极谱法测定硫酸稀土复盐母液中的稀土总量

在pH9.0的NH3·H2O-(NH4)2SO4缓冲介质中,RE(Ⅲ)-TP的络合吸附波的波高与RE(Ⅲ)的浓度在0-10μg/mL间成线性。该方法的相对标准偏差2.23%,回收率99.51%-103.38%,用于硫酸稀土复盐母液中微量稀土总量测定,结果满意。     

Studies of photooxidative degradation of poly(vinyl chloride)/poly(ethylene oxide) blends

The photooxidative degradation of blends (in a full range of compositions) of amorphous poly(vinyl chloride) (PVC) with semicrystalline poly(ethylene oxide) (PEO) in the form of thin films is investigated using absorption spectroscopy (UV–visible and Fourier transform infrared) and atomic force microscopy (AFM). The amount of insoluble gel formed as a result of photocrosslinking is estimated gravimetrically. It is found that the PVC/PEO blendsí susceptibility to photooxidative degradation differs from that pure of the components and depends on the blend composition and morphology. Photoreactions such as degradation and oxidation are accelerated whereas dehydrochlorination is retarded in blends. The photocrosslinking efficiency in PVC/PEO blends is higher than in PVC; moreover, PEO is also involved in this process. AFM images showing the lamellar structure of semicrystalline PEO in the blend lead to the conclusion that the presence of PVC does not disturb the crystallization process of PEO. The changes induced by UV irradiation allow the observation of more of the distinct PEO crystallites. This is probably caused by recrystallization of short, more mobile chains in degraded PEO or by partial removal of the less stable amorphous phase from the film surface. These results confirm previous information on the miscibility of PVC with PEO. The mechanism of the interactions between the components and the blend photodegradation are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 585–602, 2004     

Poly(vinyl chloride)-paste/clay nanocomposites: Investigation of thermal and morphological characteristics

The paper concentrates on poly(vinyl chloride) - PVC - from the point of nanocomposite characterisation through thermal degradation of samples, evolution of the changes caused by elevating temperature using TGA, FTIR and Congo Red methods combined with morphological characterisation by XRD and TEM analyses. A novel method of PVC-paste/nanocomposite preparation while processing was used. During preparation, PVC plasticizer was mixed with clay, both natural and organophilic, and the suspension was then compounded with the other components. Two factors were followed: effect of shearing alone, and in combination with temperature. As is presented, the type of nano-filler and its chemical modifier have obvious influence on final properties either thermal or morphological. Presented contribution follows previous part of investigation and brings further information from PVC-paste/nanocomposite field.     

Deacetalisation-bicyclisation routes to novel polycyclic heterocycles using stannous chloride dihydrate

The stannous chloride dihydrate-mediated deprotection-bicyclisation of a range of amides possessing a pendant acetal group is reported. These mild reaction conditions have been used to prepare a number of ring-fused heterocyclic compounds, some in enantiomerically pure form, which should be of interest both in their own right and as building blocks for the production of more complex target molecules.     

Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

Effects of tributyltin(IV) chloride on the gametes and fertilization of Ascidia malaca (Ascidiacea: Tunicata)

Ascidia malaca gametes before fertilization incubated in 10^?5 or 10^?7 M solutions of tributyltin(IV) chloride, TBTCl, for 3 h appear highly damaged under transmission electron microscopy observation. Also, the fertilization process is affected by the compound: the damaged spermatozoa are present in the vitelline coat and the egg does not cleave. An increase of microbodies, structurally similar to peroxisomes, have been detected in the egg peripheral cytoplasm, probably in relation to their role in alleviating damage to some cellular components. The results have shown that the reproduction of ascidians under unfavourable environmental conditions is prevented. Copyright © 2003 John Wiley & Sons, Ltd.     

硫酰胺的快速分析（Ⅱ） 

硫酰胺生产过程中副产的大量氯化铵要干扰硫酰胺的测定，采用四苯硼钠将全部氯化铵呈沉淀析出，再用次溴酸钠把滤液中的硫酰胺分解成氮气，测其体积，计算出硫酰胺的含量。对样品进行测定的结果表明，该法重现性好、准确度高、分析周期在３５ｍｉｎ内，相对误差在±１％以内。     

A facile synthesis of per (poly )fluoroalkyl substituted α-amino acid derivatives

Initiated by CrCl3/Fe redox couple, per(poly)fluoroalkyl iodides added to methyl a-acetylamino acrylate, giving B-per(poly)fluoroalkyl a-amino acid derivatives in good yields.     

Magnetic behaviour of TbMnFe

Neutron diffraction and M?ssbauer measurements have been carried out on the cubic Laves phase intermetallic TbMnFe. The magnetic moment on the transition metal atom is found to be low, 0.2μ _B, at room temperature. This moment is temperature independent down to 10 K. Magnetic moment on the rare earth atom varies from 2.5μ _B at 296 K to 7.27μ _B at 10 K. M?ssbauer spectra recorded at 298 K and 78 K have magnetic character but there is a large distribution of hyperfine field values. Both these features arise due to magnetic frustration created in the sample due to the competing ferro and antiferromagnetic interactions between the transition metal atoms.