Improved spacer design and cost reduction in an electrodialysis system

In electrodialysis using thin membranes and spacers, the compactness of the membrane cell-pairs leads to a small potential drop, and hence to energy saving. The spacer design itself has a great effect on the cost of the plants, since spacers act as turbulence promoters. A careful design, to increase the mass transfer coefficients, can reduce the membrane surface area required for a given application. Limiting current measurements, cell-pair resistance and pressure losses are presented for several thin spacers, for different flow-velocity values and feed water concentrations. It was possible to find an advantageous geometry of the separating mesh leading to substantial savings on investment and operation costs.     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.     

A study of structural, compositional and optical properties of spray-deposited non-stoichiometric (Zn,Fe)S thin films

Non-stoichiometric ternary chalcogenides (Zn,Fe)S were prepared in the film form by pyrolytic spray deposition technique, using air/nitrogen as the carrier gas. The precursor solution comprised of ZnCl₂, FeCl₂ and thiourea. The depositions were carried out under optimum conditions of experimental parameters viz. carrier gas (air/nitrogen) flow rate, concentration of precursor constituents, nozzle substrate distance and temperature of quartz substrate. The deposited thin films were later sintered in argon at 1073 K for 120 min.The structural, compositional and optical properties of the sintered thin films were studied. X-ray diffraction studies of the thin films indicated the presence of (Zn,Fe)S solid solution with prominent cubic sphalerite phase while surface morphology as determined by scanning electron microscopy (SEM) revealed a granular structure.The chemical composition of the resulting thin films as analyzed by energy dispersive X-ray analysis (EDAX) reflected the composition of the precursor solutions from which the depositions were carried out with Fe at% values ranging from 0.4 up to 33.SEM micrographs of thin films reveal that the grain sizes of the thin films prepared using air as carrier gas and N₂ as carrier gas are in the vicinity of 300 and 150 nm, respectively.The diffuse transmittance measurements for thin films, as a function of wavelength reveal the dependence of direct optical band gap on Fe content and type of phase.     

Large set of P3‐decompositions

Let G=(V(G),E(G)) be a graph. A (n,G, λ)‐GD is a partition of the edges of λK_n into subgraphs (G‐blocks), each of which is isomorphic to G. The (n,G,λ)‐GD is named as graph design for G or G‐decomposition. The large set of (n,G,λ)‐GD is denoted by (n,G,λ)‐LGD. In this work, we obtain the existence spectrum of (n,P₃,λ)‐LGD. © 2002 Wiley Periodicals, Inc. J Combin Designs 10: 151–159, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/jcd.10008     

On c‐Bhaskar Rao designs with block size 4

Several new families of c‐Bhaskar Rao designs with block size 4 are constructed. The necessary conditions for the existence of a c‐BRD (υ,4,λ) are that: (1)λ_min=?λ/3 ≤ c ≤ λ and (2a) c≡λ (mod 2), if υ > 4 or (2b) c≡ λ (mod 4), if υ = 4 or (2c) c≠ λ ? 2, if υ = 5. It is proved that these conditions are necessary, and are sufficient for most pairs of c and λ; in particular, they are sufficient whenever λ?c ≠ 2 for c > 0 and whenever c ? λ_min≠ 2 for c < 0. For c < 0, the necessary conditions are sufficient for υ> 101; for the classic Bhaskar Rao designs, i.e., c = 0, we show the necessary conditions are sufficient with the possible exception of 0‐BRD (υ,4,2)'s for υ≡ 4 (mod 6). © 2002 Wiley Periodicals, Inc. J Combin Designs 10: 361–386, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/jcd.10009     

Constructing Invariant Fairness Measures for Surfaces

The paper proposes a rational method to derive fairness measures for surfaces. It works in cases where isophotes, reflection lines, planar intersection curves, or other curves are used to judge the fairness of the surface. The surface fairness measure is derived by demanding that all the given curves should be fair with respect to an appropriate curve fairness measure. The method is applied to the field of ship hull design where the curves are plane intersections. The method is extended to the case where one considers, not the fairness of one curve, but the fairness of a one parameter family of curves. Six basic third order invariants by which the fairing measures can be expressed are defined. Furthermore, the geometry of a plane intersection curve is studied, and the variation of the total, the normal, and the geodesic curvature and the geodesic torsion is determined.     

Some new results on superimposed codes

A (w,r) cover‐free family is a family of subsets of a finite set such that no intersection of w members of the family is covered by a union of r others. A (w,r) superimposed code is the incidence matrix of such a family. Such a family also arises in cryptography as the concept of key distribution pattern. In the present paper, we give some new results on superimposed codes. First we construct superimposed codes from super‐simple designs which give us results better than superimposed codes constructed by other known methods. Next we prove the uniqueness of the (1,2) superimposed code of size 9 × 12, the (2,2) superimposed code of size 14 × 8, and the (2,3) superimposed code of size 30 × 10. Finally, we improve numerical values of upper bounds for the asymptotic rate of some (w,r) superimposed codes. © 2004 Wiley Periodicals, Inc.     

Fluorous osmium tetraoxide (OsO4): a recoverable and reusable catalyst for dihydroxylation of olefins

A fluorous osmium catalyst was firstly developed. It had been effectively used as recoverable and reusable catalyst in the dihydroxylation of olefins.