氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

Effect of absorbed pump power on the quality of output beam from monolithic microchip lasers

The dependence of the beam propagation factor (M ² parameter) with the absorbed pump power in the case of monolithic microchip laser under face-cooled configuration is extensively studied. Our investigations show that the M ₂ parameter is related to the absorbed pump power through two parameters (α and β) whose values depend on the laser material properties and laser configuration. We have shown that one parameter arises due to the oscillation of higher order modes in the microchip cavity and the other parameter accounts for the spherical aberration associated with the thermal lens induced by the pump beam. Such dependency of M ² parameter with the absorbed pump power is experimentally verified for a face-cooled monolithic microchip laser based on Nd³⁺ -doped GdVO₄ crystal and the values of α and β parameters were estimated from the experimentally measured data points.     

An admissible minimax estimator of a bounded scale-parameter in a subclass of the exponential family under scale-invariant squared-error loss

A subclass of the scale-parameter exponential family is considered and for the rth power of the scale parameter, which is lower bounded, an admissible minimax estimator under scale-invariant squared-error loss is presented. Also, an admissible minimax estimator of a lower-bounded parameter in the family of transformed chi-square distributions is given. These estimators are the pointwise limits of a sequence of Bayes estimators. Some examples are given.     

Changes in the kurtosis parameter of super-Gaussian beams passing through a spherically aberrated lens

Based on the Collins formula and irradiance moments definition, the propagation of the kurtosis parameter of super-Gaussian beams through a spherically aberrated lens is studied. Detailed numerical results are given. It is shown that, as compared with aberration-free super-Gaussian beams, the profile of spherically aberrated super-Gaussian beams can be leptokurtic, mesokurtic or platykurtic, depending on the aberration and propagation distance. The results for the spherically aberrated Gaussian beams can be dealt with as a special case treated in this paper. Finally, the advantage of our method is pointed out.     

在高密度下核物质的色超导性

建立了相变热力学理论和场论的关系. 强调在量子场论中必须引进序参量场， 则相变的讨论就类似于Goldstone bosons 的产生. 如果只讨论一级相变， Goldstone bosons场就足够了; 如果要讨论二级相变， 则必须讨论一系列的场， 这些场构成一个对称群的表示. 另外, 也将这一思想用到色超导中. In this paper we built a relation between the thermodynamical theory of the phase transition and field theory. We emphasized that in the quantum field theory we have to introduce the order parameter fields. Then the discussion of the phase transition is closed to the creation of the Goldstone bosons. If we only discuss the first order transition, the Goldstone bosons fields are sufficient. If we want to discuss the second order transition, we have to discuss a set of fields that constructs a representation of a symmetry group. We also apply this concept to color superconductivity.     

Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

Structure and Structural Nonrigidity of Tetrachlorodibenzo-p-Dioxin Radical Cations

Ab initio calculations showed that the tetrachlorodibenzo-para-dioxin radical cations (TCDD RCs) with a planar structure have two steady states with asymmetric dioxin cycles. The activation barriers between these states are up to 2 kcal/mole, so that the RCs may be regarded as being structurally nonrigid within the dioxin cycle. The 2,3,7,8-TCDD RC is more stable than the 1,4,6,9-TCDD RC, the energy difference being 5.2 kcal/mole. The adiabatic ionization potential of 2,3,7,8-TCDD (7.54 eV) is 0.1 eV smaller than the corresponding potential of 1,4,6,9-TCDD. These factors account for the increased hemoproteide affinity and hence increased biological activity of 2,3,7,8-TCDD.     

Statistical thermodynamics evaluation of polymer–polymer miscibility

The Simha and Somcynsky (S–S) statistical thermodynamics theory was used to compute the solubility parameters as a function of temperature and pressure [δ = δ(T, P)], for a series of polymer melts. The characteristic scaling parameters required for this task, P*, T*, and V*, were extracted from the pressure–temperature–volume (PVT) data. To determine the potential polymer–polymer miscibility, the dependence of δ versus T (at ambient pressure) was computed for 17 polymers. Close proximity of the δ versus T curves for four miscible polymer pairs: PPE/PS, PS/PVME, and PC/PMMA signaled the usefulness of this approach. It is noteworthy, that the tabulated solubility parameters (derived from the solution data under ambient conditions) propounded the immiscibility of the PVC/PVAc pair. The computed values of δ also suggested miscibility for polymer pairs of unknown miscibility, namely PPE/PVC, PPE/PVAc, and PET/PSF. In recognizing the limitations of the solubility parameter approach (the omission of several thermodynamic contributions), these preliminary results are auspicious because they indicate a new route for estimating the miscibility of any polymeric material at a given temperature and pressure. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2909–2915, 2004     

High power CW solid-state multilaser system

A laser system containing four CW Nd:YAG double-rod lasers, transforming optics and a fibre with input-output optics has been designed and investigated. It is shown that reduction of the beam parameter product of the non-Gaussian beams in the image space of the lens has made it possible to collect the emission of four lasers to the same fibre. Independent laser operation has provided the output power control in the range of 10–900 W with a stable light spot size on the input end of the fibre.