二氧化钒薄膜的低温制备及其性能研究

针对VO₂薄膜在微测辐射热计上的应用，采用射频反应溅射法，在室温下制备氧化钒薄膜；研究了氧分压对薄膜沉积速率、电学性质及成分的影响.通过调节氧分压，先获得成分接近VO₂的非晶化薄膜，再在400℃空气中氧化退火，便可制得高电阻温度系数，低电阻率的VO₂薄膜，电阻温度系数约为-4%/℃，薄膜方块电阻为R_□为100—300kΩ；薄膜在室温下沉积，400℃下退火的制备方法与微机电加工(micro electromechanic 关键词： 二氧化钒 电阻温度系数 氧分压 射频反应溅射法     

Spectrofluorimetric Method for the Determination of Aluminum with Alizarin Red PS

 A simple and direct spectrofluorimetric method has been developed for the determination of aluminum using alizarin red PS (1,2,4-trihydroxy 9,10-anthraquinone-3-sulfonic acid). The method is based on the strong fluorescence (480/564 nm) of Al³⁺ and alizarin red. Experimental parameters such as pH, concentration of the ligand, ionic strength of the solution, reaction time and temperature were optimized in order to maximize the analytical signal. Interferences of several ions (anions and cations) were studied and evaluated. The linear range of the method extends from 3 to 100 μg L⁻¹. Limit of detection (3s_b) was 0.9 μg L⁻¹. The method was tested with a silicate certified reference material. Interferences were eliminated by a liquid extraction with cupferron. Author for correspondence. E-mail: aucelior@rdc.puc-rio.br Received September 10, 2002; accepted January 15, 2003 Published online May 5, 2003     

Soluble,saturated‐red‐light‐emitting poly(p‐phenylenevinylene) containing triphenylamine units and cyano groups

A conjugated poly(p‐CN‐phenylenevinylene) (PCNPV) containing both electron‐donating triphenylamine units and electron‐withdrawing cyano groups was prepared via Knoevenagel condensation in a good yield. Gel permeation chromatography suggested that the soluble polymer had a very high weight‐average molecular weight of 309,000. A bright and saturated red emission was observed under UV excitation in solution and film. Cyclic voltammetry showed that the polymer presented quasi‐reversible oxidation with a relatively low potential because of the triphenylamine unit. A single‐layer indium tin oxide/PCNPV/Mg–Ag device emitted a bright red light (633 nm). © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3947–3953, 2004     

氟化类金刚石薄膜的拉曼和红外光谱结构研究

关键词：     

Energy transfer between the flavin chromophores of electron-transferring flavoprotein fromMegasphaera elsdenii as inferred from time-resolved red-edge and blue-edge fluorescence spectroscopy

Both a mode-locked argon-ion laser and synchrotron radiation were used as excitation sources to obtain time-resolved polarized fluorescence of the two FAD cofactors in electron transferring flavoprotein fromMegasphaera elsdenii. Red-edge excited and blue-edge detected fluorescence anisotropy decay curves did not contain a fast relaxation process which was observed upon mainband excitation and detection. This relaxation was assigned to homo-energy transfer between the two FAD cofactors. Failure of energy transfer as observed with edge spectroscopy on this protein excludes restricted reorientational motion of the flavins as a possible mechanism of depolarization. From the global analysis of the fluorescence anisotropy decay surface obtained at multiple excitation and detection wavelengths, the distance between and the relative orientation of the flavins could be estimated. The methodology described has general applicability in other multichromophoric biopolymers and has the potential to acquire accurate geometrical parameters in these systems.     

Coupled Thermo-Hydro-Mechanical and Chemical Analysis of Expansive Clay Subjected to Heating and Hydration

A fully coupled formulation combining reactive transport and an existing thermo-hydro-mechanical (THM) code is presented. Special attention has been given to phenomena likely to be encountered in clay barriers used as part of containment systems of nuclear waste. The types of processes considered include hydrolysis, complex formation, oxidation/reduction reactions, acid/base reactions, precipitation/dissolution of minerals and cation exchange. Both kinetically-controlled and equilibrium-controlled reactions have been incorporated. The total analytical concentrations (including precipitated minerals) are adopted as basic transport variables and chemical equilibrium is achieved by minimizing Gibbs Free Energy. The formulation has been incorporated in a general purpose computer code capable of performing numerical analysis of engineering problems. A validation exercise concerning a laboratory experiment involving the heating and hydration of an expansive compacted clay is described.     

磁控溅射ZnO薄膜的成核机制及表面形貌演化动力学研究

利用原子力显微镜分析了ZnO薄膜在具有本征氧化层的Si(100)和Si(111)基片上的表面形貌 随沉积时间的演化. 通过对薄膜生长形貌的动力学标度表征，研究了射频反应磁控溅射条件 下，ZnO薄膜的成核过程及生长动力学行为. 研究发现，ZnO在基片表面的成核过程可分为初 期成核阶段、低速率成核阶段和二次成核阶段. 对于Si(100)基片，三个成核阶段的生长指 数分别为β₁=1.04，β₂=0.25±0.01，β₃=0.74；对 于Si(11 关键词： ZnO薄膜 磁控溅射 生长动力学 成核机制     

Pulsed reactive crossed beam laser ablation of La0.6Ca0.4CoO3 using O: Where does the oxygen come from?

The composition of thin perovskite films, especially the oxygen content, is a crucial parameter which influences many physical properties, such as conductivity and catalytic activity. Films produced by pulsed laser deposition are normally annealed in an oxygen atmosphere after deposition to achieve a desired oxygen content. In pulsed reactive crossed beam laser ablation, no annealing step is necessary, but a fundamental question regarding this deposition technique is still open: where does the oxygen in the films come from?There are three possibilities, i.e. from the target, from the gas background, or from the gas pulse. To answer this question two experiments were performed: ¹⁸O₂ was used during the deposition process as background gas with ¹⁶O anions in the target and ¹⁶O₂ gas pulse, and a ¹⁸O₂ gas pulse with ¹⁶O from the target and background. These experiments revealed that the quantification of the oxygen origin is only possible, when no oxygen exchange occurs at the deposition temperature. The films are characterized after deposition by elastic recoil detection analysis (ERDA) to determine the ¹⁶O/¹⁸O ratio. Experiments with different oxidizing species in the gas pulse (N₂O and O₂) confirm that the oxidizing potential (N₂O > O₂) as well as the number of molecules are important.     

反应离子镀光学薄膜的微观结构分析

用反应离子镀方法制备了ＴｉＯ２单层膜及ＴｉＯ２／ＳｉＯ２多层膜，用透射电子显微镜分别观察了由反应离子镀方法及传统蒸镀法二种不同工艺制得的ＴｉＯ２单层膜及ＴｉＯ２／ＳｉＯ２多层膜的断面结构，并对ＴｉＯ２单层膜进行了喇曼分析和卢瑟福背散射分析。