X光底片在位相对标定

本文描述了X光底片在位相对标定技术。其原理是使X射线谱经阶梯形吸收滤片透射后,对X光底片曝光,测量底片的曝光量。文中给出了标定方法和数据处理方法,而且也给出了在X光激光实验中得到的Kodak AA5底片的特性曲线。     

新颖的二维超分子化合物[CoⅢ(aea)(2,2''''-bipy)]Cl·H2O的水热合成及结构表征

0IntroductionInrecentyearsgreatattentionhasbeenpaidtosupramolecularchemistryandawidevarietyofnet鄄workshavealreadybeenconstructedbasedupontheprincipleofcrystalengineering[1~3].Usually,variousmultifunctionalorganicligands,bothrigidandflexiblemulticarboxyli…     

烯烃氢甲酰化催化剂活性物种的原位~1H NMR研究

有机磷配位铐或钴联基配合物是生产难或醇的工业催化剂，一般公认金属氢化物是反应的催化活性物种．通常反应活性物种仅存在干反应状态下，其结构表征非常困难，在许多研究中只能关联催化剂母体与其活性的关系［‘1；而未能揭示出催化的本质，给催化剂设计造成很大困难，因而对催化剂活性物种的直接表征受到普遍关注．B。wn问、Morrista］及本文作者研究组＊均采用加压原位红外光谱方法，在烯烃氢甲酸化反应条件下捕捉到HCO（CO）3L存在的信息·但用相同方法在反应条件下，在RhH键特征吸收谱带195O－2200Cm‘内未观测到错氢化物的Rh－…     

Hydride generation atomic absorption spectrometry with insitu graphite tube trapping for the determination of Se (IV) and Se (VI) in baltic sea water samples

This paper reports the results of an optimisation study for a procedure to determine the total selenium and its inorganic species, Se(IV) and Se(VI) using atomic absorption spectrometry combined with hydride generation and in-situ trapping of the analyte on the inner walls of the graphite tube. With the use of the proposed modification, a detection limit (3σ) of 0.018 ng/ml is achieved. This paper presents exemplary results, according to the proposed procedure, for selenium determination in samples of marine water. The concentrations of selenium in the samples ranged from <0.02 ng/ml to 0.16ng/ml of Se(IV) and from <0.02 ng/ml to 0.10 ng/ml of Se(VI).     

聚丙烯微孔膜基渐变聚合物的制备,结构与性能的研究

以聚丙烯微孔膜为基材，通过扩散控制原位共聚合的方法在人填充了组成沿膜的厚度方向逐渐改变的无规共聚物，Ｘ－光电子能谱（ＸＰＳ）、全反射红外光谱（ＡＴＲ）以及动态粘弹谱的分析结果。说明所制备得到的合膜具有明显的渐变聚合物性质。     

红外光谱法观察二茂镧系氯化物与氧及水蒸气的反应

用实时红外光谱法在特制的收池中分别观察了一些二茂镧系氯化物Ｃｐ２ＬｎＣｌ（Ｃｐ＝Ｃ５Ｈ５，Ｌｎ＝Ｈｏ，Ｇｄ，Ｌｕ）和Ｃｐ＇Ｌｕ（Ｃｐ＝Ｃ５Ｈ４ＣＨ２ＯＣＨ３）与干燥氧气及水蒸气的反应，结果证实这些二茂镧系配合物在室温干燥氧气氛中很稳定，但在水蒸气中很快水蒸气的反应，结果证实这些二茂镧系配合物在室温干燥氧气氛中很稳定，但在水蒸气中很快水解。从水解反应的最初始阶段和较后期采得的红外光谱提示可能存在...     

Rapid—In—situ Determination of Chromium （VI） in Water Using Modified Diphenylcarbazine with Citrate

In recent years, the determination of Cr (VI) has attracted great attention because of its toxicity to human, plants and animals1-5. Usually, in the industrial waste water, the concentration of Cr (VI) is relatively high and should be determined frequently. So, an accurate, quick, and convenient method for the measurement of Cr (VI) in environmental water, as well as in river, lake, sea and tap water, is of great importance. The method for determination of Cr (VI) by diphenylcarbazine …     

等离子体引发原位聚合制备凹凸棒土/聚苯乙烯纳米复合物

用阳离子表面活性剂处理凹凸棒土（Attapulgite),通过超声分散的方法将其均匀分散到苯乙烯单体中，并采用等离子体引发的方法制备出凹凸棒土／聚苯乙烯纳米复合物。通过透射电子显微镜（TEM）和X－射线衍射（XRD）观察了凹凸棒土及其纳米复合物的微观结构。对复合物的GPC测试表明，采用等离子体引发聚合反应可以显著提高树脂的分子量。XRD结果表明聚苯乙烯不是嵌入到凹凸棒土的层间，而是通过离子吸附接枝在凹凸棒土的棒状晶束上。     

烯烃氢甲酰化催化剂活性物种的原位1H NMR研究

The rhodium-phosphine complex catalyst Rh(CO)(acac)(PPh3)(Ⅰ) for 1-hexene hydroformylation was studied under the following reaction conditions: CO/H2=1(mole rate), pressure 1.0 MPa, temperature 25-120℃, by using the pressurized in-situ 1H NMR technique. Experimental results indicated that the formation of a rhodium hydride complex from (Ⅰ) began at room temperature and its amount increased with increasing of reaction temperature. This intermediate complex began to decompose at 100℃ and disapeared completely at 120℃. The intensity change of the proton signal was parallel to catalytical activity in hydroformylation of olefins. Under pure CO pressure the proton signal of Ph-H bond was not observed. There was a 0.2 ppm difference in proton chemical shifts of Rh-H bond under pure H2 pressure and under H2+CO pressure. The results showed that the rhodium-hydride carbonyl complex is the active intermediate in the industrial hydroformylation process.     

CoTPP电化学催化原溴代环己烷的机理

以电化学循环伏安、现场ＥＳＲ电化学以及现场薄层电化学方法研究了电生Ｃｏ（Ｉ）ＴＰＰ与溴代五己烷的反机制。在ＤＭＦ中，Ｃｏ（Ⅱ）／Ｃｏ（Ⅰ）的氧化还原有明显的催化溴代环己烷还原的特片，反现场有自由基生成，反应产物之一是Ｃｏ－Ｃ键化合物，可以在１．３０Ｖ（ＳＣＥ）－电子还原，当存在ＣＨ２－ＣＨＣＮ时，。生成另一种Ｃｏ－Ｃ键化合物，该化合物在－１．１０Ｖ（ＳＣＥ）处一电子还原，证明溴代环己烷与Ｃｏ（Ｉ）