A novel tridentate nitrogen donor as ligand in copper catalyzed ATRP of methyl methacrylate

A tridentate ligand, BPIEP: 2,6‐bis[1‐(2,6‐diisopropyl phenylimino) ethyl] pyridine, having central pyridine unit and two peripheral imine coordination sites was effectively employed in controlled/“living” radical polymerization of MMA at 90°C in toluene as solvent, Cu^IBr as catalyst, and ethyl‐2‐bromoisobutyrate (EBiB) as initiator resulting in well‐defined polymers with polydispersities M_w/M_n ≤ 1.23. The rate of polymerization follows first‐order kinetics, k_app = 3.4 × 10^?5 s^?1, indicating the presence of low radical concentration ([P*] ≤ 10^?8) throughout the reaction. The polymerization rate attains a maximum at a ligand‐to‐metal ratio of 2:1 in toluene at 90°C. The solvent concentration (v/v, with respect to monomer) has a significant effect on the polymerization kinetics. The polymerization is faster in polar solvents like, diphenylether, and anisole, as compared to toluene. Increasing the monomer concentration in toluene resulted in a better control of polymerization. The molecular weights (M_n,SEC) increased linearly with conversion and were found to be higher than predicted molecular (M_n,Cal). However, the polydispersity remained narrow, i.e., ≤1.23. The initiator efficiency at lower monomer concentration approaches a value of 0.7 in 110 min as compared to 0.5 in 330 min at higher monomer concentration. The aging of the copper salt complexed with BPIEP had a beneficial effect and resulted in polymers with narrow polydispersitities and higher conversion. PMMA obtained at room temperature in toluene (33%, v/v) gave PDI of 1.22 (M_n = 8500) in 48 h whereas, at 50°C the PDI is 1.18 (M_n = 10,300), which is achieved in 23 h. The plot of lnk_app versus 1/T gave an apparent activation energy of polymerization as (ΔE^≠_app) 58.29 KJ/mol and enthalpy of equilibrium (ΔH⁰_eq) to 28.8 KJ/mol. Reverse ATRP of MMA was successfully performed using AIBN in bulk as well as solution. The controlled nature of the polymerization reaction was established through kinetic studies and chain extension experiments. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 43: 4996–5008, 2005     

Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

Possible spectroscopic manifestation of the angular group induced bond alteration (AGIBA) effect in toluene

The most obvious consequence of the concept of aromaticity is the common confidence that in aromatic compounds, bond lengths do not alternate and are between typical to the single and double ones. However, in 1994, performing crystal structure investigations of substituted pyridines and their salts, Krygowski and co‐workers have discovered a very surprising angular group induced bond alteration (AGIBA) effect: It appears that some angular substituents, like methoxy or nitrozo groups, can induce bond alternation in aromatic rings. Crystal studies do not allow one to operate with liquids that are more common in organic chemistry. This paper presents the first possible evidence of spectroscopic manifestations of the AGIBA effect. Raman spectra of the liquid toluene are analyzed. It is found that instead of being single, the line corresponding to the ring breathing vibrations is clearly split by 1.0–1.4 cm^?1, thus indicating the presence of two (cis‐ and trans‐) AGIBA isomers. The energy difference between these isomers estimated in temperature dependent Raman studies is found equal to 6.68 kJ mol^?1. The low‐wavenumber line therefore corresponds to the cis‐AGIBA isomer and the high‐wavenumber line to the trans‐AGIBA isomer stabilized by the AGIBA effect. Copyright © 2007 John Wiley & Sons, Ltd.     

Influence of concentration on the activation energy for diffusion in polymer-solvent systems

The self-diffusion of benzene, toluene, and ethylbenzene in polystyrene have been analyzed using the Vrentas/Duda free-volume diffusion model. Diffusion coefficient predictions suggest an exponential concentration dependence of the activation energy required to overcome attractive forces, E. Without the use of any diffusion data approximating E as zero over the entire concentration range yields self-diffusion coefficient predictions which are in good agreement with experimental data. © 1992 John Wiley & Sons, Inc.     

TDI三聚体的合成研究

以一种碱金属羧酸盐K-1000作为甲苯二异氰酸酯(TDI)三聚反应的催化剂合成了以TDI三聚体为主要成分的多异氰酸酯固化剂。对合成工艺条件进行了探讨。结果表明,将反应温度控制在35℃,催化剂K-1000用量为0.06%时,用苯甲酰氯作为阻聚剂可得到性能基本稳定的TDI三聚体产品。     

Importance of the Debye interaction in organic solutions: Henry's law constants for polar liquids in nonpolar solvents and vice versa

Henry's law constants have been determined for -butyrolactone (BL), ethyl acetate (EA), and 2-methyl-3-pentanol (MEP) in mixtures of iso-octane (ISO) and toluene (TOL), for BL, EA, TOL, and ISO in cinnamaldehyde (CIN) and for TOL and ISO in each other and in BL. From these data and published vapor pressures, the activity coefficients at infinite dilution and the standard molar Gibbs free energy of transfer, G ₂ ⁰ of the solutes from dilute solution in ISO to dilute solution in each solvent medium have been calculated. The different behavior patterns of BL and EA are attributed to differences in their abilities to exist in different conformations possessing different dipole moments. For polar solutes, G ₂ ⁰ decreases with increasing polarizability of the solvent and with increasing dipole moment of the solute, suggesting increased contributions from dipole-induced dipole (Debye) interactions. The sigmoidal plot of G ₂ ⁰ against the change in pair potential energy calculated from the classical expressions suggests that G ₂ ⁰ seriously underestimates the strength of the Debye interactions in comparison with the London interactions.     

Pt/HL和Pt/KL沸石在异丙醇分解反应中的不同催化行为

Ｐｔ／ＫＬ沸石在异丙醇分解反应中具有很高的脱氢活性,而Ｐｔ／ＨＬ沸石具有明显的缺电子性,在此反应中难以显示出脱氢活性,通过加氢作用,可使沸石的酸位免受积炭覆盖,从而可增强Ｐｔ／ＨＬ沸石的酸性催化作用。     

Cation radical intermediates in benzene and toluene polycondensation on sulfated zirconia

Benzene dimer cation radicals were detected on sulfated zirconia at low temperature and benzene coverage. Two temperature regions for their transformations were observed. Below 473 K the radical concentration remained stable reflecting the amount of strong surface acceptor sites. Above 623 K it increased drastically.     

Volumetric Properties of Ternary-Pseudobinary Mixtures Containing Benzene and Cyclohexane

Densities have been measured as a function of composition for ternary-pseudobinary mixtures of [(benzene + toluene or methylcyclohexane) + (cyclohexane + toluene or methylcyclohexane)] by means of a vibrating-tube densimeter at atmospheric pressure and the temperature 298.15 K. The excess molar volumes, V_m^E, were calculated from the densities and correlated using the Redlich–Kister equation to estimate the coefficients and standard errors. The experimental and calculated quantities are used to discuss the mixing behavior of the components. The results show the third component, toluene and methylcyclohexane, influences the interaction between benzene and cyclohexane.     

Titanosilicates as Supports for an Enzymatic Alcoholysis Reaction

Novel [Cr^III(amp)(bipy)(Cl)] (1) (H₂amp = N-(hydroxyphenyl)salicyldimine; bipy = 2,2-bipyridyl) and [Cr^III(app)(bipy)(Cl)]⁺ (2) (H₂app = N-(hydroxyphenyl)pyridine-2-carboxaldimine; bipy = 2,2-bipyridyl) complexes have been synthesized and characterized by physico-chemical methods. Complexes 1 and 2 have been employed as catalysts in the oxidation of both saturated and unsaturated hydrocarbons using tert-butylhydroperoxide (t-BuOOH). The significance of the results with respect to oxo-functionalization of C-H bonds both in unsaturated and saturated hydrocarbons is noted.