“网格式平行线法”在螺纹参数测量中的应用

在计算机视觉理论基础上发展起来的视觉检测(vision inspection)技术具有非接触、速度快、精度适中、可实现在线等优点，已广泛地应用于工业产品的在线检测。在计算机视觉检测技术中CCD摄像机是一个最关键的器件，其参数是否准确决定了检测的精度。所以，摄像机标定是视觉检测技术中最基本的也是最重要的一步。在比较其他标定方法的基础上，为了解决传统标定方法对螺纹图像测量系统所带来的一系列问题，采用了一种新的图像测量系统的标定方法——网格式平行线标定方法，该方法运用了CCD亚像素细分技术及调焦技术，可直接得到纵横2个方向的像素，经过理论分析及实验结果均表明，采用该方法具有标定简单、精度高、重复性好等优点，是一种较好的螺纹图像测量系统标定方法。     

The Nonexistence of Procedures with Bounded Performance Characteristics in Certain Parametric Inference Problems

This paper gives a condition which implies the nonexistence of parametric statistical procedures with bounded risk or error performance characteristics. Many examples for which such a condition is satisfied are considered.     

Calorimeter energy calibration using the energy conservation law

A new calorimeter energy calibration method was developed for the proposed ILC detectors. The method uses the center-of-mass energy of the accelerator as the reference. It has been shown that using the energy conservation law it is possible to make ECAL and HCAL cross calibration to reach a good energy resolution for the simple calorimeter energy sum.      

江汉平原上空QTEC变化特征的统计分析

提出了一种观测台网用多接收机性能一致性的标定方法，并利用江汉平原GPS接收台网的观测数据，分析了该地区上空QTEC的日变化、季节变化、年变化和逐年变化的统计特征．标定结果表明，不同接收机之间的仪器偏差是从双频GPS卫星信标推算QTEC的主要误差来源之一，必须校正．统计分析证实，江汉平原上空QTEC的日变化特征同时受电离层和等离子层控制，其年变化以半年周期为主，峰值和谷值分别出现在两分点和两至点附近，QTEC值的逐年变化从太阳活动峰年到低年逐年下降，与以太阳黑子数为代表的太阳活动密切相关．     

Intercomparison of retrieval codes used for the analysis of high-resolution, ground-based FTIR measurements

A rigorous and systematic intercomparison of codes used for the retrieval of trace gas profiles from high-resolution ground-based solar absorption FTIR measurements is presented for the first time. Spectra were analyzed with the two widely used independent, retrieval codes: SFIT2 and PROFFIT9. Vertical profiles of O₃, HNO₃, HDO, and N₂O were derived from the same set of typical observed spectra. Analysis of O₃ was improved by using updated line parameters. It is shown that profiles and total column amounts are in excellent agreement, when similar constraints are applied, and that the resolution kernel matrices are also consistent. Owing to the limited altitude resolution of ground-based observations, the impact of the constraints on the solution is not negligible. It is shown that the results are also compatible for independently chosen constraints. Perspectives for refined constraints are discussed. It can be concluded that the error budget introduced by the radiative transfer code and the retrieval algorithm on total columns deduced from high-resolution ground-based solar FTIR spectra is below 1%.     

An implicit characteristic-flux-averaging method for the euler equations for real gases

A formulation of an implicit characteristic-flux-averaging method for the unsteady Euler equations with real gas effects is presented. Incorporation of a real gas into a general equation of state is achieved by considering the pressure as a function of density and specific internal energy. The Ricmann solver as well as the flux-split algorithm are modified by introducing the pressure derivatives with respect to density and internal energy. Expressions for calculating the values of the flow variables for a real gas at the cell faces are derived. The Jacobian matrices and the eigenvectors are defined for a general equation of state. The solution of the system of equations is obtained by using a mesh-sequencing method for acceleration of the convergence. Finally, a test case for a simple form of equation of state displays the differences from the corresponding solution for an ideal gas.     

响应矩阵分析方法在BEPC储存环上的应用

由于储存环中各种元件误差的存在, 机器的实际运行模式与设计模式有一定的偏差. 目前广泛开展的响应矩阵方法研究, 可以分析出磁铁元件以及束流位置测量元件的误差, 使束流基本参数得到校正. 介绍了用响应矩阵分析方法, 在BEPC储存环上进行的局部轨道校正的实验研究, 以及BEPC储存环束流参数校正的模拟研究.     

X光底片在位相对标定

本文描述了X光底片在位相对标定技术。其原理是使X射线谱经阶梯形吸收滤片透射后,对X光底片曝光,测量底片的曝光量。文中给出了标定方法和数据处理方法,而且也给出了在X光激光实验中得到的Kodak AA5底片的特性曲线。     

用最小电离的质子刻度铅–闪烁光纤夹层电磁量能器

研究利用最小电离的质子和已知能量的电子来刻度铅–闪烁光纤夹层电磁量能器.对最小电离粒子输出响应进行光纤衰减修正后,利用最小电离质子的输出响应对量能器测量单元进行标定,然后对不同入射能量的电子事例进行能量重建,重建能量与入射能量有很好的线性关系.本文还对最小电离的质子与μ子对量能器测量单元的输出响应进行了比较,发现二者在误差范围内是一致的.