Two‐stage copolycondensation of preformed oligomers with bisphenols by tosyl chloride/dimethylformamide/pyridine from distributions of resulting oligomers determined by a combination of gel permeation chromatography and NMR

A two‐stage co‐oligomerization of the oligomers initially formed from an equimolar mixture of isophthalic acid (IPA) and terephthalic acid (TPA) and 2,2‐bis(4‐hydroxyphenyl)propane (BPA, 50 mol %) with bisphenols (BPs, 20 mol %) was carried out using a tosyl chloride/dimethylformamide/pyridine condensing agent. The distributions of the resulting oligomers (n_x‐mers), which were quenched with methanol, were determined by a combination of gel permeation chromatography (GPC) and NMR. These distributions (presented by molar percentage) were conveniently calculated with the equation n_x (mol %) = n_x (% mol by GPC) × n₀ (mol % by NMR)/n₀ (% mol by GPC), where n_x (% mol) = n_x (wt % by GPC)/its molecular weight. The results showed the distributions of the preformed IPA/TPA‐BPA oligomers to be in fairly good accord with those obtained directly from GPC and to be supported by the NMR results. The calculation was applied to the co‐oligomers prepared up to a reaction of 0.7, at which there was an increase in the number of higher oligomers indivisible by GPC and the distributions could no longer be determined by molar percentage. The calculated distributions are discussed in relation to the results of copolycondensation. The sequence distributions in the resulting co‐oligomers, which were also examined by NMR, are compared with those in the copolymers. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 44–51, 2004     

A novel specimen for investigating the mechanical behavior of elastomers under multiaxial loading conditions

In this paper we describe the design and manufacture of an axial-torsion test specimen, and provide relationships needed when conducting stress-strain characterization experiments with the specimen. The specimen is a short hollow cylinder of rubber bonded between two steel mounting rings, in which simultaneous axial and shear strains are produced via independently controlled axial and twist displacements. We present calculations for the strain-displacement and stress-load relationships, and strain energy density. These relationships have been established and validated via a combination of analytical and experimental techniques, and finite element analysis. We have investigated the extent and effects of strain and stress field non-uniformity in the test specimen. The specimen design is sufficiently simple that a closed-form expression for the strain-displacement relationship has been successfully developed.     

Axisymmetric Collision Problem for Two Identical Elastic Solids of Revolution

A direct central collision of two identical bodies of revolution is studied. A nonstationary mixed boundary-value problem with an unknown moving boundary is formulated. Its solution is represented by a series in term of Bessel functions. An infinite system of Volterra equations of the second kind for the unknown expansion coefficients is derived by satisfying the boundary conditions. The basic characteristics of the collision process are determined depending on the curvature of the frontal surface of the bodies     

Thermal decomposition of struvite

Struvite (NH₄MgPO₄·6H₂O) is a mineral often found in urinary tracts and kidneys. Thermal decomposition using slow low heating shows that the 'kidney' stone can be decomposed at temperatures below 40°C. At this temperature both ammonia and water are evolved. If more rapid heating is employed the decomposition occurs at around 80°C. The implication of this work rests with the use of low slow heat for the decomposition of the kidney stones. This revised version was published online in July 2006 with corrections to the Cover Date.     

电子探针定量分析的标准样品——几种多元氧化物单晶

在很高的温度和适宜的生长条件下,分别采用熔盐籽晶法和高温引上法生长了高质量的YAP、NAB、KTP、LN、BBO、SBN等多元氧化物单晶,它们具有优良的物理化学性能,严格的化学比,固定的组成与结构以及较好的化学均匀性和电子束轰击下的稳定性。广泛地用于激光和非线性光学领域。我们选用这些晶体为原材料研制电子探针定量分析的标准样品。经过测量和标定,这些单晶标样符合中华人民共和国国家标准GB 4930-85(电子探针显微分析标准样品通用技术条件)的规定。含有稀土元素的标样如NAB和YAP能发出绿色荧光,是电子显微术中理想的阴极发光材料。     

Effect of initiators on grafting in the initial stage of the emulsion polymerization of methyl methacrylate using poly(vinyl alcohol) as a protective colloid

 To make clear the reason of unsuitability of poly(vinyl alcohol) (PVA) protective colloid for the emulsion polymerization of conjugated monomers, a model experiment of emulsion polymerization of methyl methacrylate (MMA) was carried out with ammonium persulfate (APS) or azobis(isobutyronitrile) (AIBN) initiators, where a small amount of MMA (1/100th of the concentration compared with ordinary emulsion polymerization) was employed. This corresponds to the initial stage of the emulsion polymerization. Grafting of MMA onto PVA took place remarkably irrespective of the kind of the initiators. Formation of homo-poly(MMA) was observed to a small extent. The formation of new emulsion particles smaller than 100 nm continued to increase to almost the end of the polymerization. PVA molecules in the grafted polymer are supposed to act as stabilizers of newly formed particles. From kinetic treatment using the experimental data, the important issues were derived as follows. Firstly, the sulfate anion radical from APS is much more reactive than the isobutyronitrile radical from AIBN in terms of hydrogen abstraction from PVA. Secondly, high grafting ability of the latter initiator system, notwithstanding the much lower reactivity in the hydrogen abstraction compared with the APS system, is attributed to the relative reactivity of the primary radicals, i.e., hydrogen abstraction reaction from PVA to initiation reaction with MMA. The much slower rate of addition of the isobutyronitrile radical to the monomer compared with that of hydrogen abstraction from PVA facilitates the grafting, although the rate constant of hydrogen abstraction is far smaller than that with the sulfate anion radical by 10⁻⁴ times. Received: 26 April 2001 Accepted: 6 September 2001     

双二氮杂萘酮类化合物的电喷雾质谱研究

含新型芳香杂环单元的缩聚高分子材料耐老化热稳定性好,具有独特的加工长度和弹性模量,在宇航、电子、机械、军事和复合材料等方面的应用已引起人们的广泛兴趣和关注。含双二氮杂萘酮单元的缩聚高分子材料就是其中一种,这些新型芳香杂环单元大多数熔点都较高,难于汽化,采用电子轰击质谱或快原子轰击质谱测定其相对分子质量时,通常得不到分子离子峰信号,给质谱表征和结构鉴定带来一定的困难。     

ELECTROCHEMICAL POLYMERIZATION OF ANILINE IN PHOSPHORIC ACID AND THE PROPERTIES OF POLYANILINE

The behavior of the electrochemical polymerization of aniline in a weak acid, phosphoric acid, is very similar to that in strong acids, i.e. its polymerization rate increases quickly with the electrolysis time. The FTIR spectra of polyaniline samples synthesized in phosphoric acid indicate that the counter ion H2PO4^- is present in both the oxidized form and the reduced form of polyaniline. The counter ion plays an important role in adjusting the pH value at the electrode surface of polyaniline during the oxidation and reduction processes. As a result, a pair of redox peaks still appear in cyclic voltammograms of polyaniline in a solution of sodium sulfate of pH 5.5 and in a solution of NaH2PO4 of pH 7.0,respectively, at low potential scan rate; and the color of polyaniline film also changes with applied potential at pH 7.0. Thus,the pH region for the electrochemical activity and the electrochromism of polyaniline is extended to pH 5.5 for a solution of sodium sulfate and to pH 7.0 for a solution of NaH2PO4. The conductivity of polyaniline is 3.3 S cm^-1, depending on the concentration of phosphoric acid used in the stage of polymerization of aniline. The result of elemental analysis of polyaniline is presented here.     

Computational studies on glyceraldehyde and glycine Maillard reaction—I

Mechanisms for the initial stage of glyceraldehyde and glycine Maillard reaction under different pH conditions have been proposed, following usually the Hodge-scheme. Computations have been performed on the mechanisms at the standard state to test the possibility of the formation of different compounds, through evaluating the changes in Gibb's free energy during the reaction. Electronic energy changes during the reaction have also been evaluated. Glyceraldehyde+deprotonated glycine reaction has been found to be the most favorable for the formation of the Amadori rearrangement products in both gaseous and aqueous states. Due to the possibility of the production of both enol and keto forms of the Amadori rearrangement product, the rate of browning in glyceraldehyde+deprotonated glycine reaction is assumed to be faster than the others. Glyceraldehyde+unionized glycine reaction has been found to be more plausible for the formation of the keto form of the Amadori rearrangement products, particularly, in the gaseous phase. Glyceraldehyde+protonated glycine and glyceraldehyde+glycine zwitterion reactions are not favorable for the formation of the Amadori rearrangement products. Formation of hydroxyacetaldehyde from glyceralaldehyde, as one of the possible C2-fragmentation product, has been found to be favorable in the aqueous state.