Formation of low-temperature deformation-induced segregations of nickel in Fe–Ni-based austenitic alloys

ABSTRACT

The authors present the results of an investigation in Fe–Ni-Cr austenitic alloys of the low-temperature deformation-induced segregations of nickel that form in the micro regions being (i) located close to grain- and subgrain boundaries and (ii) characteristic of the concentration and magnetic inhomogeneities indicated by the appearance of a dark diffraction contrast at the electron diffraction patterns taken from these regions typical (at the same time) of an enhanced value of Curie temperature. The observed effects were connected with the micro distortions caused by the local change of lattice parameter because of an increase in nickel concentration, as well as in the result of a magnetostriction dilatation. Using methods of the X-ray energy dispersive spectroscopy (XEDS) and atomic-probe body-section radiography (tomography – APT) has made it possible to determine the borders of those regions of austenite that were characteristic of an enhanced concentration of nickel in the fields of the localisation of a deformation-induced segregation of nickel in the vicinity of grain (subgrain) boundaries of austenitic alloys of the types Fe–13Cr–30Ni and Fe–37Ni–3Ti.     

ZnO nanowire lines and bundles: Template-deformation-guided alignment for patterned field-electron emitters

One-dimensional ZnO materials have been promising for field-emission (FE) application, but how to facially control the alignment of ZnO emitters is still a great challenge especially for patterned display application. Here, we report the fabrication of novel ZnO nanowire (NW) line and bundle arrays for patterned field-electron emitters. The effects of PS template size and heating time on the resulted ZnO nanoarrays were systematically studied. The deformation degree of PS templates was controlled and hence utilized to adjust the alignment of electrochemically deposited ZnO arrays. It was found that the length of NW lines and the density of NW bundles can effectively tuned by the PS template heating time. The optimal FE performance with turn-on electric field as low as of 4.4 V μm⁻¹ and the field-enhancement factor as high as of 1450 were achieved through decreasing the screening effect among the patterned field-electron emitters.     

Analysis of G/D/1 Queueing Systems with Inputs Satisfying Large Deviation Principle under Weak* Topology

The large deviation principle (LDP) which has been effectively used in queueing analysis is the sample path LDP, the LDP in a function space endowed with the uniform topology. Chang [5] has shown that in the discrete-time G/D/1 queueing system under the FIFO discipline, the departure process satisfies the sample path LDP if so does the arrival process. In this paper, we consider arrival processes satisfying the LDP in a space of measures endowed with the weak^* topology (Lynch and Sethuraman [12]) which holds under a weaker condition. It is shown that in the queueing system mentioned above, the departure processes still satisfies the sample path LDP. Our result thus covers arrival processes which can be ruled out in the work of Chang [5]. The result is then applied to obtain the exponential decay rate of the queue length probability in an intree network as was obtained by Chang [5], who considered the arrival process satisfying the sample path LDP.     

Large set of P3‐decompositions

Let G=(V(G),E(G)) be a graph. A (n,G, λ)‐GD is a partition of the edges of λK_n into subgraphs (G‐blocks), each of which is isomorphic to G. The (n,G,λ)‐GD is named as graph design for G or G‐decomposition. The large set of (n,G,λ)‐GD is denoted by (n,G,λ)‐LGD. In this work, we obtain the existence spectrum of (n,P₃,λ)‐LGD. © 2002 Wiley Periodicals, Inc. J Combin Designs 10: 151–159, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/jcd.10008     

On a bifurcation governed by hysteresis nonlinearity

We consider autonomous systems with a nonlinear part depending on a parameter and study Hopf bifurcations at infinity. The nonlinear part consists of the nonlinear functional term and the Prandtl--Ishlinskii hysteresis term. The linear part of the system has a special form such that the close-loop system can be considered as a hysteresis perturbation of a quasilinear Hamiltonian system. The Hamiltonian system has a continuum of arbitrarily large cycles for each value of the parameter. We present sufficient conditions for the existence of bifurcation points for the non-Hamiltonian system with hysteresis. These bifurcation points are determined by simple characteristics of the hysteresis nonlinearity.     

大口径宽视场双波段扫描红外相机光学设计

通过分析计算,设计了一种大口径宽视场折射式红外相机光学系统。该系统设计用于超长线阵扫描红外相机的地面演示成像,它能同时对短波2μm—3μm、中波3μm—4.5μm双波段成像,且同时具有24°的大视场和150mm的宽口径,成像质量接近衍射极限。该系统在航天遥感领域应用广泛。     

双奇核136La的集体带结构

通过重离子核反应与在束γ谱的实验技术, 对A=130缺中子核区的双奇核¹³⁶La的高自旋态进行了研究, 所用核反应为¹³⁰Te(¹¹B,5n). 实验结果扩展了¹³⁶La的能级纲图, 包括3个集体转动带, 最高自旋态达20h. 对于\uppi h_{11/2}\otimes \upnu h_{11/2}$~带, 观测到了旋称反转与集体回弯现象. 通过系统学比较, 对旋称反转特性进行了讨论. 由推转壳模型的计算指出, 此集体回弯是由一对中子的角动量顺排引起的. 另外两个集体带为具有~$\gamma\approx -60^\circ$~的扁椭形变带, 其可能的组态为: $\uppi h_{11/2}\otimes \upnu g_{7/2}h_{11/2}^2$~与~$\uppi g_{7/2}\otimes\upnu g_{7/2}^2 d_{5/2} h_{11/2}^2$.     

Stability and Nonlinear Deformation of Cylindrical Grids

The general stability of single-layer cylindrical grids is studied in linear and nonlinear formulations. Dependence of the general buckling load on the geometry and stiffness parameters of a grid is established in an analytical form. Such grids are numerically analyzed for stability. It is established that the general buckling load is much less than the local buckling load. Typical general buckling modes are found. It is shown that such grids are weakly sensitive to imperfections     

Numerical Prediction of the Strain State of Thermoset Matrix/Mineral Filler Composite Plates

The numerical prediction of the fields of inelastic strains (the linear invariant of the tensor of inelastic strains) in thermoset polyester/marble filler composite plates is discussed. A uniformly distributed load is applied to the plates, which lie on a steel base. The strain fields are predicted by means of the boundary element method by using creep test data for the composites and the polyester matrix itself. Identical creep tests were performed for two ages of the materials (1 month and 13 years), which allowed evaluating the aging effect. The study is carried out in two stages. At the first stage, the application of the generalized Maxwell-Gurevich equation to the thermoset matrix/mineral filler composite is demonstrated. The model parameters determined from the experimental creep data is used for the second stage, where the state of inelastic strains in the plates is predicted by applying the boundary element method. The influence of composite formulation (filler content) and physical aging of the polyester matrix on the state of inelastic strains in the plates is shown.__________Russian translation published in Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 145–156, March–April, 2005.     

Direct numerical simulation of settling of a large solid particle during bioconvection

Settling of a large solid particle in bioconvection flow caused by gyrotactic microorganisms is investigated. The particle is released from the top of the bioconvection chamber; its settling pattern depends on whether it is released in the centre of the bioconvection plume or at its periphery. The Chimera method is utilized; a subgrid is generated around a moving particle. The method suggested by Liu and Wang (Comput. Fluid 2004; 33 :223–255) is further developed to account for the presence of a moving boundary in the streamfunction‐vorticity formulation using the finite‐difference method. A number of cases for different release positions of the particle are computed. It is demonstrated that bioconvection can either accelerate or decelerate settling of the particle depending on the initial position of the particle relative to the plume centre. It is also shown that the particle impacts bioconvection plume by changing its shape and location in the chamber. Copyright © 2005 John Wiley & Sons, Ltd.