基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Tween 20-stabilized gold nanoparticles combined with adenosine triphosphate-BODIPY conjugates for the fluorescence detection of adenosine with more than 1000-fold selectivity

This study describes the development of a simple, enzyme-free, label-free, sensitive, and selective system for detecting adenosine based on the use of Tween 20-stabilized gold nanoparticles (Tween 20-AuNPs) as an efficient fluorescence quencher for boron dipyrromethene-conjugated adenosine 5′-triphosphate (BODIPY-ATP) and as a recognition element for adenosine. BODIPY-ATP can interact with Tween 20-AuNPs through the coordination between the adenine group of BODIPY-ATP and Au atoms on the NP surface, thereby causing the fluorescence quenching of BODIPY-ATP through the nanometal surface energy transfer (NSET) effect. When adenosine attaches to the NP surface, the attached adenosine exhibits additional electrostatic attraction to BODIPY-ATP. As a result, the presence of adenosine enhances the efficiency of AuNPs in fluorescence quenching of BODIPY-ATP. The AuNP-induced fluorescence quenching of BODIPY-ATP progressively increased with an increase in the concentration of adenosine; the detection limit at a signal-to-noise ratio of 3 for adenosine was determined to be 60 nM. The selectivity of the proposed system was more than 1000-fold for adenosine over any adenosine analogs and other nucleotides. The proposed system combined with a phenylboronic acid-containing column was successfully applied to the determination of adenosine in urine.     

Analytic hierarchy process for multi-sensor data fusion based on belief function theory

Multi-sensor data fusion is an evolving technology whereby data from multiple sensor inputs are processed and combined. The data derived from multiple sensors can, however, be uncertain, imperfect, and conflicting. The present study is undertaken to help contribute to the continuous search for viable approaches to overcome the problems associated with data conflict and imperfection. Sensor readings, represented by belief functions, have to be fused according to their corresponding weights. Previous studies have often estimated the weights of sensor readings based on a single criterion. Mono-criteria approaches for the assessment of sensor reading weights are, however, often unreliable and inadequate for the reflection of reality. Accordingly, this work opts for the use of a multi-criteria decision aid. A modified Analytical Hierarchy Process (AHP) that incorporates several criteria is proposed to determine the weights of a sensor reading set. The approach relies on the automation of pairwise comparisons to eliminate subjectivity and reduce inconsistency. It assesses the weight of each sensor reading, and fuses the weighed readings obtained using a modified average combination rule. The efficiency of this approach is evaluated in a target recognition context. Several tests, sensitivity analysis, and comparisons with other approaches available in the literature are described.     

Holographic sensors for the determination of ionic strength

Holographic sensors for monitoring ionic strength have been fabricated from charged sulphonate and quaternary ammonium monomers, incorporated into thin, polymeric hydrogel films which were transformed into volume holograms. The diffraction wavelength or reflected colour of the holograms was used to characterise their swelling or de-swelling behaviour as a function of ionic strength in various media. The effects of co-monomer structure, buffer composition, ion composition, pH and temperature were evaluated, whilst the reversibility and reproducibility of the sensor was also assessed. An acrylamide-based hologram containing equal molar amounts of negatively and positively charged monomers was shown to be able to quantify ionic strength independent of the identity of the ionic species present in the test solution. The sensor was fully reversible, free of hysteresis and exhibited little response to pH between 3 and 9 and temperature within the range 20-45 °C. The system was successfully used to quantify the ionic strength of milk solutions, which contain a complex mixture of ions and biological components.     

Silicon-Based Integrated Optic Pressure Sensor Using Intermodal Interference between TM-Like and TE-Like Modes

In this paper, a silicon-based integrated optic pressure sensor using an intermodal interference between the fundamental TM-like and TE-like modes is described. The sensor consists of a micromachined rectangular diaphragm and a straight polystyrene optical waveguide passing over the diaphragm. Its sensitivity is theoretically known to be strongly dependent on the position of the waveguide over the diaphragm. To experimentally investigate such dependence, we fabricated a sensor with a 1.2 mm ×10 mm ×20 μm diaphragm, over which waveguides were placed at 50 μm intervals. The measured phase sensitivity was 98 mrad/kPa for the waveguide nearest to the diaphragm edge. The measurement was also carried out for the other waveguides. As theoretically expected, the largest sensitivity was obtained for the waveguide nearest to the edge.     

Electrochemical Detection of As(III) via Iodine Electrogenerated at Platinum,Gold, Diamond or Carbon‐Based Electrodes

The reaction of iodine, electrogenerated from iodide, is used for the detection of As(III) via electrocatalytic reaction in the diffusion layer of a boron‐doped diamond electrode. The merits of this electrode material for this purpose (over platinum, gold or glassy carbon) are demonstrated and the kinetics of the reaction between I₂ and As(III) in acid reported.     

An optical fibre pH sensor based on dye doped mesostructured silica

This paper describes the synthesis and optical pH sensing properties of a pH indicator dye activated mesostructured silica coated optical fibre. The pH-sensitive dye bromothymol blue was incorporated into the mesostructure sol precursor and thin films/coatings were used for pH-sensing applications without prior removal of the surfactant. The pH sensitivity range and operating wavelength were analysed by absorption measurements on layer dip-coated on glass slides. The pH sensing properties of coated optical fibre were tested by evanescent wave method. Experiments were carried out by using a series of solutions of known pH. No leaching was observed (except at very high pH) and an excellent reversibility was obtained between pH=2 and 5.     

Temperature measurements using fiber optic polarization interferometer

A novel measurement method of temperature based on the phenomena that the phase difference between principle polarization states in the optical retarder is function of temperature is described. The polarization state of optical beam is changed as it passes through the optical retarder, which depends on the temperature. The temperature of optical retarder is determined by comparison of the power difference between principal polarization states. We demonstrate successfully the temperature measurement by using a polarization maintaining fiber as the optical retarder. With a 100 mm length of the fiber optic retarder, the change rate of phase difference on temperature was 0.236 rad/°C and the measurement error was ±0.038°C over the temperature range of −2.6 – +3.4°C. With a 11.5 mm length of the fiber optic retarder, the change rate of phase difference on temperature was 0.021 rad/°C and the measurement error was ±0.79°C over the temperature range of −8.5 – +86.5°C.     

Urea method for the synthesis of hydrotalcites

Mg-Al, Zn-Al and Ni-Al hydrotalcite-like compounds with high crystallinity were synthesized by using the decomposing property of urea at high temperature. The crystallinity and the regularly of the samples were much preferable to those synthesized by other methods. This revised version was published online in June 2006 with corrections to the Cover Date.     

Fluorescent humic substances–arsenic complex in well water in areas where blackfoot disease is endemic in Taiwan

The relationship between the four components, (1) fluorescence intensity, (2) arsenic concentration, (3) pH and (4) total dissolved solids, (TDS) measured in well waters from areas in Taiwan where blackfoot disease (BFD) is endemic was studied, as well as the relationships between the four degrees of BFD and each of the above four symptomatic components, in order to evaluate the etiological factors of BFD more progressively. The following 95% confidence intervals were obtained in well water samples (n = 1189): fluorescence intensity, 26.837–32.570; arsenic concentration, 0.103–0.127 mg dm^?3; pH, 7.466–7.519; and TDS 733.063–801.647 mg dm^?3. Fluorescence intensities of the four degrees of BFD were not all the same (F = 64.54, P < 0.001), and nor were arsenic concentrations (F = 72.03, P < 0.001), pH values (F = 7.30, P < 0.001), nor TDS values (F = 10.76, P < 0.001). In addition, multiple comparisons indicate that the higher the epidemical degree, the higher the fluorescence intensities, arsenic concentrations and pH values become; however, such a relationship is not found for TDS values. Moreover, the fluorescence intensities have positive linear correlations with arsenic concentrations (r = 0.49, P < 0.001), pH (r = 0.25, P < 0.001), and TDS (r = 0.18, P < 0.001), as do the arsenic concentrations with pH (r = 0.22, P < 0.001). Of the four epidemical degree groups, pairs are not significantly different from one another in correlation coefficients between fluorescence intensity and arsenic concentration, which implies a steady relationship between fluorescent compounds and arsenic. We conclude that fluorescent compounds in well water, as possible etiological factors of BFD, are closely related to arsenic along with pH and TDS values in the areas where BFD is endemic. In addition, we infer that a complex is formed by fluorescent compounds, arsenic and other metals.