SURFACE METALLIZATION OF CENOSPHERES AND PRECIPITATORS BY ELECTROLESS PLATING

This paper reports the use of a colloidal Pd^0 catalysis system to metallize the surface of precipitators separated from coal fly-ash, and metals such as Cu, Ni etc. are deposited on the precipitators surface. Alternatively, according to the characteristic surface of cenospheres, an Ag coating catalysis system is adopted to first deposit Ag on the cenospheres surface, followed, if necessary, by the deposition of other metals such as Cu, Ni, etc. on the Ag coating to produce monolayer and multilayer metal-coated cenospheres. The surface characteristics and the morphologies of the metal coatings are examined in detail with scanning electron microscopy (SEM), energy dispersive spectroscopy (EDX) and X-ray photoelectron spectroscopy (XPS) techniques. It can be shown that the quality of metal coatings derived from the Aa coatina catalysis system, is better than that of the colloidal Pd^0 catalysis system.     

Chemical Speciation of Amphoteric Ions on Semi‐Dry Scrubber Residue and Bag‐House Ash from MSWI

Two series of size‐fractionated combusted residues, a bag‐house ash and a scrubber residue, from a municipal solid waste incinerator (MSWI) were prepared and extracted by means of sequential chemical extraction (SCE) procedures proposed by Tessier. Concentrations of water‐soluble phase, exchangeable phase, carbonated phase, Fe/Mn oxide phase, organic matter phase, and residual phase bound amphoteric metals (Pb and Zn) were obtained, and have been compared with those of single batch extraction of toxic characteristic leaching procedure (TCLP). In each size fraction of baghouse ash or scrubber residue, lead or zinc shows a common phenomena that the TCLP value is always lower than the content of the water‐soluble fraction. For lead, baghouse ash has a significant size‐dependent distribution on the water‐soluble phase to perform a size‐dependent test of lead in the TCLP test. The zinc TCLP data having less size dependence might be due to that neither the baghouse ash nor the scrubber residue has a size‐dependent distribution on the water‐soluble zinc phase.     

Direct analysis of fly ash materials by inductively coupled plasma atomic emission spectrometry using slurry nebulization

Fly ash samples of cement works were analysed using slurry nebulization inductively coupled plasma atomic emission spectrometric (ICP-AES). Because of the influence of the experimental factors on the signal intensity, the optimal conditions of the analysis circumstances were determined. Control analyses (wet digestion followed by ICP-AES, and XRF of dry powders (pressed pellets)) were also carried out to compare the results. Based on the result, it was concluded that the slurry nebulization method using slurry standard of same type reference material for calibration can be applied for rapid but less precise (RSD 5–10%) determination of the elements in fly ash.     

Thermogravimetric analysis of the co-combustion of the blends with high ash coal and waste tyres

Incineration methods are becoming increasingly important from the view point of the need to minimize the environmental impact of waste tyre disposal. Combustion of waste tyre, one high ash coal and tyre-coal blends with 10, 30 and 50% waste tyre were investigated by means of thermogravimetric analysis (TGA) carried out at 20 K min⁻¹ in the temperature range from ambient temperature to 1273 K. And effects of the mixed proportion between coal and waste tyre on the combustion process, ignition and burnout characteristics were also studied. The results indicate that the combustion of waste tyre is controlled by the emission of volatile matter, the regions are more complex for waste tyre (three or more peaks) than for coal (one peak). Also as compared with the case of burning only high ash coal, the incorporation of waste tyre can improve the combustion characteristics of high ash coal, especially the ignition performance and the peak weight loss compared with the separate burning of waste tyre and coal. Moreover, comparisons of the TG-DTG profiles between experimental and calculational results, it is indicate that there is a comparatively important difference, the co-combustion characteristics is the coupling effect between waste tyre and coal. The data resulting also showed that the co-combustion of waste tyre and low quanlitied coal as fuel is feasible.     

粉煤灰与几种酸固相反应特性的表面分析

用扫描电镜．能量色散谱研究了粉煤灰与酸的固相反应过程中表面形貌和化学组成变化特性。室温下粉煤灰分别与HCI、HNO3、H2SO4、HCIO4固相反应后，表面产生直径20—200nm的结晶颗粒或晶柱。反应生成的水溶物结晶体的扫描电镜图像分别呈手指状、龟背形、蛛蛛状、蝙蝠态，分别为氯化铝铁混晶、硝酸铝铁混晶、硫酸铝铁混晶和高氯酸铝铁混晶。粉煤灰是硅、铝、铁等元素的氧化物聚集体，铁铝等氧化物主要分布在颗粒表面，氧化硅主要分布在颗粒内层。用少量酸进行固相反应这些氧化物聚集体可相互剥离，用H2SO4处理粉煤灰优先将铁铝氧化物转化成可溶性硫酸盐。     

Hydration behaviour of a lime-pozzolan cement containing MSW incinerator fly ash

A lime-pozzolan cement was used to make pastes containing different quantities of MSW fly ash. After setting, the pastes were cured in water at room temperature from 1 h to 260 days. The hydration characteristics and the nature of the hydration products of the various pastes were studied by simultaneous TG/DSC thermal analysis and X-ray diffractometry. The MSW fly ash was found to induce a slowing of the hydration process in lime-pozzolan pastes, and after some days an evident acceleration of hydration reactions occurred. Sulphate and chloride in the MSW fly ash yield hydration products forming a cementitious matrix.The author is grateful to D. Calabrese for assistance with the thermal and XRD analyses.     

Rice husk ash as an adsorbent for methylene blue—effect of ashing temperature

Utilization of one waste material to control pollution caused by another is of high significance in the remediation of environmental problems. Rice husk, an abundantly available agricultural waste, can be used as a low cost adsorbent for dyes and heavy metals in effluent streams. The possible utilization of rice husk ash as an adsorbent for methylene blue dye from aqueous solutions has been investigated. Ash samples from husks of two origins were prepared at different temperatures and their physical, chemical spectroscopic and morphological properties were determined. XRD, FTIR and SEM were some of the techniques adopted for the characterization. The samples were also analyzed for bulk density, pH, nitrogen adsorption properties and lime reactivity. Experiments of methylene blue adsorption on the ash samples were conducted using batch technique and a comparative study was made. Results were analyzed using linear, Langmuir and Freundlich isotherms. The values of separation factor indicate that most of the ash samples do adsorb the dye molecules, but in varying quantities. Calcination at 900^∘C reduces the adsorption capacity of the ash to a great extent. Regression analysis shows that the experimental data fits both Langmuir and Freundlich isotherms for certain concentration limits. The adsorbate species are most probably transported from the bulk of the solution into the solid phase through intra-particle diffusion process. Kinetics of adsorption was found to follow pseudo second order rate equation with R ²∼ 0.99. The highest adsorption capacity (Q ₀) achieved is found to be ∼690 mg/g, which is even higher than the values reported for activated carbon from rice husk. The adsorption capacity of the ash samples are in good agreement with their surface area and pore volume.     

Size-based analysis of incinerator fly ash using gravitational SPLITT fractionation, sedimentation field-flow fractionation, and inductively coupled plasma-atomic emission spectroscopy

Fly ash has been regarded as hazardous because of its high adsorption of toxic organic and/or inorganic pollutants. Fly ash is also known to have broad distributions of different chemical and physical properties, such as size and density. In this study, fly ash emitted from a solid waste incinerator was pre-fractionated into six sub-populations by use of gravitational SPLITT fractionation (GSF). The GSF fractions were then analyzed by sedimentation field-flow fractionation (SdFFF) and ICP–AES. SdFFF analysis showed the fly ash has a broad size distribution ranging from a few nanometers up to about 50 µm. SdFFF results were confirmed by electron microscopy. Inductively coupled plasma–atomic emission spectroscopy (ICP–AES) analysis of the GSF fractions showed the fly-ash particles contain a variety of inorganic elements including Ca, Si, Mg, Fe, and Pb. The most abundant in fly ash was Ca, followed by Si then Mg. No correlations were found between trace element concentration and particle size.     

粉煤灰空心微珠沸石化制备复合空心球

采用晶种静电吸附-诱导转化技术，成功地将选自工业废弃物粉煤灰的空心微 球转化为具有沸石/莫来石双层复合球壳结构的空心球，用XRD和SEM等手段对产物 进行了表征，并对球壳的转化机理进行了讨论。     

Effect of some additives on the reactions in fly ASH-Ca(OH)2 system

Differential thermal analysis and thermogravimetry were used to evaluate the effect of some additives, such as CaSO₄, CaCl₂ and silica fume amorphous silica from ferrosilicon synthesis on the mechanism and kinetics of reactions occurring in fly ash-Ca(OH)₂ system. The accelerating role of these additives was demonstrated from the data relating to Ca(OH)₂ consumption in hydrated pastes, determined by TG measurements. This revised version was published online in July 2006 with corrections to the Cover Date.