Numerical solutions of the shallow water equations with discontinuous bed topography

A simple scheme is developed for treatment of vertical bed topography in shallow water flows. The effect of the vertical step on flows is modelled with the shallow water equations including local energy loss terms. The bed elevation is denoted with z_b^‐ for the left and z_b⁺ for the right values at each grid point, hence exactly representing a discontinuity in the bed topography. The surface gradient method (SGM) is generalized to reconstruct water depths at cell interfaces involving a vertical step so that the fluxes at the cell interfaces can accurately be calculated with a Riemann solver. The scheme is verified by predicting a surge crossing a step, a tidal flow over a step and dam‐break flows on wet/dry beds. The results have shown good agreements compared with analytical solutions and available experimental data. The scheme is efficient, robust, and may be used for practical flow calculations. Copyright © 2002 John Wiley & Sons, Ltd.     

High resolution electronic study of ONO, ONO and ONO: A rovibronic survey covering 11 800-14 380 cm

The 11 800-14 380 cm⁻¹ frequency range has been scanned for rotationally resolved rovibronic transitions in the A²B₂-X²A₁ electronic band system of the symmetric (C_2v) ¹⁶O¹⁴N¹⁶O and ¹⁸O¹⁴N¹⁸O isotopologues and in the corresponding electronic band system of the asymmetric (C_s) ¹⁸O¹⁴N¹⁶O isotopologue. The rotational analysis—reflecting minor differences in mass—in combination with symmetry induced spectral differences allows an identification of 68 ¹⁶O¹⁴N¹⁶O vibronic levels, 26 ¹⁸O¹⁴N¹⁸O vibronic levels and 51 ¹⁸O¹⁴N¹⁶O vibronic levels. The bands are recorded using near infrared fluorescence spectroscopy and a piezo valve based pulsed molecular beam expansion of premixed ¹⁸O₂ and ¹⁴N¹⁶O in Ar. The majority of the observed bands is rotationally assigned and can be identified as transitions starting from the vibrational ground state of one of the isotopologues. Numerous hot bands have also been identified. A comparison of the overall spectroscopic features of C_2v vs. C_s symmetric species provides qualitative information on symmetry dependence of vibronic couplings.     

Some hydrodynamic aspects of 3-phase inverse fluidized bed

Hydrodynamics of 3-phase inverse fluidized bed is studied experimentally using low density particles for different liquid and gas velocities. The hydrodynamic characteristics studied include pressure drop, minimum liquid and gas fluidization velocities and phase holdups. The minimum liquid fluidization velocity determined using the bed pressure gradient, decreases with increase in gas velocity. The axial profiles of phase holdups shows that the liquid holdup increases along the bed height, whereas the solid holdup decreases down the bed. However, the gas holdup is almost uniform in the bed.     

Static and dynamic detection of axial surface defects on metallic wires by conical triple laser reflection

The quality of the surface of metallic wires is relevant for different applications. The reflection of a laser beam on the surface of a metallic cylindrical wire provides an efficient way to inspect the quality of its surface. Our interest is focused in the detection of axially oriented defects, which are the most relevant for the wire drawing process. We present a simple interference-geometrical model to describe the light pattern reflected from a wire with defects. This model adequately accounts for the observed results from an industrial prototype developed for the purpose. It incorporates three-laser beams incident on the wire at equidistant locations in its perimeter, which produce three reflection cones with a CCD. This configuration permits to explore the whole perimeter of the wire. Several results are presented, both in static operation and in production line, in agreement with qualitative and quantitative predictions.     

造纸污泥与废水污泥流化床焚烧时NO_x和SO_2的排放特性研究

1前言流化床焚烧污犯是近年来发达国家广泛采用的方法，它能很好地实现污泥的稳定化、无害化、减容化和资源化处理。燃煤流化床锅炉污染物排放方面已做了大量的研究工作，由于污泥与煤在结构和性质方面的差异较大，因此有必要对流化床焚烧污泥时污染物排放特性进行研究。本文详细研究了造纸、废水污泥在流化床中焚烧时污泥水份、运行床温及过量空气对NO。和SO。的排放特性及污泥N－＋NO。、S－SO。的转化率的影响，并对这两种性质差异较大的污泥焚烧时的NO。和502的生成特性进行了对比分析，取得了许多有价值的结果，为污泥流化床焚烧…     

气-固流化床反应器内双流体力学模型及其验证 Ⅱ.单组分两维射流床内流场特性分析

由以质量、动量和能量三大守恒定律为基础的湍流两相流理论出发,建立了描述气固流化床内两相流动的数学模型;在微型计算机上编写了相应的数值计算和图形处理程序;为了验证模型的可靠性,本文着手模拟与分析了单组分颗粒体系两维射流流化床内气、固相速度场、空隙度和压力场随时间、空间变化规律;得到了与前人实验结果相吻合的结论。     

不同常压流化床煤气化方案的模型预测 Ⅰ. 模型建立及验证

为评价不同气化方案对常压流化床气化的影响，从化学动力学角度并结合化学平衡建立了流化床气化模型，该模型考虑了煤热解和气化所经历的各反应过程。模型预测结果与文献报道的试验数据吻合较好，气化组分的平方误差和在10%左右，表明该模型可以用来预测各种气化方案对常压流化床气化的气化过程、生成煤气组分和气化效率等方面的影响。     

Influence of particle diameter distribution on protein recovery in the expanded bed adsorption process

The General Rate model has been developed and solved to describe protein adsorption in an expanded bed. The model takes into account axial and local variation of particle size distribution (PSD), external and intra-particle mass transfer resistances, and dispersion in liquid phase. The influence of PSD on breakthrough profiles has been analysed. The simulation results show that for a significantly high expanded bed the lower part of the breakthrough curve profiles, calculated for local particle size distribution (LPSD) and for axial average particle size distribution (APSD) are very similar. However, the upper part of breakthrough profiles calculated for LPSD approaches inlet concentration much more slowly than those calculated for APSD. The retention times of the lower part of uptake curves calculated with average particle diameter are constantly shorter than those obtained from LPSD. For the calculation of the dynamic capacity (DC), the LPSD can be replaced by APSD for large expanded bed heights. Using breakthrough profiles calculated for average particle size, DC values are constantly underestimated.     

循环流化床生物质气化炉内计算流体动力学模拟——鼓泡流化床内改进的颗粒床模型（英文）

采用改进颗粒床模型的CFD方法模拟了实验室规模冷模装置内鼓泡床的流体流动时空特性。模拟结果表明表观气速是影响气固动态特征和压力波动的主要因素之一：随表观气速的增大，气泡数目增加，气泡体积增大，压力波动增强；气速越高时均压降越大；在内循环鼓泡流化床内固体颗粒呈“单室”流型。上述与实验观察相吻合的模拟结果将有助于放大和设计商业化的内循环流化床生物质气化炉。     

Substituent-controlled photoisomerization in retinal chromophore models: Fluorinated and methoxy-substituted protonated Schiff bases

The effect of substitution on the intrinsic (i.e. in vacuo) photoisomerization ability of retinal chromophore models has been explored using CASPT2//CASSCF minimum energy path computations to map the S₁ photoisomerization paths of two substituted minimal models of the retinal chromophore: the 2-cis-penta-2,4-dieniminium and the all-trans-epta-2,4,6-trieniminium cations, which have been modified using fluorine or methoxyl substituents as representative examples of electron-withdrawing and electron-releasing groups, respectively. A systematic analysis has been performed involving substitutions in all the possible positions along the chain. It is shown that the photochemical reactivity and photoisomerization efficiency of these systems may be tuned or indeed changed, although this effect strongly depends on the position of the substituent. In particular, we have shown that (i) most of the systems preserves qualitatively the reactivity of the parent (i.e. unsubstituted) compound; (ii) substitution at positions C4 or C6 leads to a different relaxed excited state structure of the chromophore and in general to a very flat photoisomerization path (or to a tiny S₁ energy barrier in some cases); (iii) the nature of the TICT state (i.e. the S₁ → S₀ decay funnel) may be turned from a conical intersection into an excited state minimum; (iv) for the C4 methoxy-substituted system the isomerization path as well as the S₁/S₀ decay funnel involve an unusual torsional angle. Thus, substitution turns out to be a good tool not only to tune the optical properties (i.e. the absorption and emission features) of the chromophore (as we have already shown in a previous work: I. Conti, F. Bernardi, G. Orlandi, M. Garavelli, Mol. Phys. 104 (2006) 915–924), but it may also play a crucial role in tuning and controlling photoisomerization selectivity and efficiency, affecting excited state lifetime and reaction rate. A rationale for these effects is presented, which provides a basis for understanding reactivity properties and the intrinsic photochemical behavior of substituted retinal chromophores.