Study on deactivation and regeneration of Pd/Al2O3 catalyst in hydrogen peroxide production by the anthraquinone process

Deactivated palladium catalysts in the hydrogenation of anthraquinione were regenerated with ethanol, nitric acid, hydrogen peroxide, boiling water and steam, respectively. The deactivated and regenerated catalysts were characterized by XPS, ICP, TG, FTIR, TPD, XRD, etc., and studied in the hydrogenation of anthraquinone. The results showed that the main cause of catalyst deactivation is the coverage of the active component by deposits. The treatments by hydrogen peroxide and boiling water can effectively regenerate the deactivated catalysts. This revised version was published online in August 2006 with corrections to the Cover Date.     

Modification of a three-way catalyst washcoat by aging: A study along the longitudinal axis

This work reports the research carried out by studying aliquots extracted at different axial coordinates from Three Way Catalyst (TWC) monoliths aged under real traffic conditions. Our study focused on the catalytic properties and on several chemical and physical effects caused in the Front and Rear monolith washcoat surfaces by vehicle aging after 60,000 km. Regarding the catalytic properties, all the used aliquots showed poorer activity than their corresponding fresh counterparts. The strongest deactivation was detected for NO and hydrocarbon conversion. CO conversion was less affected and the Rear monolith was as deactivated as the Front one. The characterisation techniques (TXRF, N₂ adsorption-desorption isotherms, XRD and H₂-TPR) detected - (i) the deposition of P, Zn and Pb; (ii) the formation of CePO₄ on account of the Ce from the washcoat; (iii) thermal sintering; (iv) inhibition of the reducibility of Ce oxides - as the main effects brought about by vehicle aging conditions. The deactivation observed at the beginning of the Front monolith was the result of a combination of the former effects. When moving downstream to higher axial coordinates, Pb accumulation and the loss of specific area appeared to be the only probable sources of deactivation.     

苯与丙烯烷基化失活沸石催化剂氢再生机理

对工业中试用于苯与丙烯烷基化失活β－沸石改性催化剂进行了H2再生研究。通过对失活、新鲜和再生后催化剂的TPO、TPD、孔结构测定和活性评价以及失活和再生催化剂样品上炭组成的GC－MS分析，讨论了H2再生后催化剂催化性能的恢复状况。解释了虽然仍有部分炭未被除去，但酸性和活性恢复良好的原因。提出了本文体系失活催化剂H2再生过程的作用机理。     

催化裂化USY／ZnO／Al2O3脱硫添加剂的高温水热失活

 对USY／ZnO／Al2O3汽油催化裂化脱硫添加剂经高温水热老化处理前后的脱硫性能进行了考察，发现老化后添加剂的脱硫性能大幅度下降．采用XRD和IR等技术对USY／ZnO／Al2O3添加剂在高温和高温水热条件下失活的原因进行了研究．结果表明，在高温下，ZnO可与USY沸石中的铝发生固相反应生成ZnAl2O4尖晶石，从而造成USY晶体结构崩塌，转变成无定形状态．在ZnO含量较高的条件下，ZnO可继续与USY晶体结构崩塌后生成的无定形的硅和铝的氧化物反应，生成Zn2SiO4硅锌矿和ZnAl2O4尖晶石结构．这一方面使添加剂失去了可形成硫化物吸附中心的ZnO，另一方面破坏了硫化物的裂化活性组分USY，从而造成添加剂脱硫性能下降甚至失去脱硫活性．ZnO对USY的破坏作用主要与温度有关．在USY／ZnO／Al2O3体系中，ZnO被ZnO与Al2O3之间形成的锌铝尖晶石膜固定并与USY隔离，单纯的高温条件对添加剂的破坏不显著，而水蒸气可以促进ZnO的移动，有利于ZnO与USY的接触，因此在高温和有水蒸气存 在的条件下添加剂的结构易遭到破坏．     

催化燃烧去除VOCs污染物的最新进展

催化燃烧是目前最有效的处理挥发性有机物(VOCs)技术之一. 本文从催化剂活性组分、催化剂载体、有效组分颗粒大小、水蒸汽的影响及催化燃烧反应中的积碳等几个方面, 对近年来催化燃烧处理VOCs的研究进行了总结. 分析表明: 贵金属催化剂的研究主要着重于选择有效的载体和双组分贵金属催化剂; 非贵金属催化剂的研究主要集中在高活性的过渡金属复合氧化物、钙钛矿和尖晶石型等催化剂的研制, 还有这些活性组分粒径大小及载体对催化燃烧VOCs反应活性的影响;此外, 在实际应用中,水蒸汽和催化剂积碳失活等问题对催化燃烧VOCs的反应也有很大影响. 本文的评述将为选择合适的催化燃烧技术处理VOCs污染物提供一定参考.     

催化燃烧去除VOCs污染物的最新进展

催化燃烧是目前最有效的处理挥发性有机物(VOCs)技术之一. 本文从催化剂活性组分、催化剂载体、有效组分颗粒大小、水蒸汽的影响及催化燃烧反应中的积碳等几个方面, 对近年来催化燃烧处理VOCs的研究进行了总结. 分析表明: 贵金属催化剂的研究主要着重于选择有效的载体和双组分贵金属催化剂; 非贵金属催化剂的研究主要集中在高活性的过渡金属复合氧化物、钙钛矿和尖晶石型等催化剂的研制, 还有这些活性组分粒径大小及载体对催化燃烧VOCs反应活性的影响;此外, 在实际应用中,水蒸汽和催化剂积碳失活等问题对催化燃烧VOCs的反应也有很大影响. 本文的评述将为选择合适的催化燃烧技术处理VOCs污染物提供一定参考.     

Study of the influence of substituents on spectroscopic and photoelectric properties of zinc phthalocyanines

In this paper we describe conversion of light energy into electric energy in a photoelectrochemical cell containing zinc phthalocyanine (ZnPc) dyes. For all dyes investigated in liquid polyvinyl alcohol with dimethyl sulfoxide solution and located in the photoelectrochemical cell the following measurements have been done: absorption, fluorescence, photoacoustic spectra, photovoltaic spectra, kinetics of photocurrent and current–voltage characteristics. It has been shown that all dyes located in the photoelectrochemical cell are able to convert light into electric energy but with different effectiveness. The influence of substituted different peripheral groups to ZnPc core and the correlation between the molecular structure and effectiveness of solar to electric energy conversion were observed and described. The unique behavior of ZnPc substituted with fluorines was indicated.     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

Photovoltaic and spectral properties of tetraphenyloporphyrin and metallotetraphenyloporphyrin dyes

Spectroscopical properties and photocurrent (or photovoltage) of tetraphenyloporphyrins and metallotetraphenyloporphyrins in nematic liquid crystal have been studied. Photoelectric response has been measured in an electrochemical cell made of the semitransparent semiconducting and golden electrodes with porphyrin dyes embedded in liquid crystal. Fluorescence, time-resolved luminescence in microsecond time scale and photoacoustic spectra have also been measured. The competition between radiative, non-radiative processes and charge transfer is discussed. It has been shown that effectivity of porphyrins for photocurrent generation depends on the presence/absence of central metal in the macrocycle of porphyrin skeleton and the kind of metal. The schematic model of the contributions of the dye molecule and semiconducting electrode in the electron transfer process is shown.     

钯催化气相氧化羰基化合成碳酸二甲酯

通过催化剂反应性能和反应前后XPS谱图对比，分析了负载型钯催化剂在甲醇气相氧化羰基化合成碳酸二甲酯过程中的失活原因，研究了HCl在维持催化剂活性及失活催化剂再生中的作用．结果表明，氯离子的流失是负载型钯碳催化剂失活的主要原因．由于氯离子的流失，对于PdCl2／AC催化剂，钯很容易从二价变为零价：对于PdCl2-CuCl2／AC催化剂，CuCl2发生变化，失去使钯保持二价氯化物状态的功能．在反应过程中补充HCl可以延长催化剂的寿命，也可以利用HCl对失活催化剂进行再生，但采用HCl不能从根本上解决催化剂失活的问题．