玻色—爱因斯坦凝聚和兰姆位移

扼要地介绍了ＢＥＣ研究的近况和研究方向，同时报道了我们在ＢＥＣ的光散射和兰姆位移方面的研究工作     

Purification and characterization of lamb pregastric lipase

Lamb pregastric lipase was purified from a commercial source using delipidation, solubilization with KSCN, acid-precipitation, pepsin-digestion, affinity chromatography with agarose-Cibacron Blue F3GA, gel filtration, and elution from a native 10% (w/v) polyacrylamide gel. The enzyme had a single subunit of 68,000 Da with maximum esterase activity when measured at pH 6.0 and 30 degrees C. The enzyme preferentially hydrolyzed short- and medium-chain (C4, C6, and C8) synthetic esters and short-chain (C4 and C6) monoacid triglycerides. The NH2-terminal sequence demonstrated high homology with gastric and lingual lipases.     

Optoacoustic Laser Stark spectroscopy and FIR laser action on CH3Br using a waveguide CO2 laser

The optoacoustic spectrum of CH₃Br around 10 m band lines of a tunable cw waveguide CO₂ laser is investigated. Several new infrared absorptions are observed and most of the correspond ing molecular transitions are assigned. Far infra red laser action is reported by pumping with the same CO₂ laser: pump offsets are given using the Transferred Lambs dip (TLD) technique. A new FIR laser emission is obtained and assigned. An optoacoustic Laser Stark spectroscopy technique is used to investigate off resonance infrared tran sitions.     

Lamb波频域逆散射全聚焦成像方法研究

Lamb波因其传播距离远、衰减小常被用于板状结构的无损检测中,在基于Lamb波损伤检测的诸多成像技术中,全聚焦方法(Total Focus Method,TFM)方法因其成像分辨率高、信噪比高而受青睐.然而Lamb波的频散效应导致时域延时量不能被准确计算,进而影响传统TFM方法对损伤定位及成像的精度;此外,既有的TFM...     

非线性兰姆波在厚度缓慢变化和衰减下的特性分析

该文运用解析的方式推导了考虑声波衰减时兰姆波二次谐波的累积和传播规律,并用半解析方式将该理论推广到缓慢变厚度板的情况。由于色散特性,兰姆波二次谐波和基频波相速度不匹配,传播通常会产生拍频效应,使得二次谐波的振幅沿着传播距离周期性的归零。当考虑声波衰减或板的厚度缓慢变化的情况时,拍频效应将不再严格地被满足。二次谐波的振幅依然会沿着传播距离而振荡,但不会归零。该研究可以用于分析如何高效地激发和接收兰姆波的二次谐波,表征和评估不同厚度变化的结构中的微观结构损伤。     

Time-domain analysis of second-harmonic generation of primary Lamb wave propagation in an elastic plate

Within the second-order perturbation approximation,this paper investigates the physical process of generation of the time-domain second harmonic by a primary Lamb wave waveform in an elastic plate.The present work is performed based on the preconditions that the phase velocity matching is satisfied and that the transfer of energy from the primary Lamb wave to the double frequency Lamb wave is not zero.It investigates the influences of the difference between the group velocities of the primary Lamb wave and the double frequency Lamb wave,the propagation distance and the duration of the primary Lamb wave waveform on the envelope shape of the time-domain second harmonic.It finds that the maximum magnitude of the envelope of the second-harmonic waveform can grow within some propagation distance even if the condition of group velocity matching is not satisfied.Our analyses also indicate that the maximum magnitude of the envelope of the second-harmonic waveform is kept constant beyond a specific propagation distance.Furthermore,it concludes that the integration amplitude of the time-domain second-harmonic waveform always grows with propagation distance within the second-order perturbation.The present research yields new physical insight not previously available into the effect of generation of the time-domain second harmonic by propagation of a primary Lamb wave waveform.     

Design of interdigital transducers for crack detection in plates

Interdigital transducers (IDT) for non-destructive evaluation (NDE) of cracks in plates are designed based on an analytical model established previously. Key considerations include mode selectivity, excitation strength, collimation of wave and cost. The advantage of mode selectivity of IDT over PZT patch is presented both analytically and experimentally. Effects of parameters, namely finger spacing, width, length, number of fingers, and the size of IDT, on the excitation strength and mode selectivity are considered. This led to the design of a mobile double-sided IDT as an efficient device where excitation strength is strong and focused. The device was fabricated in-house using commercially available piezoelectric ceramics and used to develop a procedure for accurate identification of the direction and extent of cracks in plates. Three aluminum plates, one with a linear deep crack, another with a piecewise linear shallower crack and the third with a curved crack, were used to illustrate the accuracy and efficiency of both the proposed device and procedure for effective NDE.     

Imaging anisotropic elastic properties of an orthotropic paper sheet using photorefractive dynamic holography

An important material property in the paper industry is the anisotropic stiffness distribution due to the fibrous microstructure of paper and to processing procedures. Ultrasonic methods offer a means of determining the stiffness of sheets of paper from the anisotropic propagation characteristics of elastic Lamb waves along the machine direction and the cross direction. That is, along and perpendicular to the direction of paper production. Currently, piezoelectric ultrasonic methods are employed in the industry to measure the elastic polar diagram of paper through multiple contacting measurements made in all directions. This paper describes a new approach utilizing the INEEL Laser Ultrasonic Camera to provide a complete image of the elastic waves traveling in all directions in the plane of the paper sheet. This approach is based on optical dynamic holographic methods that record the out of plane ultrasonic motion over the entire paper surface simultaneously without scanning. The full-field imaging technique offers great potential for increasing the speed of the measurement and it ultimately provides a substantial amount of information concerning local property variations and flaws in the paper. This report shows the success of the method and the manner in which it yields the elastic polar diagram for the paper from the dispersive flexural or antisymmetric Lamb wave.     

Lamb wave sensors array for nonviscous liquid sensing

The interdigital transducer (IDT) can excite Lamb wave in a piezoelectric plate loading with a liquid layer, and the phase velocity of Lamb wave is associated with the properties of the liquid layer. In this paper, the concept of effective permittivity is introduced to study the Lamb wave’s potential application in liquid sensing. Considering the measuring of ideal nonviscous liquid, the sensors array is designed to sense the density and the dielectric constant of the liquid layer simultaneously. Using LiNbO₃ as piezoelectric material, in order to improve the sensors array sensitivity and the electro-mechanical coupling coefficient, the optimized results including plate thicknesses and cut orientations are presented by numerical simulation. These studies show that the Lamb wave sensors array can be potential in liquid sensing.     

有限元仿真兰姆波评价胶接接头界面弹性模量的研究

金属薄板检测中,声-超声检测方法可激发多模式的兰姆波,兰姆波能够评价金属胶接后结构质量,正确认识兰姆波传播特性与胶接接头弹性模量的关系是有效应用该技术的基础。本文采用有限元仿真法分析这种关系,得出随着胶层弹性模量的降低,各模式兰姆波通过胶接接头后能量有不同程度的衰减,频率为0.5 MHz和1 MHz时,兰姆波主要模式A₀、S₀能量值与接头弹性模量具有一定的线性关系。实验结果表明,低频时随着胶接接头的人工老化,接头中主要模式兰姆波能量均发生一定程度的衰减,其能量变化曲线与有限元仿真结果趋势一致。本方法能为实验研究、实际检测提供有效参考依据。