钯作基体改进剂FIA－HG－GFAAS法测定锗及其机理研究

采用钯，钯－镁作基体改进剂，ＦＩＡ－ＨＧ－ＧＦＡＡＳ法成功地测定了锗。灵敏度、精密度和分析速度都得到很大的提高。峰值吸收的特征质量８．０ｐｇ，检出限１０．９ｐｇ，相对标准偏差０．３４％，同时探讨了基体改进剂钯的稳定作用机理及锗在石墨管中的原子化机理。     

Stabilization of valence fluctuations in the cerium solid by the time-dependent collision approach

The collision-generated hybridization which has been found responsible for the on-site mixing of the atomic-likef-state and the band-liked states in mixed valence solids has been studied for the cerium solid. A practical expression which depends on the lattice constant and temperature has been obtained for the collision-generated hybridization. Numerical calculations show that the valence varies continuously with lattice constant and that temperature makes the transition smoother. The collision-generated hybridization is found to be of significant strength in the intermediate valence regime; but over a wide range of the valence near 3.5 it varies rather slowly without preferring a particular valence. Factors which can assist the collision-generated hybridization in stabilizing the mixed valence phase at a particular lattice constant are discussed.     

Independence of the brittle–ductile transition from the rubber particle size for impact‐modified poly(vinyl chloride)

A series of acrylic impact modifiers (AIMs) with different particle sizes ranging from 55.2 to 927.0 nm were synthesized by seeded emulsion polymerization, and the effect of the particle size on the brittle–ductile transition of impact‐modified poly(vinyl chloride) (PVC) was investigated. For each AIM, a series of PVC/AIM blends with compositions of 6, 8, 10, 12, and 15 phr AIM in 100 phr PVC were prepared, and the Izod impact strengths of these blends were tested at 23 °C. For AIMs with particle sizes of 55.2, 59.8, 125.2, 243.2, and 341.1 nm, the blends fractured in the brittle mode when the concentration of AIM was lower than 10 phr, whereas the blends showed ductile fracture when the AIM concentration reached 10 phr. It was concluded that the brittle–ductile transition of the PVC/AIM blends was independent of the particle size in the range of 55.2–341.1 nm. When the particle size was greater than 341.1 nm, however, the brittle–ductile transition shifted to a higher AIM concentration with an increase in the particle size. Furthermore, the critical interparticle distance was found not to be the criterion of the brittle–ductile transition for the PVC/AIM blends. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 696–702, 2006     

石墨炉原子吸收光谱法直接测定血样中硒

用石墨炉原子吸收光谱法，以硝酸铜和硝酸铵为基体改进剂，塞曼效应扣背景，采用标准加入法可直接测定血样中硒，回收率为95％～105％，相对标准偏差为5．8％，检出限为96pg，测定结果准确可靠。     

氯化钠在球形纳米氧化铈形成过程中的作用

以水合碳酸铈为原料, 以氯化钠作为助磨剂和阻聚剂, 采用机械活化法制备了球形纳米氧化铈, 用XRD法研究了水合碳酸铈与氯化钠质量比、球磨时间、煅烧温度对CeO2粉体晶粒度的影响, 用TEM对最终产物粒子进行形貌观察. 结果表明: 在碳酸铈的球磨过程及其随后的煅烧过程中, 氯化钠的存在起到了很好的助磨和阻聚作用, 所得CeO2为类球形粒子, 分散性较好, 晶粒度约为30～50 nm.     

Trace elemental determination in alcohol automotive fuel by electrothermal atomic absorption spectrometry

Suitable analytical methodologies were developed allowing direct determination of As, Cu, Fe, Pb, Sb and Sn in alcohol fuel samples by electrothermal atomic absorption spectrometry. Different chemical modification approaches were tested and compared in terms of analytical performance and in practical terms. Experimental conditions were optimized allowing little sample dilution and use of calibration curves prepared with aqueous inorganic analyte standards. Methodologies were tested with analyte spiked alcohol samples. Good analyte recoveries from spiked alcohol samples, precision better than 10% and limits of detection in the sub μg l⁻¹ range were achieved.     

Aromatization of methane over different Mo-supported catalysts in the absence of oxygen

Both acidity and structure of the support are important factors in converting methane to aromatics. Lower SiO₂/Al₂O₃ ratio seems to favor the aromatization of methane over the Mo/HZSM-5 catalyst. When Pt is added as a modifier the activity of Mo/HZSM-5 catalyst will decrease slightly, but coke formation will enhanced.     

Electroreduction of cerium ions on silver electrode in halide melts at 973 K

The mechanism of electroreduction of cerium ions in equimolar KCl-NaCl melt is explored at 973 K. The effect of the anionic composition of the melt on the electroreduction of cerium ions is studied. It is shown that the electrodeposition of metal cerium from halide melts on a silver electrode is the primary electrochemical process that occurs at potentials more positive than those corresponding to the supporting-electrolyte decomposition. The electroreduction of chloride complexes of cerium on a silver electrode in the melt in both steady-and non-steady-state polarization modes at rates below V ≤ 0.5 V/s is limited by the diffusion delivery; at higher polarization rates, the charge-transfer stage predominates.     

二氧化铈还原表面上水煤气变换反应机理

采用原位红外，程序升温脱附，脉冲表面反应技术研究了ＣｅＯ２还原表面在中温变换反应条件下表面物种的生成及脱附，并根据研究结果归纳出水煤气变换反应机理。     

Fraktionierte Kristallisation von Ammonium- und Magnesiumdoppelnitraten der Ceriterden; Bestimmung der Trennfaktoren und Vergleich der Trennwirkung

Summary The Separation Factors for Pr/La, Nd/Pr, and Sm/Nd, characterizing the crystallization of ammonium and magnesium double nitrates under practical conditions, were determined analytically and are discussed. They confirm that La and Pr can be separated better by fractional crystallization of ammonium double nitrates, whereas in the presence of Sm the magnesium double nitrates are preferable.