Solid-phase epitaxy of CaSi2 on Si(1 1 1) and the Schottky-barrier height of CaSi2/Si(1 1 1)

Thin Ca films were evaporated on Si(1 1 1) under UHV conditions and subsequently annealed in the temperature range 200–650 °C. The interdiffusion of Ca and Si was examined by ex situ Auger depth profiling. In situ monitoring of the Si 2p core-level shift by X-ray photoemission spectroscopy (XPS) was employed to study the silicide formation process. The formation temperature of CaSi₂ films on Si(1 1 1) was found to be about 350 °C. Epitaxial growth takes place at T≥400 °C. The morphology of the films, measured by atomic force microscopy (AFM), was correlated with their crystallinity as analyzed by X-ray diffraction (XRD). According to measurements of temperature-dependent I–V characteristics and internal photoemission the Schottky-barrier height of CaSi₂ on Si(1 1 1) amounts to qΦ_Bn=0.25 eV on n-type and to qΦ_Bp=0.82 eV on p-type silicon.     

On a new calcium vanadate: synthesis, structure and Li insertion behavior

A synthetic form of the mineral hewettite was prepared via a new route in aqueous medium, starting either from the crystalline compound Li_1.1V₃O₈, or from its amorphous precursor. The anhydrous, crystalline derivative Ca_0.5V₃O₈ was obtained by heating the synthetic hewettite at 250°C under dynamic vacuum. The diffraction studies show that the 2D structure of Ca_0.5V₃O₈ involves the same V₃O₈ layers as in the hewettite or in Li_1+αV₃O₈. The stacking of the layers is similar to that in the metahewettite. A structural model is proposed, where the Ca²⁺ ions occupy octahedral sites in the interlayer space. The electrochemical behavior of Ca_0.5V₃O₈ vs. lithium insertion is presented. It is original and reveals particularly good performances in terms of stability during cycling at C/5 rate. The homologues obtained with Mg or Ba, instead of Ca, are briefly presented.     

Synthesis of Dimethyl Carbonate from CO2 , Methanol, and Epoxides Using Re（CO） 5 Cl/K2 CO3 as Catalyst System

IntroductionOver the past few years, dimethyl carbonate(DMC) has been proven to be an efficientmethylating,methoxylating, and methoxycarbonylating agent inorganic syntheses, in which DMC is used to replace thetoxic methyl halides, dimethyl sulfate or carb     

Inhibition of the reduction of Cr(VI) at the magnetite–water interface by calcium carbonate coatings

The effect of calcium carbonate coatings on the reduction of aqueous chromate on the magnetite(1 1 1) surface has been investigated using a combination of synchrotron based X-ray photoemission spectroscopy (PES) and X-ray absorption near edge structure (XANES) spectroscopy, along with laboratory-based powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). CaCO₃ coatings (dominantly calcite with minor quantities of aragonite and vaterite) of thicknesses ranging from 10 Å to 20 m were grown on magnetite(1 1 1) surfaces by exposure to supersaturated aqueous solutions followed by evaporation of the solution—a process that mimics pore-water evaporation in vadose zones leading to the formation of caliche and calcium carbonate coatings on mineral grains. Coating thicknesses were determined from attenuation of the Fe 2p photoemission signal by the carbonate coating. For coatings less than 15 Å thick, Cr 2p photoemission and Cr L_II, L_III-edge XANES spectra show that chromate is reduced by the underlying magnetite surface; however, as the minimum coating thickness increases beyond 15 Å, the magnetite surface becomes passivated and further chromate reduction ceases. Our findings suggest that carbonate coatings on natural magnetite grains can significantly reduce or eliminate their ability to reduce Cr(VI), which is a toxic and highly mobile environmental contaminant.     

VUV-UV excited luminescent properties of LnCa4O(BO3)3:RE (Ln=Y, La, Gd; Re=Eu, Tb, Dy, Ce)

Calcium lanthanide oxyborate doped with rare-earth ions LnCa₄O(BO₃)₃:RE³⁺ (LnCOB:RE, Ln=Y, La, Gd, RE=Eu, Tb, Dy, Ce) was synthesized by the method of solid-state reaction at high temperature. Their fluorescent spectra were measured from vacuum ultraviolet (VUV) to visible region at room temperature. Their excitation spectra all have a broadband center at about 188 nm, which is ascribed to host absorption. Using Dorenbos’ and Jφrgensen's work [P. Dorenbos, J. Lumin. 91 (2000) 91, R. Resfeld, C.K. Jφrgensen, Lasers and Excite States of Rare Earth [M], Springer, Berlin, 1977, p. 45], the position of the lowest 5d levels E(Ln,A) and charge transfer band E_ct were calculated and compared with their excitation spectra.Eu³⁺ and Tb³⁺ ions doped into LnCOB show efficient luminescence under VUV and UV irradiation. In this system, Ce³⁺ ions do not show efficient luminescence and quench the luminescence of Tb³⁺ ions when Tb³⁺ and Ce³⁺ ions are co-doped into LnCOB. GdCOB doped with Dy³⁺ shows yellowish white light under irradiation of 254 nm light for the reason that Gd³⁺ ions transfer the energy from itself to Dy³⁺. Because of the existence of Gd³⁺, the samples of GdCOB:RE³⁺ show higher excitation efficiency than LaCOB:RE³⁺ and YCOB:RE³⁺, around 188 nm, which indicates that the Gd³⁺ ions have an effect on the host absorption and can transfer the excitation energy to the luminescent center such as Tb³⁺, Dy³⁺ and Eu³⁺.     

光电光谱法分析钢中钙

本文研究了用光电光谱法测定钢中钙的方法 ,确定了最佳分析条件 ,分析了共存元素的干扰情况。用本方法测定钢中钙 ,具有良好的准确度和精密度 ,结果令人满意。     

新的酰胺型开链冠醚的合成与性质

Simon在70年代开发了一类酰胺型开链冠醚,能选择性配位碱土金属离子并可作为中性载体制备离子选择性电极.由于酰胺型开链冠醚易于制备,因此受到人们广泛地重视.Vgtle等提出的“末端基”概念为开链冠醚的合成、设计起了重要的指导作用.前文报道2-甲氧基-1-氨甲基萘与三甘醇二碘化物在无水碳酸钠存在下于乙腈中反应得到双手臂的套索冠醚与碘化钠的配合物.X射线衍射晶体结构分析表明萘环上的甲氧基中的氧原子参加了与钠离子的配位,生成了扭曲的六边形双锥结构配合物.因此2-甲氧基-1-氨基萘可以作为开链冠醚的“末端基”.开链冠醚的合成路线是:     

水溶性高聚物萃取分离光度法测定Ca2+的研究

利用在无机盐存在下,水溶性高聚物可分为两相的特点,研究了在聚乙二醇-邻苯二酚紫-邻二氮菲-硫酸铵体系中,Ca2+、Al3+、Co2+、Cu2+、Fe3+、Ni2+、Pb2+、Zn2+混合溶液中Ca2+的分离及测定条件,实现了Ca2+与Al3+、Co2+、Cu2+、Fe3+、Ni2+、Pb2+、Zn2+的定量分离和测定.Ca2+质量浓度在0.05～1.0 μg/mL范围内具有良好的线性关系,回收率92%～105%.     

Influence of target surface degradation on the properties of r.f. magnetron‐sputtered calcium phosphate coatings

This paper reports a detailed study of how repeated r.f. magnetron sputtering from a hydroxyapatite (HA) powder target affects the nature and reproducibility of a sequential series of thin‐film coatings deposited onto Ti6Al4V substrates. An evaluation of the effective lifespan of the HA sputter targets and the reproducibility of the calcium phosphate (CaP) coatings produced from them has been made from Fourier transform infrared spectroscopy, XPS and, as appropriate, atomic force microscopy and SEM/energy dispersive x‐ray analyses. The annulus region of the target surface, from which sputtering under r.f. magnetron conditions normally occurs, showed severe surface degradation after only one deposition run, as indicated by significant PO₄^3? and OH^? depletion. This deterioration continued after each subsequent deposition cycle but to a much lesser extent than that observed in the initial sputtering period. The layers produced from all of the sputter runs contained the expected Ca²⁺ and PO₄^3? species characteristic of a CaP system but were OH^? deficient in the as‐deposited state. However, the chemical and morphological properties of the coatings did not change significantly until after the third consecutive sputter cycle. Hence, these data indicate that, even though a significant level of degradation of the HA target occurs at the outset of the sputtering procedure, the general plasma conditions employed here have a dominant influence on the coating properties until a critical degradation condition is met. As such, the compacted HA powder targets of interest can have a life‐cycle greater than single usage without detriment to the chemistry and morphology of the coatings produced from them. Copyright © 2003 John Wiley & Sons, Ltd.     

荧光钙探针试剂及其在生物分析中的应用

本文评论了荧光钙探针试剂合成、性质、结构和生物分析应用方面的进展。各种典型的荧光钙探针试剂均已分别加以讨论。