A Photoluminescent Ag10Cu6 Cluster Stablized by a PNNP Ligand and Phenylacetylides Selectively and Reversibly Senses Ammonia in Air and Water

A photoluminescent bimetallic cluster [Ag₁₀Cu₆(bdppthi)₂(C≡CPh)₁₂(MeOH)₂(H₂O)](ClO₄)₄ ( 1 , bdppthi=N,N’-bis(diphenylphosphanylmethyl)-tetrahydroimidazole} was synthesized from the PNNP type ligand bdppthi generated in-situ. Upon excitation at 365 nm, 1 exhibited strong phosphorescent emission at 630 nm, which was selectively quenched by NH₃ in air or water. The sensing of NH₃ was rapid and recoverable, with detection limits of 53 ppm (v/v) in N₂ and 21 μmol/L (0.36 ppm, w/w) for NH₃ ⋅ H₂O in water. Cluster 1 could potentially serve as a bifunctional chemical sensor for the efficient detection of ammonia in waste-gas and waste-water.     

Caesium carbonate supported on hydroxyapatite‐encapsulated Ni0.5Zn0.5Fe2O4 nanocrystallites as a novel magnetically basic catalyst for the one‐pot synthesis of pyrazolo[1,2‐b]phthalazine‐5,10‐diones

A novel nanomagnetic basic catalyst of caesium carbonate supported on hydroxyapatite‐coated Ni_0.5Zn_0.5Fe₂O₄ magnetic nanoparticles (Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃) was prepared. This new catalyst was fully characterized using Fourier transform infrared spectroscopy, transmission and scanning electron microscopy, X‐ray diffraction and vibrating sample magnetometry techniques, and then the catalytic activity of this catalyst was investigated in the synthesis of 1H‐pyrazolo[1,2‐b]phthalazine‐5,10‐dione derivatives. Also, Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃ could be reused at least five times without significant loss of activity and could be recovered easily by applying an external magnet. Thus, the developed nanomagnetic catalyst is potentially useful for the green and economic production of organic compounds. Copyright © 2015 John Wiley & Sons, Ltd.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Recent advances on the use of active anodes in environmental electrochemistry

Active anodes, especially those consisting of metal mixed oxides (MMOs) containing Ru and/or Ir oxides, have been applied in the treatment of wastewater, especially when chloride ions are present. Their characteristics continuously drive the study of applications of these materials, be they in the degradation of different organic molecules, the preparation of new electrode materials and in the association of various processes to increase pollutant removal. Thus, this brief review aims to present some of the recent advances in the application of active anode materials in environmental electrochemistry. Focussing on the 2018–2020 period, it is possible to note many applied studies, using commercially available materials, covering a wide range of target pollutants. Still other studies aim to modify the catalyst surfaces to increase the mineralization capacity, and the use of these anodes in the production of free chlorine species to mediate indirect organic reduction is observed.     

A volatolomic approach using cerumen as biofluid to diagnose bovine intoxication by Stryphnodendron rotundifolium

An innovative volatolomic approach employs the detection of biomarkers present in cerumen (earwax) to identify cattle intoxication by Stryphnodendron rotundifolium Mart., Fabaceae (popularly known as barbatimão). S. rotundifolium is a poisonous plant with the toxic compound undefined and widely distributed throughout the Brazilian territory. Cerumen samples from cattle of two local Brazilian breeds (‘Curraleiro Pé-Duro’ and ‘Pantaneiro’) were collected during an experimental intoxication protocol and analyzed using headspace (HS)/GC–MS followed by multivariate analysis (genetic algorithm for a partial least squares, cluster analysis, and classification and regression trees). A total of 106 volatile organic metabolites were identified in the cerumen samples of bovines. The intoxication by S. rotundifolium influenced the cerumen volatolomic profile of the bovines throughout the intoxication protocol. In this way, it was possible to detect biomarkers for cattle intoxication. Among the biomarkers, 2-octyldecanol and 9-tetradecen-1-ol were able to discriminate all samples between intoxicated and nonintoxicated bovines. The cattle intoxication diagnosis by S. rotundifolium was accomplished by applying the cerumen analysis using HS/GC–MS, in an easy, accurate, and noninvasive way. Thus, the proposed bioanalytical chromatography protocol is a useful tool in veterinary applications to determine this kind of intoxication.     

Immobilized Catalysts for Iridium‐Catalyzed Allylic Amination: Rate Enhancement by Immobilization

The first immobilized catalyst for Ir‐catalyzed asymmetric allylic aminations is described. The catalyst is a cationic (π‐allyl)Ir complex bound by cation exchange to an anionic silica gel support. Preparation of the catalyst is facile, and the supported catalyst displayed considerably enhanced activity compared with the parent homogeneous catalyst. Up to 43 consecutive amination runs were possible in recycling experiments.     

Extended Open-Chain Polyenides as Versatile Delocalized Anion Ligands for Metal Chain Clusters

Although small cyclic- and open-chain unsaturated hydrocarbon anions such as cyclopentadienide and open-chain pentadienide are used as the strongly electron-donating auxiliary ligands for metal complexes, more extended π-conjugated unsaturated hydrocarbon anions have rarely been used in coordination chemistry, despite their potential ability to serve as the multiply bridging π-ligands for metal clusters. This work reports isolation of metal chain clusters bearing the multi-dentate, open-chain extended unsaturated hydrocarbon anion ligands. The extended open-chain π-conjugated polyenyl ligands could effectively stabilize oxidized palladium chains, including an unprecedented [Pd₄]⁴⁺ chain.     

Extraction of methyl xanthines and their UHPLC–DAD determination in consumable beverages used in Eastern province of Saudi Arabia

Coffee and tea are the most widely consumed beverages worldwide. However, the consumer may be unaware of the exact amount of methyl xanthine (MX, i.e. caffeine [C], theobromine [TB] and theophylline [TH]) consumed, as most of the products do not list the proper amounts. This may lead to serious risks including cardiovascular, kidney and stimulant effects. The aim of the study was to determine the MX amount in ready-to-use beverages (coffee and tea) collected from various outlets in the city of Al-Khobar, Saudi Arabia. Forty different samples of espresso, black coffee and red tea were collected. A fast, reliable and efficient UHPLC–DAD method was developed and validated for MX determination. Total lipids were extracted and fractionated in order to determine glycolipids, phospholipids and neutral lipids. The r² value for the method was 0.980–0.988 in a linearity range of 0.5–200 ppm. The range for MX (C [0.02–2.39 mg/ml], TB [0.00–0.10 mg/ml] and TH [0.00–0.004 mg/ml]) and total lipids was 1–5 g. The amount of glycolipids (3.1 g) was higher among the lipid fractions followed by phospholipids (1.8 g) and neutral lipids (0.25 g). In general, espresso beverages (20–30 ml) contained high amounts of MX whereas black coffee beverages contained high amount of lipids. Most of the beverages expressed C, TB, TH, lipids or their fractions; however, the product with high amounts of MX and lipids at the same time was espresso (brands Chemistry and Wogard). Although the MX and lipid levels in these beverages well below the allowed limits, care must still be taken, especially when using the beverages with high serving volumes (200–250 ml) or coffee prepared via the filter method i.e. black coffee, using a high temperature for a longer time.     

Organic–Inorganic Hybrid Gold Halide Perovskites: Structural Diversity through Cation Size

Crystal structures of a series of organic–inorganic hybrid gold iodide perovskites, formulated as A₂[Au^II₂][Au^IIII₄] [A=methylammonium (MA) ( 1 ) and formamidinium (FA) ( 2 )], A′₂[I₃]_1−x[Au^II₂]_x[Au^IIII₄] [A′=imidazolium (IMD) ( 3 ), guanidinium (GUA) ( 4 ), dimethylammonium (DMA) ( 5 ), pyridinium (PY) ( 6 ), and piperizinium (PIP) ( 7 )], systematically changed depending on the cation size. In addition, triiodide (I₃⁻) ions were partly incorporated into the AuI₂⁻ sites of 3 – 7 , whereas they were not incorporated into those of 1 and 2 . Such a difference comes from the size of the organic cation. Optical absorption spectra showed characteristic intervalence charge-transfer bands from Au^I to Au^III species, and the optical band gap increased as the size of the cation became larger.