Wave-based vibration control of large cable net structures

Large cable net structures have been widely applied in aerospace engineering due to the feature of light-weight, high packaging efficiency, and high thermal stability. Structural vibrations induced by a variety of disturbances are inevitable in the space environment, resulting in the requirement of effective vibration control strategies for large cable net structures. Since the large cable net structures have many closely spaced vibrational modes in the range of low frequencies, traditional modal based control may cause modal truncation and spillover problems. In this paper, a wave-based boundary control strategy is adopted and its effectiveness to control the vibration of cable net structures is investigated, by transfer function analysis and numerical methods. It is found that the structural vibration can be absolutely resisted by applying the wave-based boundary controllers onto all the exterior nodes, when disturbances come from the external boundaries of the cable net. Our results in this paper can provide a theoretical basis for the vibration control of large cable net structures.     

介孔网络电路

用二次阳极氧化法制备纳米多孔氧化铝板,然后用磁控溅射方式在纳米多孔氧化铝板表面镀金得到介孔网络电路,对该介孔网络电路进行输运测量,发现其具有非线性电阻.     

Hybrid free radical/cationic frontal photopolymerizations

The irradiation of hybrid photopolymer systems consisting of a free radically polymerizable multifunctional acrylate monomer and a cationically polymerizable epoxide or oxetane monomer was conducted under conditions where only the free radical polymerization takes place. This results in the formation of a free‐standing polyacrylate network film containing quiescent oxonium ions along with the unreacted cyclic ether monomer. The subsequent application of a point source of heat to the film ignites a cationic ring‐opening frontal polymerization that emanates from that site and propagates to all portions of the irradiated sample. This article examines the impact of various molecular structural and experimental parameters on these novel hybrid frontal polymerizations that produce interpenetrating network polymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4331–4340, 2007     

Viscoelastic properties of nanostructured natural rubber/polystyrene interpenetrating polymer networks

The effects of the blend ratio and initiating system on the viscoelastic properties of nanostructured natural rubber/polystyrene‐based interpenetrating polymer networks (IPNs) were investigated in the temperature range of ?80 to 150 °C. The studies were carried out at different frequencies (100, 50, 10, 1, and 0.1 Hz), and their effects on the damping and storage and loss moduli were analyzed. In all cases, tan δ and the storage and loss moduli showed two distinct transitions corresponding to natural rubber and polystyrene phases, which indicated that the system was not miscible on the molecular level. However, a slight inward shift was observed in the IPNs, with respect to the glass‐transition temperatures (T_g's) of the virgin polymers, showing a certain degree of miscibility or intermixing between the two phases. When the frequency increased from 0.1 to 100 Hz, the T_g values showed a positive shift in all cases. In a comparison of the three initiating systems (dicumyl peroxide, benzoyl peroxide, and azobisisobutyronitrile), the dicumyl peroxide system showed the highest modulus. The morphology of the IPNs was analyzed with transmission electron microscopy. The micrographs indicated that the system was nanostructured. An attempt was made to relate the viscoelastic behavior to the morphology of the IPNs. Various models, such as the series, parallel, Halpin–Tsai, Kerner, Coran, Takayanagi, and Davies models, were used to model the viscoelastic data. The area under the linear loss modulus curve was larger than that obtained by group contribution analysis; this showed that the damping was influenced by the phase morphology, dual‐phase continuity, and crosslinking of the phases. Finally, the homogeneity of the system was further evaluated with Cole–Cole analysis. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1680–1696, 2003     

激光二极管端面抽运的棒状Yb：YAG激光器

分析了影响激光二极管抽运Yb：YAG激光器调Q效率的参量，推导了激光二极管端面脉冲抽运Yb：YAG晶体的速率方程，解出了双程抽运情况下的净抽运量子产率。利用数值计算方法，模拟了净抽运量子产率与晶体长度，抽运光脉冲宽度等关系，得出晶体长度的优化可以提高Yb：YAG激光器输出效率。计算了词Q Yb：YAG激光器的最大增益、最大储能，分析了放大自发辐射对于Yb：YAG能量存储的影响。同时给出了激光二极管端面抽运调Q Yb：YAG优化设计方法。这些分析和计算为实际器件的研制提供参考。     

Transversal-Free Translation Nets

Translation planes of order q ² containing non-Desarguesian Baer subplanes are used to construct transversal-free translation nets with very small deficiencies. Also, a generalization of the ideas of Bruen shows that any non-Desarguesian spread in PG(3, q) produces a transversal-free net of small deficiency.     

Hydrogel‐like elastic membrane consisting of semi‐interpenetrating polymer networks based on a phosphorylcholine polymer and a segmented polyurethane

To obtain a hydrogel‐like elastic membrane, we prepared semi‐interpenetrating polymer networks (IPNs) by the radical polymerization of methacrylates such as 2‐methacryloyloxyethyl phosphorylcholine (MPC), 2‐hydroxyethylmethacrylate, and triethyleneglycol dimethacrylate diffused into segmented polyurethane (SPU) membranes swollen with a monomer mixture. The values of Young's modulus for the hydrated semi‐IPN membranes were less than that for an SPU membrane because of higher hydration, but they were much higher than that for a hydrated MPC polymer gel (non‐SPU). According to a thermal analysis, the MPC polymer influenced the segment association of SPU. The diffusion coefficient of 8‐anilino‐1‐naphthalenesulfonic acid sodium salt from the semi‐IPN membrane could be controlled with different MPC unit concentrations in the membrane, and it was about 7 × 10² times higher than that of the SPU membrane. Fibroblast cell adhesion on the semi‐IPN membrane was effectively reduced by the MPC units. We concluded that semi‐IPNs composed of the MPC polymer and SPU may be novel polymer materials possessing attractive mechanical, diffusive‐release, and nonbiofouling properties. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 68–75, 2003     

具有六重穿插非中心对称金刚石网络结构的Cd(Ⅱ)和Zn(Ⅱ)的配位高聚物(英)

利用1，4-二-(4-羧基吡啶基)丁烷(L)合成了两个新的三维配位聚合物{(CdL₂)·4H₂O·2ClO₄}_n 1和{(ZnL₂)·4H₂O·2ClO₄}_n 2。单晶X-射线结构分析表明，1和2具有相同的计量式，但其晶体属于不同的空间群(1属于P4n2，2属于P4₂22)。两种配合物中，每个金属离子分别由配体与四个相邻的金属离子连接，从而形成具有六重穿插的金刚石网络结构，其网络中大的空腔被高氯酸根离子和(H₂O)₄分子簇所占据。     

Interpenetrating polymer networks of poly(dimethyl siloxane–urethane) and poly(methyl methacrylate)

Simultaneous IPNs of poly(dimethyl siloxane-urethane) (PDMSU)/poly(methyl methacrylate) (PMMA) and related isomers have been prepared by using new oligomers of bis(β-hydroxyethoxymethyl)poly(dimethyl siloxane)s (PDMS diols) and new crosslinkers biuret triisocyanate (BTI) and tris(β-hydroxylethoxymethyl dimethylsiloxy) phenylsilane (Si-triol). Their phase morphology have been characterized by DSC and SEM. The SEM phase domain size is decreased by increasing crosslink density of the PDMSU network. A single phase IPN of PDMSU/PMMA can be made at an M_c = 1000 and 80 wt % of PDMSU. All of the pseudo- or semi-IPNs and blends of PDMSU and PMMA were phase separated with phase domain sizes ranging from 0.2 to several micrometers. The full IPNs of PDMSU/PMMA have better thermal resistance compared to the blends of linear PDMSU and linear PMMA. © 1993 John Wiley & Sons, Inc.     

Optically clear simulataneous interpenetrating polymer networks based on poly(ethylene glycol) diacrylate and epoxy. II. Kinetic study

Simultaneous interpenetrating polymer networks (SINs) based on diglycidyl ether of bis-phenol A (DGEBA) and poly(ethylene glycol) diacrylate (PEGDA) in weight ratios of 100/0, 50/50, and 0/100 were blended and cured simultaneously by using benzoyl peroxide (BPO) and m-xylenediamine (MXDA) as curing agents. A kinetic study during SIN formation was carried out at 45, 55, 63, and 70°C. Concentration changes for both the epoxide and C?C bond were monitored with FTIR. A rate expression for DGEBA cure kinetics was established with a model reaction of phenyl glycidyl ether (PGE) and benzylamine. Experimental results revealed that lower rate constants and higher activation energy for the SIN were found, compared with those for the constituent DGEBA and PEGDA network formation. A model of network interlock was proposed to account for this phenomenon. During simultaneous cure of DGEBA and PEGDA, the interlock (mutual entanglement) between DGEBA and PEGDA networks provided a sterically hindered environment, which subsequently increased the activation energy and reduced cure rates for both DGEBA and PEGDA. © 1993 John Wiley & Sons, Inc.