Comparison of growth stress measurements with modelling in thin iron oxide films

High temperature oxidation of metals leads to residual stresses both in the metal and in the growing oxide. In this work, the evolution of this residual stresses is theoretically predicted in the growing oxide layers. The origin of these stresses is based on a microstructural model. Using experimental results providing from the oxidation kinetics, and an analysis proposed to describe the growth strain occurring in the thin layers, a set of equations is established allowing determining the stresses evolution with oxidation time. Then, the model is compared with experimental results obtained on both α-Fe and phosphated α-Fe, oxidised at different temperatures. Numerical data are extracted from experiments either with an asymptotic formulation or with an inverse method. These two methods give good agreement with experiments and allow extracting the model parameters.     

Design of an experimental procedure for energy evaluation from biomass

The rational and sustainable exploitation of nature resources is one of the priority objectives of our society. In this article a method is proposed to evaluate and exploit the energetic resources contained in different forest formations. This method is based on the use of a combustion bomb calorimeter to determine the calorific values of the different samples studied. These results were complemented with chemical analysis of the samples and with environmental and geomorphological studies of the zones were samples were taken. The results obtained during the last 3 years for the residual biomass originated from the forest formations existing in Galicia ensure the reliability and usefulness of the method that can be extended to any forest formation all over the world.     

Phase modulation in dipolar-coupled A2 spin systems: effect of maximum state mixing in H NMR in vivo

Coupling constants of nuclear spin systems can be determined from phase modulation of multiplet resonances. Strongly coupled systems such as citrate in prostatic tissue exhibit a more complex modulation than AX connectivities, because of substantial mixing of quantum states. An extreme limit is the coupling of n isochronous spins (A_n system). It is observable only for directly connected spins like the methylene protons of creatine and phosphocreatine which experience residual dipolar coupling in intact muscle tissue in vivo. We will demonstrate that phase modulation of this “pseudo-strong” system is quite simple compared to those of AB systems. Theory predicts that the spin-echo experiment yields conditions as in the case of weak interactions, in particular, the phase modulation depends linearly on the line splitting and the echo time.     

Sensitivity-enhanced IPAP experiments for measuring one-bond C–C and C–H residual dipolar couplings in proteins

Sensitivity-enhanced 2D IPAP experiments using the accordion principle for measuring one-bond 13C'-13Calpha and 1Halpha-13Calpha dipolar couplings in proteins are presented. The resolution of the resulting spectra is identical to that of the decoupled HSQC spectra and the sensitivity of the corresponding 1D acquisitions are only slightly lower than those obtained with 3D HNCO and 3D HN(COCA)HA pulse sequences due to an additional delay 2Delta. For cases of limited resolution in the 2D 15N-1HN HSQC spectrum the current pulse sequences can easily be modified into 3D versions by introducing a poorly digitized third dimension, if so desired. The experiments described here are a valuable addition to the suites available for determination of residual dipolar couplings in biological systems.     

30J能量驱动类镍银X光激光的理论研究

 在1.2×10¹³W·cm^－2低功率密度下，对基频激光预主短脉冲驱动类镍银X光激光机理进行了数值模拟和理论分析。证实了在靶长23 mm范围内X光激光都能获得有效放大，取得了和实验相符合的结果。考虑了单柱面镜线聚焦沿靶长度方向功率密度的非均匀性对X光激光放大的影响，采用弯曲靶能有效克服折射以及单柱面镜线聚焦功率密度非均匀带来的不利影响。理论模拟给出的类镍银X光激光的出光下限泵浦功率密度也与实验符合得很好。理论模拟还表明，采用1%左右的预脉冲强度并对预主脉冲时间间隔进行优化，X光激光的输出能量和能量转换效率将获得大幅度提高。     

光参量啁啾脉冲饱和放大的增益稳定性

 光参量啁啾脉冲放大（OPCPA）在饱和放大区存在一个增益稳定点，据此设计了一个输出稳定的三级OPCPA系统；第一、二、三级分别选用准相位匹配的周期极化钛氧磷酸钾（PPKTP）晶体、LBO晶体和KDP晶体作为增益介质。饱和放大时，增益随泵浦光强度变化时的增益输出稳定性明显改善，在泵浦光强度抖动低于6%的情况下，各级光参量放大器OPA输出的增益抖动小于1%。前级采用准相位匹配的PPKTP晶体作为增益介质，在远低于破坏阈值的30MW/cm²的泵浦功率密度下，可得到2×10⁵的饱和放大增益和20%的能量转换效率。     

Orders of Indescribable Sets

We extract some properties of Mahlo’s operation and show that some other very natural operations share these properties. The weakly compact sets form a similar hierarchy as the stationary sets. The height of this hierarchy is a large cardinal property connected to saturation properties of the weakly compact ideal.     

Residual currents and corridor of flow in the Rio de la Plata

The Rio de la Plata is a large and shallow water body that discharges onto the Atlantic Ocean. The main driving forces for the river flow are the bathymetry, tides, the outflow from the Paraná and Uruguay rivers and the winds. A numerical model covering the entire river was set up with the objective of increasing our understanding of the hydrographical features and morphological dynamics in the Estuary. The simulations revealed a counter-clockwise residual circulation in the Samborombón Bay and an eastward net flow near the Uruguayan coast. The residual flow is forced by both the tides and the bathymetry. The residence time for the entire river ranges from 40 to 80 days. However, residence times above 120 days was found in the Samborombón Bay. Three corridors of flow have been identified.     

傅里叶变换近红外光谱仪在酒醅分析中的应用

傅里叶变换近红外光谱分析技术用于酒醅中水分、酸度、淀粉和残糖的分析，方法分析速度快、操作简单，其分析的准确度满足酿酒工业的要求，是值得推广的一种实用技术。     

Optical characteristics of semiconductor saturable absorber mirrors investigated by the reflection Z-scan technique

Recently, the semiconductor saturable absorber mirror (SESAM) has become a key component of passive mode-locked solid-state lasers. Here we present a simple method based on the reflection Z-scan technique to measure the key optical parameters of SESAM such as saturation fluence and modulation depth. The experimental results demonstrate that our method is able to perform with a high accuracy of 10⁻⁴ and a dynamic range of over four orders of magnitude.