首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   2362篇
  免费   573篇
  国内免费   349篇
化学   1497篇
晶体学   192篇
力学   85篇
综合类   20篇
数学   12篇
物理学   1478篇
  2024年   4篇
  2023年   21篇
  2022年   50篇
  2021年   71篇
  2020年   71篇
  2019年   62篇
  2018年   59篇
  2017年   87篇
  2016年   105篇
  2015年   104篇
  2014年   103篇
  2013年   187篇
  2012年   172篇
  2011年   183篇
  2010年   139篇
  2009年   175篇
  2008年   159篇
  2007年   193篇
  2006年   181篇
  2005年   128篇
  2004年   131篇
  2003年   132篇
  2002年   140篇
  2001年   85篇
  2000年   83篇
  1999年   62篇
  1998年   64篇
  1997年   55篇
  1996年   43篇
  1995年   53篇
  1994年   41篇
  1993年   39篇
  1992年   21篇
  1991年   16篇
  1990年   17篇
  1989年   14篇
  1988年   9篇
  1987年   4篇
  1986年   2篇
  1984年   2篇
  1982年   1篇
  1979年   3篇
  1975年   2篇
  1974年   1篇
  1973年   7篇
  1972年   3篇
排序方式: 共有3284条查询结果,搜索用时 31 毫秒
1.
2.
利用分子筛择形特点,对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物,采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变,分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响,以获得高性能固相吸附剂,并将其应用于180-190℃馏分段混合酚分离。结果表明,当分子筛硅铝比为25、粒径为3-5 μm时,分子筛的孔口结构调节效果最优;当正硅酸乙酯的最小用量为0.2 mL/g时,固相吸附剂的吸附量为0.03 g/g,对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化,导致对甲酚选择性的提高。进一步采用HZSM-5(1)吸附剂对真实煤直接液化油混合酚的分离中发现,苯酚和对甲酚的选择性均达到100%。  相似文献   
3.
Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.  相似文献   
4.
The consequences of Ge deposition on Br-terminated Si(1 0 0) were studied with scanning tunneling microscopy at ambient temperature after annealing at 650 K. One monolayer of Br was sufficient to prevent the formation of Ge huts beyond the critical thickness of 3 ML. This is possible because Br acts as a surfactant whose presence lowered the diffusivity of Ge adatoms. Hindered mobility was manifest at low coverage through the formation of short Ge chains. Further deposition resulted in the extension and connection of the Ge chains and gave rise to the buildup of incomplete layers. The deposition of 7 ML of Ge resulted in a rough surface characterized by irregularly shaped clusters. A short 800 K anneal desorbed the Br and allowed Ge atoms to reorganize into the more energetically favorable “hut” structures produced by conventional Ge overlayer growth on Si(1 0 0).  相似文献   
5.
A simple simulation scheme that simultaneously describes the growth kinetics of SiO2 films at the nanometer scale and the SiOx/Si interface dynamics (its extent, and spatial/temporal evolution) is presented. The simulation successfully applies to experimental data in the region above and below 10 nm, reproduces the Deal and Grove linear-parabolic law and the oxide growth rate enhancement in the very thin film regime (the so-called anomalous region). According to the simulation, the oxidation is governed mainly by two processes: (a) the formation of a transition suboxide layer and (b) its subsequent drift towards the silicon bulk. We found that it is the superposition of these two processes that produces the crossover from the anomalous oxidation region behavior to the linear-parabolic law.  相似文献   
6.
This paper reports that the m-plane GaN layer is grown on (200)-plane LiAlO2 substrate by metal-organic chemical wpour deposition (MOCVD) method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer's thickness. The high transmittance (80%), sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.  相似文献   
7.
The glow curve structures for LiF:Mg,Cu,Na,Si TL detectors with various dopant concentrations and sintering temperatures were investigated for the improvement of the glow curve structure and sensitivity of the TL detector. The dopant concentrations were varied over the following ranges: Mg (0–0.25 mol%), Cu (0–0.07 mol%), Na and Si (0–1.5 mol%). With increasing Cu concentration, the intensity of the main peak was intensified and reached a maximum at a concentration of 0.05 mol%. The high-temperature peak was reduced. The dependency of the main peak intensity on the Mg concentration exhibits a sharp maximum at 0.2 mol%. The intensity of the high-temperature peak tends to rise slightly with increasing Mg concentration. It was found that the optimum concentrations of the dopants in the LiF:Mg,Cu,Na,Si TL material are Mg: 0.2 mol%, Cu: 0.05 mol%, Na and Si: 0.9 mol%. The dependency of the main peak intensity on sintering temperature exhibits a very sharp maximum at 830°C. The high-temperature peak was rapidly reduced after 825°C.  相似文献   
8.
朱建敏  沈文忠 《物理学报》2004,53(11):3716-3723
建立傅里叶变换步进扫描时间分辨光电导光谱,并研究太阳电池中与转换效率密切相关的少数载流子寿命.实验选取三种典型的硅太阳电池(单晶硅样品1、多晶硅样品2和多晶硅样品3 ),发现其瞬态光电导的上升和衰退曲线可以分别用两个简单的指数函数描述.由于有复合中心的参与,复合过程中少数载流子的寿命比产生过程中的寿命短.为验证实验结果的可靠性,采用了提取样品少数载流子的体寿命和计算其有效扩散长度两种方法.通过与太阳电池暗伏安特性和负载特性研究相结合,进一步分析和讨论了少数载流子寿命与短路电流、开路电压和转换效率的关系.同时探讨了步进扫描时间分辨光谱实验的其他用途. 关键词: 步进扫描 时间分辨 硅太阳电池 瞬态光电导  相似文献   
9.
硅光电二极管激光损伤阈值随激光脉宽的变化   总被引:4,自引:0,他引:4       下载免费PDF全文
 对飞秒激光辐照下硅光电二极管损伤阈值进行了实验测量,对从1s到60fs不同脉宽激光辐照下硅光电二极管损伤阈值进行了讨论。实验数据表明,在1s到10ns脉宽范围内损伤所需能量密度近似而非严格地与脉宽的平方根成正比。信号分析表明硅光电二极管的损伤主要由热效应造成,而60fs激光辐照下的损伤阈值为0.1J/cm2,明显偏离普通温度分布预言的趋势。  相似文献   
10.
Results of experimental investigations of the volt-brightness characteristics, frequency dependences of brightness, and the directional radiation pattern of electroluminescent MSDM, MSCM, and MSDCM emitters, where M stands for the first transparent and second nontransparent electrodes, S is a semiconductor, D is a thin-film dielectric, and C is a silicone-based composite liquid dielectric with a powdered segnetoelectric filler, developed on conventional “smooth” and rough glass substrates are presented. It is shown that electroluminescent structures on rough surfaces have a brightness approximately two times higher than that of similar structures developed on a “smooth” substrate. Ul’yanovsk State University, 42, L. Tolstoi St., Ul’yanovsk, 432700, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 4, pp. 507–512, July–August, 1997.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号