催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

Modulated DSC for gas hydrates analysis

Modulated DSC has been applied to the study of methane, ethane and propane hydrates at different hydrate and ice concentrations. The reversing component of the TMDSC curves, makes it possible to characterize such hydrates. Methane and ethane hydrates show the melting-decomposition peak at a temperatures higher than the ice contained in the sample, while propane hydrate melts and decomposes at lower temperature than the ice present in the sample. The hydrate peaks tend to disappear if the hydrate is stored at atmospheric pressure. Guest size and cavity occupation fix the heat of dissociation and stability of the hydrates, as confirmed by parallel tests on tetrahydrofurane hydrates.     

Sol-Gel Particulate Float Process to Make Vitreous Silica Bodies

Particulate sol-gel technology uses larger particles than that of alkoxide-derived gels and provides larger pore sizes in the gelled object. This allows relatively rapid drying and fabrication of large rods or tubular shapes. However, the formation of more complex or flat shapes, which require extensive surface contact with a mold, is more difficult. The shrinkage during drying, with the significantly greater stress of surface friction due to adhesion, frequently leads to cracking.We have demonstrated a solution to this problem by floating the gel on the surface of a dense liquid. Dry silica panels up to 28 × 40 × 0.7 cm³ were prepared in this way. The use of patterning molds allowed the fabrication of more sophisticated shapes. These bodies were sintered to transparent vitreous silica articles of near net dimensions.     

Calorimetric study of methane interaction with supported Pd catalysts

As supported palladium oxide catalysts present the best performances in methane combustion in lean conditions, microcalorimetric studies of the interaction between methane and palladium oxide or metallic palladium supported on Al₂O₃, ZrO₂ and BN have been performed at 673 K. At this temperature methane reduced the palladium oxide, and the heat of reduction of palladium oxide was shown to depend on the dispersion and on the support. The lowest heats of reduction corresponded to the highest rates of methane combustion. Moreover methane reforming occurred on metallic palladium, producing hydrogen, and again methane decomposition was shown to depend on the support. This revised version was published online in July 2006 with corrections to the Cover Date.     

CO_2 Reforming of CH_4 over Ni/CeO_2-ZrO_2-Al_2O_3 Prepared by Hydrothermal Synthesis Method

The Ni/CeO2-ZrO2-Al2O3 catalyst with different Al2O3 and NiO contents were prepared by hydrothermal synthesis method. The catalytic performance for CO2 reforming of CH4 reaction, the interaction among components and the relation between Ni content and catalyst surface basicity were investigated. Results show that the interaction between NiO and Al2O3 is stronger than that between NiO and CeO2-ZrO2.The addition of Al2O3 can prevent the formation of large metallic Ni ensembles, increase the dispersion of Ni, and improve catalytic activity, but excess Al2O3 causes the catalyst to deactivate easily. The interaction between NiO and CeO2 results in more facile reduction of surface CeO2. The existence of a small amount of metallic Ni can increase the number of basic sites. As metallic Ni may preferentially reside on the strong basic sites, increasing Ni content can weaken the catalyst basicity.     

工业污染排放中气──固两相流的光学测量

烟尘及各种工业性粉尘排放是典型的气-固两相系．迄今为止，国内外尚缺少有效的监测其排放的手段．本文基于光的散时原理，提出了一种非接触的光学方法，能对上述固体颗粒物的污染排放浓度及粒径大小进行实时、在线的监测。计算机模拟和实验研究表明，该方法具有广阔的工业应用前景。     

添加助剂的钙钛矿型氧化物NdMO_3上的甲烷氧化偶联——Ⅱ.15% Li_2O/NdMO_3(M=Cr、Mn、Fe、Co、Ni)上的OCM反应研究

在添加了15%Li_2O的NdMO_3(M=Cr、Mn、Fe、Co、Ni)上进行了甲烷氧化偶联(OCM)反应研究.通过改变反应气中CH_4:O_2浓度比,在氧化态和“脱氧态”催化剂上的CH_4脉冲反应,探讨了表面吸附氧和晶格氧在OCM反应中的作用以及NdMO_3中不同金属离子(M)对OCM反应活性的影响等.     

THE AROMATIZATION MECHANISM OF METHANE OVER Mo/HZSM-5 ZEOLITE CATALYSTS WITHOUT USING OXIDANTS

IntroductionMethancisthcmaJorcomponcntofnaturalgasanditscatalyticconvcrsiontodcsiredchemicalproductsorliquidfiJcIisnotonl}'apromisingapproachtotheutilizationofnaturalgasrcsourccbutalsoagrcatsubjcctforcatalysissciencctt'hichdcaIst"iththcactivationofsmallmolcculesThcx"orldrcscrvcofnaturalgashasbccnexplorcdasaboutl382562xl()8m3IllTheMTGprocessdcvclopedbythcMobilcorpcangctliquidfuelfrommethancthroughsteamreformingofmethanctoproduccsynthcsisgaswhichisassociatedt'ithamaJorityofthecostsofthcprocc…     

La2Zr2O7催化剂结构相变对甲烷氧化偶联反应性能的影响

采用共沉淀法并通过改变焙烧温度制备了一系列具有不同晶相结构的La₂Zr₂O₇催化剂，在微型固定床反应器上评价其甲烷氧化偶联反应性能，并利用XRD、Raman、CO₂-TPD、XPS等表征手段，探究催化剂的物相结构、表面碱性以及表面氧物种的变化规律。结果表明，随着焙烧温度从700℃逐渐升高到1200℃，La₂Zr₂O₇催化剂结晶度不断提高，晶相发生明显变化，从无定形结构逐渐向缺陷萤石结构过渡，最终转变成烧绿石结构。焙烧温度提高促使La₂Zr₂O₇晶相转变过程中，催化剂表面的碱性强度减弱，中等碱性位数量以及具有催化活性的表面氧物种O₂^2-和O₂^-的相对含量不断减少，致使催化剂的CH₄转化率和C₂₊选择性不断降低。其中，无定形LZO-CP-700催化剂表现出最佳的甲烷氧化偶联反应性能。