PHARAO flight model, which is now completed and ready for launch. We then briefly present the status of development of the other instruments of the ACES payload, the Space Hydrogen Maser, the microwave time-transfer system (MWL), and the laser time transfer ELT.     

Screening of a library of hemisalen ligands in asymmetric H-transfer: Reduction of aromatic ketones in water

A library of chiral hemisalen ligands (30) was realized. The ligands were synthesized by the condensation of salicylaldehyde derivatives with amino-alcohols (amino-indanol or substituted amino-ethanol) and characterized. These ligands associated with ruthenium (II) precursors were tested on the asymmetric transfer hydrogenation (ATH) of aromatic ketones by sodium formate in water. The different substituent pattern on the ligand (electronic and hindrance effects on different positions) as well as the ruthenium precursor were investigated. The best compromise in terms of conversion and chiral induction led to the complex [RuCl₂(mesitylene)]₂ coordinated to (1S,2R)-1-((E)-(3-(dimethyl(phenyl)silyl)-2-hydroxy-5-methoxy benzylidene) amino)-2,3-dihydro-1H-inden-2-ol (L25). It reduces acetophenone in 95% yield and 91% ee in 18 h at 30 °C.     

Solution analytique pour le transfert de masse entre puits en milieu poreux hétérogèneAnalytical solution for mass transfer between wells in heterogeneous porous media

The analytical solution developed by Dagan and Indelman (Water Resources Res. 35 (12) (1999) 3639–3647) for modelling the transport of a tracer in an infinite heterogeneous porous media in a dipole flow is extended by accounting for the presence of no flow finite boundaries. The results obtained are compared to those corresponding to the infinite domain, emphasizing the important influence of the boundaries on the elution at the pumping well and the effect of the medium's heterogeneity. The analytical results are then compared to experimental data and provide good matching. To cite this article: J.-P. Carlier, P. Ackerer, C. R. Mecanique 331 (2003).