Temperature-Dependent Dynamic Properties of LixMn2O4 in Monte Carlo Simulations

Monte Carlo (MC) simulations are used to simulate the voltage profile and the ionic conductivity s of Li ions in LixMn2O4 and its dependence on the lithium concentration x. The open circuit potential shows clearly the two plateaus in the charge/discharge curve, which agrees well with the experimental results. The two plateaus become more and more steep when the temperature is increased. The simulated ionic conductivity shows an M-shaped curve in the plot of ionic conductivity cr versus x when the simulation temperature is low. Interestingly,the minimum valley, which lies at the middle single-phase area near x=0.5, disappears gradually when the temperature increases to 453K.     

Li(AlxCo1-x)O2晶体中Co3+电子态的变化及对结构演化的影响

研究了应用于锂二次电池正极的新型高能量密度存贮材料Li(AlxCo1-x)O2 (x=01—05)的磁性.发现Al3+的掺杂可导致Co3+中d电子自旋态发生变化，即有部分d电子进入高自旋态.伴随Co3+中电子状态的改变，材料结构演化也发生了相应变化，表现为c/a比增大明显减缓，较好地解释了材料结构对Vegard定律的正偏离.这对材料的微观结构与性能设计具有重要意义. 关键词： 锂电池材料 Li（AlxCo1-x）O2 磁性 自旋态 结构演化     

二次锂电池正极材料LixNi0.3Co0.7O2的XPS与XRD研究

结果表明，ＬｉｘＮｉ０．３Ｃｏ０．７Ｏ２具有六方晶系Ｒ３＾－ｍ空间群结构。当Ｘ－１，０．３１５时，其晶胞参数分别为ａ＝２．８２６ｎｍ，ｃ＝１４．１３０ｎｍ和ａ＝０．２８０８ｎｍ，ｃ＝１．４２５３ｎｍ；ＭＯ６（Ｍ＝Ｎｉ，Ｃｏ）八面体中Ｍ－Ｏ平均距离分别为０。１９４１ｎｍ和０．１９３３ｎｍ。ＸＰＳ分析结果表明ＬＩｘＮｉ０．３ＣＯ０．７Ｏ２表面存在Ｌｉ２Ｏ，同时探讨了其中过渡金属离子的３ｄ电子结构变化。     

锂离子电池负极碳材料的表面改性与修饰：Ⅲ,人工施加的固体电解质膜…

研究了人工施加的无机固体电解质体膜对锂碳负极电池性能的影响作用，结果表明碳电极的容量及首次充放电效率相对于未改性电极都得到了一定程度的提高。显示了以这层外界人工施加的晶体膜替代的电极体系本身所形成的钝化膜之有效性，扫描电子显微镜的研究直观地显示了这层人工施加膜的均匀，致密性质。     

锂电池Li／KIBr2—非水体系的研究

本非水电池体系由Ｌｉ负极、多孔石墨电极和电解质溶液组成；电解质溶液由无机溶剂ＰＯＣｌ＿３（或有机溶剂硝基苯）和溶解在该溶剂中的活性物质（ＫＩＢｒ＿２）及支持电解质构成。该电池体系的开路电压为８．５０伏左右，放电性能良好，可望在实际中得到应用。此外，对电池体系的反应机理也作了初步的探讨。     

锂离子电池杂论

首先论述了锂离子电池的大好形势，难得的机遇和面临的挑战。 欧盟相继出台了两项与化学品相关的法令，加之原材料上涨、我国出口退税政策调整，锂电池市场出现新的机遇。面对能源短缺和环保的严峻形势，对动力电池和储能电池的呼声日益高涨。     

锂离子二次电池碳负极材料的改性

作为锂离子二次电池的碳负极材料，其改性方面的研究内容主要有：引入非金属元素，引入金属元素，处理表面及其它方面。纺入的非金属元素有硼，硅，氮，磷和硫。引入的金属元素有钾，铝，镓和钒，镍，钴，铜，铁等过渡金属元素。表面处理的方法包括氧化，形成表面层等。     

Novel Gel—like Process for Synthesizing Submicron LiaNi0.8Co0.2O2 Powders Used in Lithium Ion Batteries

A novel gel-like process has been developed for synthesizing LiaNi0.8Co0.2O2 powders,using citric acid as a chelating agent. This process improves the homogeneity of constituent cation and enhances their reactivity in the obtained precursor. The results of electrochemical test demonstrated that these materials exhibited excellent electrochemical properties. Its initial capacity reached 181.6 mAh/g and reversible efficiency at the first cycle is about 88.6%.     

LiCl—KCl熔盐中锂在铝电极上的电极过程

采用线性扫描伏安法和电位阶跃法，研究了锂离子在铝电极上的电极过程机理，结果表明锂离子在铝电极上沉积形成α－固熔体时，电极过程受锂原子向铝电极中的扩散速度控制，当形成β－锂铝合地，存在成核极化现象，成核过程为瞬间成核过程，初期电极过程受形成β－锂铝合金的速度控制，一定时间后受锂原子通过β－锂铝合金层的扩散速度控制，β－锂铝合金阳极有限限充电电压和极限电流。     

PVC DISULFIDE AS CATHODE MATERIALS FOR SECONDARY LITHIUM BATTERIES

PVC disulfide (2SPVC) was synthesized by solution crosslink and its molecular structure was confirmed by infrared spectrum. 2SPVC's specific area is 36.1 m2·g-1 tested by stand BET method, and granularity experiment gives out the particle size of d0.5= 11.3μm. With SEM (Scanning Electron Microscope) experiment the surface morphology and particle shape of 2SPVC were observed. Cyclic voltammetry (scan rate: 0.5 mV·s-1) shows that 2SPVC experience an obvious S-S redox reaction in charge-discharge process. When 2SPVC was used as cathode material for secondary lithium battery in a 1 mol·L-1 solution of lithium bis(trifluoromethylsulfonyl) imide (Li(CF3SO2)2N) in a 5:45:50 volume ratio mixture of o-xylene (oxy), diglyme (DG) and dimethoxymethane (DME) at 30℃, the first discharge capacity of 2SPVC is about 400.3 mAh·g-1 which is very close to its theoretical value (410.5 mAh·g-1) at a constant discharge current of 15 mA·g-1. It can retain at about 346.1 mAh·g-1 of discharge capacity after 30 charge-discharge cycles. So 2SPVC is a very promising cathode candidate for rechargeable lithium batteries.