A novel tridentate nitrogen donor as ligand in copper catalyzed ATRP of methyl methacrylate

A tridentate ligand, BPIEP: 2,6‐bis[1‐(2,6‐diisopropyl phenylimino) ethyl] pyridine, having central pyridine unit and two peripheral imine coordination sites was effectively employed in controlled/“living” radical polymerization of MMA at 90°C in toluene as solvent, Cu^IBr as catalyst, and ethyl‐2‐bromoisobutyrate (EBiB) as initiator resulting in well‐defined polymers with polydispersities M_w/M_n ≤ 1.23. The rate of polymerization follows first‐order kinetics, k_app = 3.4 × 10^?5 s^?1, indicating the presence of low radical concentration ([P*] ≤ 10^?8) throughout the reaction. The polymerization rate attains a maximum at a ligand‐to‐metal ratio of 2:1 in toluene at 90°C. The solvent concentration (v/v, with respect to monomer) has a significant effect on the polymerization kinetics. The polymerization is faster in polar solvents like, diphenylether, and anisole, as compared to toluene. Increasing the monomer concentration in toluene resulted in a better control of polymerization. The molecular weights (M_n,SEC) increased linearly with conversion and were found to be higher than predicted molecular (M_n,Cal). However, the polydispersity remained narrow, i.e., ≤1.23. The initiator efficiency at lower monomer concentration approaches a value of 0.7 in 110 min as compared to 0.5 in 330 min at higher monomer concentration. The aging of the copper salt complexed with BPIEP had a beneficial effect and resulted in polymers with narrow polydispersitities and higher conversion. PMMA obtained at room temperature in toluene (33%, v/v) gave PDI of 1.22 (M_n = 8500) in 48 h whereas, at 50°C the PDI is 1.18 (M_n = 10,300), which is achieved in 23 h. The plot of lnk_app versus 1/T gave an apparent activation energy of polymerization as (ΔE^≠_app) 58.29 KJ/mol and enthalpy of equilibrium (ΔH⁰_eq) to 28.8 KJ/mol. Reverse ATRP of MMA was successfully performed using AIBN in bulk as well as solution. The controlled nature of the polymerization reaction was established through kinetic studies and chain extension experiments. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 43: 4996–5008, 2005     

Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

Possible spectroscopic manifestation of the angular group induced bond alteration (AGIBA) effect in toluene

The most obvious consequence of the concept of aromaticity is the common confidence that in aromatic compounds, bond lengths do not alternate and are between typical to the single and double ones. However, in 1994, performing crystal structure investigations of substituted pyridines and their salts, Krygowski and co‐workers have discovered a very surprising angular group induced bond alteration (AGIBA) effect: It appears that some angular substituents, like methoxy or nitrozo groups, can induce bond alternation in aromatic rings. Crystal studies do not allow one to operate with liquids that are more common in organic chemistry. This paper presents the first possible evidence of spectroscopic manifestations of the AGIBA effect. Raman spectra of the liquid toluene are analyzed. It is found that instead of being single, the line corresponding to the ring breathing vibrations is clearly split by 1.0–1.4 cm^?1, thus indicating the presence of two (cis‐ and trans‐) AGIBA isomers. The energy difference between these isomers estimated in temperature dependent Raman studies is found equal to 6.68 kJ mol^?1. The low‐wavenumber line therefore corresponds to the cis‐AGIBA isomer and the high‐wavenumber line to the trans‐AGIBA isomer stabilized by the AGIBA effect. Copyright © 2007 John Wiley & Sons, Ltd.     

Influence of concentration on the activation energy for diffusion in polymer-solvent systems

The self-diffusion of benzene, toluene, and ethylbenzene in polystyrene have been analyzed using the Vrentas/Duda free-volume diffusion model. Diffusion coefficient predictions suggest an exponential concentration dependence of the activation energy required to overcome attractive forces, E. Without the use of any diffusion data approximating E as zero over the entire concentration range yields self-diffusion coefficient predictions which are in good agreement with experimental data. © 1992 John Wiley & Sons, Inc.     

TDI三聚体的合成研究

以一种碱金属羧酸盐K-1000作为甲苯二异氰酸酯(TDI)三聚反应的催化剂合成了以TDI三聚体为主要成分的多异氰酸酯固化剂。对合成工艺条件进行了探讨。结果表明,将反应温度控制在35℃,催化剂K-1000用量为0.06%时,用苯甲酰氯作为阻聚剂可得到性能基本稳定的TDI三聚体产品。     

甲苯定向硝化的理论研究

运用密度泛函理论(DFT)B3LYP方法，在6-31G~(* *)基组水平上，全优化计算 了硝酰阳离子NO_2~+对苯和从0-，m-,p-位进攻甲苯亲电取代硝化后应，求得4条反 应途径上包括反应物、过渡态和Wheland中间体共(4×3)12个反应驻点σ络合物的 分子几何、电子结构、能量和IR光谱等性质，阐明了反应中无同位素效应的实验事 实，求得各反应途径的活化能排序：p-＞o-＞PhH＞m-和σ络合物(R,TSak或INT)的 相对稳定化能排序：p-ArCH_3-NO_2~+＞o-ArCH_3-NO_2~+＞m-ArCH_3-NO_2~+＞ PhH-NO_2~+，从而阐明了甲基对苯环致活(或致钝)以及增加甲苯硝化络合物稳定性 的双重功能，对甲苯定向硝化的理论预示与实验结果相吻合。     

金属富勒烯La＠C_（2n）的合成、提取及其ESR和MS表征

采用对掺入Ｌａ_２Ｏ_３的石墨棒原位活化并结合交换电极回放方法制备了产率较高的金属富勒烯，并用甲苯高温热提取的方法有效地提取出Ｌａ＠Ｃ_（２ｎ），其中Ｌａ＠Ｃ_（７４）为可溶性金属富勒烯增加了新成员．同时，首次采用解吸电子轰击质谱对提取物进行了表征，讨论了提取物的ＥＳＲ谱．     

多壁碳纳米管负载铂的甲苯加氢脱芳催化剂

以多壁碳纳米管(CNTs)为载体制备了负载型Pt催化剂Pt/CNTs并将其用于催化甲苯加氢脱芳(HDA)反应.结果表明,在1.0%Pt/CNTs催化剂上,在0.4MPa,373K,PhCH3/H2摩尔比=6/94和GHSV=120L/(h.g)的反应条件下,甲苯转化率可达100%,比反应速率为0.0523mmol/(s.m2),分别是γ-Al2O3和AC负载各自最佳Pt负载量催化剂1.4%Pt/γ-Al2O3和2.4%Pt/AC上相应值的1.17和1.18倍.甲苯加氢产物全部为甲基环己烷,其他可能的加氢产物均在气相色谱检测限以下.催化剂的表征研究揭示,用CNTs代替γ-Al2O3或AC作为载体并不会引起所负载Pt催化剂上甲苯HDA反应的表观活化能发生明显变化.与γ-Al2O3或AC负载的相应催化剂相比,一方面,CNTs负载的Pt催化剂易于在较低温度下还原活化,并且其工作态催化剂表面催化活性Pt物种(Pt0)所占表面Pt摩尔分率有所提高;另一方面,CNTs负载的Pt催化剂对H2具有较高的吸附/活化和储存能力.这些促进效应对催化剂HDA活性的提高都有重要贡献.     

Importance of the Debye interaction in organic solutions: Henry's law constants for polar liquids in nonpolar solvents and vice versa

Henry's law constants have been determined for -butyrolactone (BL), ethyl acetate (EA), and 2-methyl-3-pentanol (MEP) in mixtures of iso-octane (ISO) and toluene (TOL), for BL, EA, TOL, and ISO in cinnamaldehyde (CIN) and for TOL and ISO in each other and in BL. From these data and published vapor pressures, the activity coefficients at infinite dilution and the standard molar Gibbs free energy of transfer, G ₂ ⁰ of the solutes from dilute solution in ISO to dilute solution in each solvent medium have been calculated. The different behavior patterns of BL and EA are attributed to differences in their abilities to exist in different conformations possessing different dipole moments. For polar solutes, G ₂ ⁰ decreases with increasing polarizability of the solvent and with increasing dipole moment of the solute, suggesting increased contributions from dipole-induced dipole (Debye) interactions. The sigmoidal plot of G ₂ ⁰ against the change in pair potential energy calculated from the classical expressions suggests that G ₂ ⁰ seriously underestimates the strength of the Debye interactions in comparison with the London interactions.     

化学蒸气沉积硅氧化合物调变HZSM－5沸石的研究

本文研究了正硅酸乙酯分别在无胺法和有胺法制得的ＨＺＳＭ－５沸石上的沉积过程，并用吸附，ＮＨ３－ＴＰＤ及异丙醇探针反应等手段表征了沉积后的样品，发现沉积仅在外表面上进行，可使孔口变小但不影响孔道内性质，显示有对于二甲苯分子的择形吸附能力，且在甲苯甲醇烷基化反应和二甲苯异构化反应中表现出良好的择形催化性能．