Drying agents for water-free introduction of desorption solvent into a GC after on-line SPE of aqueous samples

Summary A small cartridge containing a drying agent is inserted between a solid phase extraction (SPE) column and a gas chromatograph (GC) to enable the introduction of water-free desorption solvent into the GC in on-line liquid chromatography (LC)-type enrichment of trace-level analytes from water samples. Some characteristics of the drying agents, such as their capacity to retain water and their re-usability after heating, have been tested. Possible interactions of the drying agent with the analytes, e.g., irreversible adsorption or catalyzed degradation, have been checked for a wide range of alkanes, alkylbenzenes chlorobenzenes, chlorophenols and phthalate esters. Using the on-line SPE-GC system with flame ionization detection (FID) and spiked samples containing different levels of the test compounds, the repeatability was shown to be satisfactory (6–17%). For 10 mL samples, the detection limits were lower than 0.1 g/L. The on-line SPE-GC-FID system here presented can be used for the repeated analysis of water samples without exchange of the dyring cartridge. The technique is applied to the analysis of tap water.     

Biosensors for environmental pollutants and food contaminants

This review article provides an overview of the most recent literature on biosensors for environmental pollutants and food contaminants. Due to the large number of publications, only papers published between 2000 and January 2003 were considered. Also, while not all of the published literature could be reviewed here, over 200 references are cited to provide a good overview of research undertaken in the last two years. Older publications are covered by a number of earlier review articles. This article provides an introduction into the field including specific consideration of the application areas, describes the typical biosensor assay format used, and is subsequently structured according to the biorecognition elements used (i.e., nucleic acids, enzymes, whole cells, tissue and whole organisms, antibodies and receptors, and biomimetic materials). In addition, a section on microbiosensing systems is provided. Since only very few microbiosensors with applications in environmental and food systems have been published, enabling technology is also covered in this article.Abbreviations BOD biological oxygen demand - cfu colony forming units - DNP dinitrophenol - GFP green fluorescent protein - NASBA nucleic acid sequence-based amplification - PCR polymerase chain reaction - ppt parts per trillion - QCM quartz crystal microbalance - SPR surface plasmon resonance     

星形支化聚苯乙烯模型化合物的合成及表征

本文用阴离子聚合方法,首先合成了线形‘活’的聚苯乙烯大分子阴离子,然后用二乙烯基苯为偶联成核剂,制备了十三个4-80臂较窄分子量分布的等臂长规则星形支化聚苯乙烯的模型化合物,并用GPC—粘度计联用装置对之进行了表征。     

SYNTHESIS OF FUNCTIONAL MACROMOLECULE INTERMEDIATE THROUGH ACYLATION CATALYZED BY [Emim]Cl-AlCl3 IONIC LIQUID

Acylation reaction of anthracene with oxalyl chloride in the presence of [Emim]Cl-AlCl3 ionic liquid has been investigated. Pure 1,2-aceanthryenedione, which is used as intermediate of functional aromatic polymer material, was obtained by recrystalling the reaction mixture with aether and was determined by GC/MS, 1↑HNMR and FTIR analysis. The influences of various parameters, such as the contents of AlCl3 in [Emim]Cl-AlCl3, the amount of acylation agent, amount of [Emim]Cl-AlCl3, reaction temperature and reaction time were investigated. The optimum conditions were as follows： the molar fraction of AlCl3 in ionic liquid [x（AlCl3）] being 0.67, molar ratio of ionic liquid to anthracene being 2：1, molar ratio of oxalyl chloride to anthracene being 2：1, reaction temperature being 40℃ and reaction time being 6h. Under above conditions, the yield and selectivity of 1,2-aceanthrylenedione can reach 91.5% and 98.3% respectively. Further more, [Emim]Cl-AlCl3 ionic liquid, compared with metal halides such as AlCl3, was found to catalyze the reaction as a novel environmental friendly catalyst and solvent and can be reused.     

Optimization of an electrolytic conductivity detector for determination of toxic nitrogen-containing food contaminants separated by open tubular column gas chromatography

The combination of open tubular column gas chromatography with electrolytic conductivity detection has been evaluated for the determination of nitrogen-containing pesticide residues in food extracts. Optimization of the column position at the column-detector interface was crucial to the successful operation of the detector. The signal-to-noise ratio and response stability of the detector are greatly influenced by the composition of the electrolyte solvent. Large volume splitless injections using retention gaps and optimized detector operating conditions enabled pesticide residues in food extracts to be determined at sub parts-per-million levels. Although the electrolytic conductivity detector is less sensitive than the thermionic ionization detector, its greater nitrogen selectivity can he crucial to the determination of nitrogen-containing contaminants in food extracts, particularly in complex mixtures where phosphorus-containing contaminants or matrix compounds are also present.     

Synthesis and Structure of Environmentally Relevant Perfluorinated Sulfonamides

Alkylated perfluorooctanesulfonamides are compounds of environmental concern. To make these compounds available for environmental and toxicological studies, a series of N-alkylated perfluorooctanesulfonamides and structurally related compounds were synthesized by reaction of the corresponding perfluoroalkanesulfonyl fluoride with a suitable primary or secondary amine. Perfluoroalkanesulfonamidoethanols were obtained from the N-alkyl perfluoroalkanesulfonamides either by direct alkylation with bromoethanol or alkylation with acetic acid 2-bromo-ethyl ester followed by hydrolysis of the acetate. N-Alkyl perfluorooctanesulfonamidoacetates were synthesized in an analogous way by alkylation of N-alkyl perfluoroalkanesulfonamides with a bromo acetic acid ester, followed by basic ester hydrolysis. Alternatively, N-alkyl perfluoroalkanesulfonamides can be alkylated with an appropriate alcohol using the Mitsunobu reaction. Perfluorooctanesulfonamide was synthesized from the perfluorooctanesulfonyl fluoride via the azide by reduction with Zn/HCl. All perfluorooctanesulfonamides contained linear as well as branched C₈F₁₇ isomers, typically in a 10:1 to 30:1 ratio. The crystal structures of N-ethyl and N,N-diethyl perfluorooctanesulfonamide show that the S-N bond has considerable double bond character. This double bond character results in a significant rotational barrier around the S-N bond (ΔG^≠ = 62-71 kJ mol⁻¹) and a preferred solid state and solution conformation in which the N-alkyl groups are oriented opposite to the perfluorooctyl group to minimize steric crowding around the S-N bond.     

可注射型酶促高分子水凝胶的制备及表征

利用聚乙二醇（PEG，相对分子质量2 000）与对羟基苯丙酸（DAT）的酯化反应得到凝胶因子，在辣根过氧化物酶（HRP）和过氧化氢催化体系的作用下，制备了一种新型的能快速固化的可注射型水凝胶。研究了HRP、凝胶因子和过氧化氢浓度对凝胶时间的影响，结果表明，当凝胶因子浓度高、HRP浓度高、过氧化氢浓度较低时，凝胶时间较短，最短可在3 s内凝胶。采用红外光谱和核磁共振氢谱对凝胶因子的结构进行了表征，并提出了HRP/H2O2酶促催化下凝胶因子的自由基聚合机理。     

Secondary Formation of Aromatic Nitroderivatives of Environmental Concern: Photonitration Processes Triggered by the Photolysis of Nitrate and Nitrite Ions in Aqueous Solution

Aromatic nitroderivatives are compounds of considerable environmental concern, because some of them are phytotoxic (especially the nitrophenols, and particularly 2,4-dinitrophenol), others are mutagenic and potentially carcinogenic (e.g., the nitroderivatives of polycyclic aromatic hydrocarbons, such as 1-nitropyrene), and all of them absorb sunlight as components of the brown carbon. The latter has the potential to affect the climatic feedback of atmospheric aerosols. Most nitroderivatives are secondarily formed in the environment and, among their possible formation processes, photonitration upon irradiation of nitrate or nitrite is an important pathway that has periodically gained considerable attention. However, photonitration triggered by nitrate and nitrite is a very complex process, because the two ionic species under irradiation produce a wide range of nitrating agents (such as ^•NO₂, HNO₂, HOONO, and H₂OONO⁺), which are affected by pH and the presence of organic compounds and, in turn, deeply affect the nitration of aromatic precursors. Moreover, aromatic substrates can highly differ in their reactivity towards the various photogenerated species, thereby providing different behaviours towards photonitration. Despite the high complexity, it is possible to rationalise the different photonitration pathways in a coherent framework. In this context, this review paper has the goal of providing the reader with a guide on what to expect from the photonitration process under different conditions, how to study it, and how to determine which pathway(s) are prevailing in the formation of the observed nitroderivatives.     

Determination of 13C/12C-ratios of anthropogenic organic contaminants in river water samples by GC-irmMS

This study describes the application of a common analytical procedure adapted for compound-specific stable carbon isotope analyses of riverine contaminants. To evaluate the sensitivity of the analytical method and the precision of the isotopic data obtained, a set of numerous substances at different concentration levels were measured. For most of the anthropogenic contaminants investigated (including chlorinated aliphatics and aromatics, musk fragrances, phthalate-based plasticizers and tetrabutyl tin) acceptable carbon isotope analyses could be obtained down to amounts of approximately 5?ng absolutely applied to the gas chromatograph. These amounts correspond to concentrations in water samples at a natural abundance level of approximately 50–200?ng?L^?1 (low to medium contaminated river systems). However, it has to be considered that the precision and the sensitivity of the analytical method depend partially on the chemical properties of the substances measured. Five recovery experiments were conducted to assess changes in carbon isotope ratios during sample preparation and measurement. The compounds selected for these experiments are known riverine contaminants. Isotopic shifts or higher variations of the isotope ratios as a result of the analytical procedures applied were observed only for a couple of contaminants. Furthermore, compound-specific carbon isotope analyses were performed on eight water extracts of the Rhine river. By comparing the variation of the data of several individual compounds with the deviations obtained from the recovery experiments, it was possible to differentiate contaminants with unaffected isotope ratios and substances with significant alterations of the δ¹³C-values.