Radioactive Tracer Study of the Displacement of Iodine Adatoms from Platinized Platinum Electrode by Carbon Monoxide

Radioactive tracer studies confirm the earlier electrochemical results that carbon monoxide can virtually completely displace iodine adatoms. For the first time, it is found that iodine adatoms are not displaced by carbon monoxide when iodide anions are adsorbed in the presence of an upd silver monolayer. The possible reasons for the effect observed are discussed.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

Au deposits on graphite: On the nature of high temperature desorption peaks in CO thermal desorption spectra

Due to the discovery of Au as a catalyst for low temperature CO oxidation, the adsorption of CO on Au surfaces has attracted a lot of attention recently. On stepped and rough single crystal surfaces as well as on deposited particles two characteristic desorption states above 100 K have been observed via TPD. We have studied Au deposits on graphite in order to elucidate the nature of these desorption peaks in more detail. For this purpose, Au was deposited at 100 K and 300 K on HOPG as a weakly interacting support. In analogy to other supports, we obtain two desorption states (∼140 K and ∼170 K) whose relative intensities depend strongly on the deposition temperature with the high temperature peak being much more pronounced for the 100 K deposits. After annealing to 600 K, both states drastically lose intensity. XP spectra, on the other hand, show virtually no decrease of the Au 4f intensity as would be expected for desorption or significant changes of the particle morphologies. We conclude that both desorption peaks are defect-related and connected with under-coordinated Au atoms that are lost for the most part upon annealing. These sites could be located at the perimeter of dendritic islands or on small, defect-rich particles in addition to larger particles not adsorbing CO at 100 K. Preliminary STM results are in favour of the second interpretation.     

Polymorphism in alternating polyketones studied by x-ray diffraction and calorimetry

Differential scanning calorimetry and high temperature x-ray diffraction were used to study the perfectly alternating copolymer of ethene and carbon monoxide (polyketone; POKC2). It was found that oriented POK-C2 fibers show a crystalline phase transition at a temperature between 110–125°C with a 10% change in crystalline density. At this temperature, the crystal structure reported recently (POK-α) is transformed to a crystal structure that was reported in the past for room temperature imperfectly alternating polyketone. The latter structure will be designated as POK-β. The influence of chain defects on the crystal structure was studied by synthesizing terpolymers (POK-C2/C3), in which small amounts of propylene-CO units are incorporated into the polymer backbone. The resulting terpolymers differ from the copolymer by the presence of methyl groups randomly distributed along the polyketone backbone chain. Evidence is presented that indicates that the methyl groups are built into the crystal lattice as defects. With more than 5 mole-% propene the terpolymer fibers crystallize exclusively in the β-modification. Below this level the α/β ratio (at room temperature) increases with decreasing amounts of propene. Both as-synthesized and as-spun POK-C2 were found to consist of both POK-α and POK-β; the α/β ratio depends on the method of preparation. Because the drawn POK-C2 fibers studied here consist exclusively of POK-α, the process of spinning and drawing leads to the transformation of unoriented β-rich material into oriented POK-α. © 1995 John Wiley & Sons, Inc.     

Sample preparation procedure for the determination of sulphur and trace metals in oil products by the ICP with a minitorch using emulsions

A quick sample preparation method was used for the determination of sulphur and trace metals in oil and oily products by the ICP with a minitorch. Stable aqueous emulsions of oils and oil products were made by using two kinds of emulsifiers (one with low sulphur content, the other sulfonated). Aqueous standard solutions can be used for the preparation of calibration solutions. The contents of S, Al, Cr, Cu, Fe, Mg, Ni and Pb in aqueous emulsions were determined and the results were in good agreement with the composition of oil standard solutions used for control analysis procedure.     

钯II催化CO/乙烯共聚加压原位红外光谱研究

聚酿以其优良的物理、化学性能及原料（CO乙烯）简单易得的优点，在世界范围内已引起人们的普遍关注．为寻找价廉的催化剂或改良高效或（11）一双磷催化剂以推动聚酮的工业化进程，必须对共聚机理进行深入的研究．S；，n［’，’1、DrentP］等人根据对产品主链和端基的分析首先     

三效催化剂作用下的NO+CO催化反应机理

NO与CO在Pt/Rh/Pd及载体组成的三效催化剂上的氧化还原应用是控制汽车尾气对空气污染的一个关键反应，这一反应随着近年来对环境保护的日益重视而成为国内外研究的热点，本文主要综述了NO及CO在Pt,Rh,Pd上的吸附及反应机理的实验及理论研究现状，总结得出：在三效催化剂对NO CO的催化反应中，Pt,Pd对CO的催化氧化起主要作用，而Rh对NO的解离有很好的活化作用。     

Metal carbonyl catalysis of carbon monoxide and formate reactions

The water gas shift reaction (CO + H₂O = CO₂+ H₂) is catalyzed by aqueous metal carbonyl systems derived from simple mononuclear carbonyls such as Fe(CO)₅ and M(CO)₆ (M = Cr, Mo, and W) and bases in the 140–200 °C temperature range. The water gas shift reaction in a basic methanol-water solution containing Fe(CO)₅ is first order in [Fe(CO)₅], zero order in [CO], and essentially independent of base concentration and appears to involve an associative mechanism with a metallocarboxylate intermediate [(CO)₄Fe-CO₂H]^–. The water gas shift reactions using M(CO)₆ as catalyst precursors are first order in [M(CO)₆], inverse first order in [CO], and first order in [HCO₂ ^–] and appear to involve a dissociative mechanism with formatometallate intermediates [(CO)₅M-OCHO]^–.The Reppe hydroformylation of ethylene to produce propionaldehyde and 1-propanol in basic solutions containing Fe(CO)₅ occurs at 110–140 °C. This reaction is second order in [Fe(CO)₅], first order in [C₂H₄] up to a saturation pressure >1.5 MPa, and inhibited by [CO]. These experimental results suggest a mechanism where the rate-determining step involves a binuclear iron carbonyl intermediate. The substitution of Et₃N for NaOH as the base facilitates the reduction of propionaldehyde to 1-propanol but results in a slower rate for the overall reaction.The homogeneous photocatalytic decomposition of the formate ion to H₂ and CO₂ in the presence of Cr(CO)₆ appears to be closely related to the water gas shift reaction. The rate of H₂ production from the formate ion exhibits saturation kinetics in the formate ion and is inhibited by added pyridine. The infrared spectra of the catalyst solutions indicate an LCr(CO)₅ intermediate. Photolysis of the Cr(CO)₆/formate system in aqueous methanol in the presence of an aldehyde RCHO (R =n-heptyl,p-tolyl, andp-anisyl) results in catalytic hydrogenation of the aldehyde to the corresponding alcohol RCH₂OH by the formate ion. Detailed kinetic studies onp-tolualdehyde hydrogenation by this method indicates saturation kinetics in formate ion, autoinhibition by thep-tolualdehyde, and a threshold effect for Cr(CO)₆ at concentrations >0.004 mol L^–1. The presence of an aldehyde can interrupt the water gas shift catalytic cycle by interception of an HCr(CO)₅ ^– intermediate by the aldehyde.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1533–1539, September, 1994.