Comparative absorption kinetics of seven active ingredients of Eucommia ulmoides extracts by intestinal in situ circulatory perfusion in normal and spontaneous hypertensive rats

Eucommia ulmoides Oliv. (E. ulmoides) is a valuable and nourishing medicinal herb in China that has been used in the treatment of hypertension. Given the fact that most traditional Chinese medicine is mainly used to treat disease, investigating the pharmacokinetics of traditional Chinese medicines in the pathological state is more useful than that in the normal state. However, the differences in the absorption kinetics of active ingredients of E. ulmoides extract between pathological and physiological conditions have not been reported. Therefore, in this study, the rat intestinal in situ circulatory perfusion model was used to investigate the differences in absorption kinetics of seven active ingredients of E. ulmoides extract in normal and spontaneously hypertensive rats, namely, genipinic acid, protocatechuic acid, neochlorogenic acid, chlorogenic acid, cryptochlorogenic acid, (+)-pinoresinol di-O-β-D -glucopyranoside and (+)-pinoresinol 4′-O-β-D -glucopyranoside. Our results indicate that the pathological state of spontaneous hypertension may change the absorption of active components of E. ulmoides extracts, and these findings may provide a reference for improving the rational use of E. ulmoides in the clinic.     

A RAPID APPROXIMATION FOR PREDICTING THE HYDROCARBON DISCOVERY RATE: PART 1. ASSESSING THE ACCURACY

The hydrocarbon discovery prediction problem is important to firms having to make decisions about the deployment of scarce exploration resources. Traditional methods for estimating the discovery rate rely on the completion of time consuming simulation experiments. A rapid approximation that does not require the completion of simulation exists and has been shown to have some promise as a prediction tool. This paper investigates the accuracy of the approximation method under a wide variety of distributional and drilling efficiency assumptions. The results indicate that the approximation produces predictions close to those of simulation under most of the tested conditions. This suggests that resource exploration firms could conveniently use the method for a wide variety of planning purposes without incurring the same costs in time and personnel required for simulation.     

土壤中酚的超声波提取

以合成土样为对象,研究了超声波辅助提取苯酚的条件及其提取效率。用中档超声波场辐射试样2×30s,30ml丙酮-正己烷(体积比1:1)分两次萃取10.0g合成土样中的苯酚,这时所获收率最高。在选定条件下用于实际土样分析,以索氏萃取4h的结果为对照基准,本方法的平均回收率为97.8％,RSD为1.5％。     

Production of carbon soot with a high content of C60 and C70 fullerenes by electric arc

The effect of the parameters of the electric arc (helium pressure, current and voltage, clearance between electrodes) and of the peculiarities of the setup design (arrangement of electrodes, distance between the arc and the cooling surface, temperature of the soot condensation surface) on the yield of fullerenes has been studied. Conditions for producing soot with a C₆₀ and C₇₀ content up to 43% (toluene extract) have been found.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 805–809, May, 1994.The authors are grateful to N. G. Spitsyna and A. V. Dubovitskii for the determination of the content of C₆₀ and C₇₀ fullerenes in the extract.The work was financially supported by the Russian Foundation for Basic Research (Project 93-03-18705).     

槲寄生蛋白注射液细胞毒活性测定的MTT方法探讨

采用MTT比色法对体外培养的肿瘤细胞进行细胞毒作用实验，验证槲寄生蛋白注射液体外抗肿瘤效果．并且鉴定这种检测方法的有效性。实验结果表明槲寄生蛋白注射液有一定的体外抗肿瘤效果；MTT比色法是一种可用的体外细胞毒作用检测法，为新药品的开发提供了实验依据。     

Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

Studies on mass production of transformed Panax ginseng hairy roots in bioreactor

The growth properties of Panax ginseng hairy roots transformed by Agrobacterium rhizogenes were compared between flask and aerated column or stirred bioreactor. In flask cultures, sucrose, initially 30 g/L, was nearly exhausted after 45 d of culture. The pH of the medium dropped from 5.5 to 4.96 after 10 d, but afterward it gradually increased to 6.4. After 45 d, hairy roots grew about 16-folds. The growth rate of hairy roots in air-bubble column or stirred bioreactor cultures was 1.13 (1.11) to 1.23 (1.20) g fresh wt (dry wt)/(g of cells·d), respectively. For both bioreactors, growth was about three times as high as in the flask cultivation.     

原油三维荧光分析中猝灭现象辨析

研究了原油的三维荧光猝灭现象，指出浓度过高是原油产生荧光猝灭的主要原因，将会造成三维荧光等值线图畸变，致使定量分析数据失真，谱图特征变异，难以获取原油特征三维指纹图。提出了避免荧光猝灭的预试方法，并列出了不同类型原油的最佳测试浓度。     

高富勒烯的提取,分离和分析

采用二硫化碳重结晶富勒烯混合物或二硫化碳二次抽提烟灰以提取高富勒烯（ｈｉｇｈｅｒｆｕｌｅｒｅｎｅｓ，Ｃｎ，ｎ＞７０）。产物经高效液相色谱分析，高富勒烯的含量从１％分别提高到４％和６％；经激光飞行时间质谱证明，产物中除含主要成分Ｃ６０和Ｃ７０以外，还含有Ｃ７６、Ｃ７８、Ｃ８２、Ｃ８４以及更高碳原子的富勒烯。     

Adsorption separation of terpene lactones from Ginkgo biloba L. extract using glass fiber membranes modified with octadecyltrichlorosilane

In this study porous glass fiber membranes were modified by reaction with octadecyl-trichlorosilane to form C18 hydrophobic membranes. The contact angle and the CH2 vibration bands at 2855 and 2920 cm(-1) found by FTIR measurements verified the successful immobilization of C18 groups on the glass fiber membranes. The resulting C18 hydrophobic membranes were used to adsorb terpene lactones from crude Ginkgo biloba L. extracts. In batch adsorption processes, the modified C18 membranes exhibited a better adsorption performance than commercial C18 solid phase extraction adsorbents. Different desorption solvents were tested and ethyl acetate was found to preferentially desorb terpene lactones from the modified C18 membranes. In flow adsorption experiments at 1 mL/min, terpene lactone contents higher than 6 wt% (the standardized content) could be achieved in the elution step using ethyl acetate.