Strain effects on multiferroic BiFeO3 films

The field of multiferroics has experienced a rapid progress resulting in the discovery of many new physical phenomena. BiFeO₃ (BFO) compound, which is one of the few room-temperature single-phase multiferroics, has contributed subsequently to this progress. As a result, significant review articles have been devoted specifically to this famous system. This chapter is dedicated to the strain effects on the structure stability and property changes of BFO thin films. It is a short and non-exhaustive topical overview that may be seen as an invitation for interested readers to go beyond. There is a very active and prolific research in this field and we apologize to the authors whose relevant work is not cited here. After a short introduction, we will thus review the effect of strain on BFO films by describing the consequences on the structure and the phase transitions as well as on polar, magnetic and magnetoelectric properties.     

A study of structural, compositional and optical properties of spray-deposited non-stoichiometric (Zn,Fe)S thin films

Non-stoichiometric ternary chalcogenides (Zn,Fe)S were prepared in the film form by pyrolytic spray deposition technique, using air/nitrogen as the carrier gas. The precursor solution comprised of ZnCl₂, FeCl₂ and thiourea. The depositions were carried out under optimum conditions of experimental parameters viz. carrier gas (air/nitrogen) flow rate, concentration of precursor constituents, nozzle substrate distance and temperature of quartz substrate. The deposited thin films were later sintered in argon at 1073 K for 120 min.The structural, compositional and optical properties of the sintered thin films were studied. X-ray diffraction studies of the thin films indicated the presence of (Zn,Fe)S solid solution with prominent cubic sphalerite phase while surface morphology as determined by scanning electron microscopy (SEM) revealed a granular structure.The chemical composition of the resulting thin films as analyzed by energy dispersive X-ray analysis (EDAX) reflected the composition of the precursor solutions from which the depositions were carried out with Fe at% values ranging from 0.4 up to 33.SEM micrographs of thin films reveal that the grain sizes of the thin films prepared using air as carrier gas and N₂ as carrier gas are in the vicinity of 300 and 150 nm, respectively.The diffuse transmittance measurements for thin films, as a function of wavelength reveal the dependence of direct optical band gap on Fe content and type of phase.     

Condensation film on an inclined rotating disk

The three dimensional problem of steady fluid deposition on an inclined rotating disk is solved by similarity transform. For a given spraying rate there may be one, two or no steady state solution. The inclination causes a downward draining flow and a lateral flow. Perturbation solutions compare well with exact similarity solutions when the fluid film is thin.     

ICP-AES测定彩涂前处理表面调整转化层中Ti、Ni含量及钝化膜中Cr含量

采用电感耦合等离子体-原子发射光谱法同时测定彩涂前处理表面调整转化层中Ti、Ni含量及钝化膜中Cr含量.以表征表面调整转化层厚度及钝化膜厚度,采用本方法准确度高、快速简便,经试验结果令人满意.     

The epitaxial sexiphenyl (0 0 1) monolayer on TiO2(1 1 0): A grazing incidence X-ray diffraction study

A para-sexiphenyl monolayer of near up-right standing molecules (nominal thickness of 30 Å) is investigated in-situ by X-ray diffraction using synchrotron radiation and ex-situ by atomic force microscopy. A terrace like morphology is observed, the step height between the terraces is approximately one molecular length. The monolayer terraces, larger than 20 μm in size, are extended along the [0 0 1] direction of the TiO₂(1 1 0) substrate i.e. along the Ti-O rows of the reconstructed substrate surface. The structure of the monolayer and its epitaxial relationship to the substrate is determined by grazing incidence X-ray diffraction. Extremely sharp diffraction peaks reveal high crystalline order within the monolayer, which was found to have the bulk structure of sexiphenyl. The monolayer terraces are epitaxially oriented with the (0 0 1) plane parallel to the substrate surface (out-of-plane order). Four epitaxial relationships are observed. This in-plane alignment is determined by the arrangement of the terminal phenyl rings of the sexiphenyl molecules parallel to the oxygen rows of the substrate.     

The effect of microscopic features upon the transmissivity of enclosed laser ablated laminated metallised polymer films

A vacuum-deposited aluminium layer (20 nm) is sandwiched between two layers of laminated oriented polypropylene (OPP) film whose thickness varies from 20 to 40 μm. Selected areas of this sealed system were transparentised by the redistribution of the aluminium layer without breaking the seal or causing damage to the OPP film using a 75 W Q-switched Nd:YAG laser. The resultant transparentised films contain aluminium particles, distorted polymer areas and intact areas of the vacuum-coated aluminium layer. This paper investigates the effect of microscopic features upon the overall transmissivity of the laser-treated films and hence the quality of the transparentisation process.     

Photo-Absorption and photochemical decomposition of copper and alkaline-earth ß-diketonates as source gases of high-Tc superconducting films

For low-temperature deposition of oxide films relating to Bi-Sr-Ca-Cu-O superconductors, photo-absorption and -decomposition properties were examined with respect to copper and alkaline-earth ß-diketonates. It was confirmed that all ß-diketonates examined were promising as source materials for photochemical vapour deposition (photo-CVD) using a low-pressure mercury lamp, in view of their large light absorption coefficients at wavelength 254 nm. The light irradiation was effective for the formation of highly crystalline oxide films at temperatures below 600 °C. By combining two sources, Ca₂CuO₃ and SrCuO₂ films were prepared. Photo-CVD of c-axis oriented Bi₂Sr₂CuO_x film was achieved by the irradiation of ternary sources of Bi(C₆H₅)₃ and strontium and copper ß-diketonates at 500 °C.     

不锈钢丝网上薄膜TiO2光催化剂的Raman光谱研究

用Raman光谱方法来研究用Sol Gel法负载于金属丝网的薄膜TiO2 光催化剂的物相结构、厚度以及粒径大小。研究结果显示 ,薄膜达到一定厚度能够阻止基底Fe元素向薄膜表层的扩散 ;在 4 0 0℃下灼烧制得的薄膜TiO2 光催化剂具有锐钛矿晶型 ,而高于 4 0 0℃时 ,将出现金红石相TiO2 ;锐钛矿晶型TiO2 的Raman特征峰产生偏移 ,表明薄膜粒径的变化 ,通过计算表明 ,薄膜TiO2 的粒径为 10nm左右 ,TEM的分析结果也与之一致。