Heterochain model for simultaneous long‐chain branching and crosslinking. III. Multicomponent polymerization

The matrix formula developed in the context of heterochain theory, M?_w = M?_wp + WF ( I ? M )^?1 S , was applied to describe the molecular weight development during free‐radical multicomponent polymerization. All of the required probabilistic parameters are expressed in terms of the kinetic‐rate constants and the various concentrations associated with them. In free‐radical polymerization, the number of heterochain types, N, needs to be extrapolated to infinity, and such extrapolation is conducted with only three different N values. This matrix formula can be used as a benchmark test if other approximate approaches can give reasonable estimates of the weight‐average molecular weights. The moment equations with the average pseudo‐kinetic‐rate constants for branching and crosslinking reactions may provide poor estimates when the copolymer composition drift during polymerization is very significant. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2801–2812, 2004     

Synthesis of MgAl2O4 Spinel Nanometer Powder via Biology Polysaccharide Assisted Sol-Gel Process

A novel and cost-effective sol-gel process for preparation of MgAl₂O₄ spinel nanometer powders has been developed in this study. A solution of magnesium and aluminum nitrates in stoichiometric proportion was successfully embraced in the biology polysaccharide gel network, formed by the synergistic interaction between xanthan gum (XG) and locust bean gum (LBG) utilizing their broad-spectrum stability of salt tolerance and character of transformation from sol to gel on the condition of proper temperature and relative proportion of polymeric components. Dry gel could be obtained by vacuum dehydration of aqueous gel at low temperatures. Monolithic MgAl₂O₄ spinel nanometer powders were produced by calcining the dry gel above 800°C, with average crystallite size of 20 nanometers.     

Chemically modified proton‐conducting membranes based on sulfonated polyimides: Improved water stability and fuel‐cell performance

A series of branched/crosslinked sulfonated polyimide (B/C‐SPI) membranes were prepared and evaluated as proton‐conducting ionomers based on the new concept of in situ crosslinking from sulfonated polyimide (SPI) oligomers and triamine monomers. Chemical branching and crosslinking in SPI oligomers with 1,3,5‐tris(4‐aminophenoxy)benzene as a crosslinker gave the polymer membranes very good water stability and mechanical properties under an accelerated aging treatment in water at 130 °C, despite their high ion‐exchange capacity (2.2–2.6 mequiv g^?1). The resulting polymer electrolytes displayed high proton conductivities of 0.2–0.3 S cm^?1 at 120 °C in water and reasonably high conductivities of 0.02–0.03 S cm^?1 at 50% relative humidity. In a single H₂/O₂ fuel‐cell system at 90 °C, they exhibited high fuel‐cell performances comparable to those of Nafion 112. The B/C‐SPI membranes also displayed good performances in a direct methanol fuel cell with methanol concentrations as high as 50 wt % that were superior to those of Nafion 112. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3751–3762, 2006     

玉米芯水溶性多糖的分离纯化和抗凝血活性研究

从玉米芯中提取到水提水溶性粗多糖,通过乙醇分级、冻融、凝胶过滤层析,生物测定导向等手段,分离到一种能延长体外凝血时间,而且具有外源抗凝血功能的多糖CCⅢ.CCⅢ对活化部分凝血酶原时间(APTT)无显著影响,但可显著延长体外抗凝血时间(PT).将CCⅢ纯化,经糖组成分析、甲基化、高碘酸氧化、Smith降解和GC-MS分析,确定该多糖结构为:β-(1→4)Glc,(1→3)Xyl构成主链,Glc在6-O处有分枝.平均每10个糖残基有1个分枝,支链由β-(1→3)Xyl,(1→3)Glc构成.     

榆耳水溶性多糖的结构特征

用3%三氯醋酸从榆耳子实体中提取出水溶性粗多糖,经乙醇分级、SepharoseCL6B纯化得到单一组分GIA.SepharoseCL6B柱层析测得GIA的相对分子质量为1 26×105.GC分析表明GIA由Man和Glc两种单糖构成,其物质的量比为1 42∶1.多糖GIA经部分酸水解、高碘酸氧化、Smith降解和甲基化分析其结构主要为β(1→3)Man和β(1→3)Glc,且在6～0处构成分枝结构,平均每11个己糖残基有2个分枝,多糖GIA的支链部分由(1→4)Glc构成,末端残基为Man,Glc.     

Thermodynamics of mixtures of hexane and heptane isomers with normal and branched hexadecane

Molar excess mixing enthalpies h ^E , Gibbs free energies g ^E and hence entropies s ^E have been obtained using calorimetry and the vapor sorption method at 25°C for hexane isomers+2,2,4,4,6,8,8-heptamethylnonane, a highly branched C ₁₆ . The h ^E and g ^E are negative while Ts ^E are positive, but small. The values are explained by the Prigogine-Flory theory through negative free volume contributions to h ^E and Ts ^E , counterbalanced in the case of Ts ^E by the positive combinatiorial Ts ^E for mixing molecules of different size. No contribution is seen from the interaction between methyl and methylene groups. The excess quantities are also obtained for hexane and heptane isomers mixed with n-hexadecane. Values of h ^E and Ts ^E are now strongly positive, while those of g ^E are only slightly less negative. The interpretation requires two recently advanced contributions in addition to those of the Prigogine-Flory theory: 1) a decrease of order when correlations of orientations between n-C ₁₆ molecules in the pure liquid are replaced in the solution by weaker correlations whose strengths depend on the shapes of the lower alkane isomers. For lower alkane isomers of the same shape, but highly sterically hindered, h ^E and Ts ^E are small, manifesting, 2) a negative contribution, ascribed to a rotational ordering of n-C ₁₆ segments on the sterically-hindered molecule. Enthalpy-entropy compensation is observed for these new contributions, arising from their rapid fall-off with increase of temperature.     

Free‐volume variation in polyethylenes of different crystallinities: Positron lifetime,density, and X‐ray studies

High‐quality positron lifetime measurements (70 million total counts) are reported for polyethylenes (PEs) of different crystallinities (X_c = 3–82%). The specific volumes of the crystalline and amorphous phases (V_c and V_a, respectively) were estimated from density and wide‐angle X‐ray scattering (WAXS) experiments. Some samples (those with low values of X_c) were branched PEs, and those with high values of X_c were linear PEs for which X_c was varied with changes in the crystallization temperature. Both V_c and V_a increase with decreasing X_c in the range 0% ≤ X_c ≤ 56% (the branched PEs) but are constant for X_c ≥ 56% (the linear PEs). The lifetime spectra were analyzed with the MELT and LIFSPECFIT routines. Artifacts that can appear in the spectrum analysis were checked via an analysis of computer‐generated spectra. Four lifetime components appeared in all of the PEs; the two long‐lived ones are attributed to pick‐off annihilation of ortho‐positronium (o‐Ps) in crystalline regions (τ₃) and in holes of the amorphous phase (τ₄). With increasing X_c, τ₃ decreases from about 1.2 to 1 ns, τ₄ decreases from 3.0 to 2.5 ns, and the intensity I₄ decreases from 29 to 0%. An increase in I₃ from 6 to 12% was observed. A comparison with simulations shows that the true I₃ value approaches 0 for X_c → 0%. The decrease in I₄ is weaker than the increase in X_c; this leads to the conclusion that the apparent specific o‐Ps yield in the amorphous phase I₄^Xc increases with X_c. Possible reasons for this surprising results are discussed. The fractional free hole volume [h = (V_a ? V_occ)/V_a, where V_occ is the crystalline occupied volume] was estimated from density and WAXS results. Between X_c = 0 and 56%, h decreases from 0.151 to 0.090, but it does not change further above X_c = 56%. The mean size (v) of the local free volumes (holes) estimated from τ₄ decreases from 200 to 150 ų. The number density of holes (N_h) calculated from these values (N_h = h/v) also decreases from 0.8 to 0.6 nm^?3 in the range 0% ≤ X_c ≤ 56%. The values of V_a, V_c, h, and N_h increase with an increasing degree of branching but do not vary for linear PEs. The possible influence of a crystalline–amorphous interfacial phase (three‐phase model) on the observed lifetime parameters is also discussed. © 2001 John Wiley & Sons, Inc. J Polym Sci Part B: Polym Phys 40: 65–81, 2002     

Effect of Coconut Protein and Xanthan Gum,Soybean Polysaccharide and Gelatin Interactions in Oil-Water Interface

We report on our study of the interactions between coconut protein extracted from coconut meat and three hydrocolloids (gelatin, xanthan gum, and soybean polysaccharide) and their interfacial adsorption and emulsification properties. We used Zeta potential, fluorescence spectroscopy scanning and ITC to investigate the interactions between a fixed concentration (1%) of coconut protein and varying concentrations of hydrocolloid. Through the interfacial tension and interfacial viscoelasticity, the interfacial properties of the hydrocolloid and coconut protein composite solution were explored. The physical stability of the corresponding emulsion is predicted through microstructure and stability analysis. Xanthan gum forms a flocculent complex with coconut protein under acidic conditions. Soy polysaccharides specifically bind to coconut protein. Under acidic conditions, this complex is stabilized through the steric hindrance of soy polysaccharides. Due to gelatin-coconut protein interactions, the isoelectric point of this complex changes. The interfacial tension results show that as time increases, the interfacial tensions of the three composite solutions decrease. The increase in the concentration of xanthan gum makes the interfacial tension decrease first and then increase. The addition of soybean polysaccharides reduces the interfacial tension of coconut protein. The addition of xanthan gum forms a stronger elastic interface film. Emulsion characterization showed that the gelatin-added system showed better stability. However, the addition of xanthan gum caused stratification quickly, and the addition of soybean polysaccharides also led to instability because the addition of polysaccharides led to a decrease in thermodynamic compatibility. This research lays the foundation for future research into coconut milk production technology.     

Alternative Approach to an AB2 Monomer for Hyperbranched Poly(Arylene Ether Ketone Imide)s

An alternative approach to an AB₂ monomer, N‐[3,5‐bis(4‐hydroxybenzoyl)benzene]‐4‐fluorophthalimde, 4, for hyperbranched poly(arylene ether ketone imide)s has been developed. The key steps were a para‐position selective electrophilic aromatic substitution of fluorobenzene with 5‐nitroisophthaloyl dichloride and a subsequent clean conversion of the aryl fluorides to phenol groups using potassium hydroxide as the nucleophile. The overall yield for the synthesis of 4 was 51.6%.     

Visualization of arborescent architecture of polystyrenes prepared by raft‐based initiator‐monomer polymerization using atomic force microscopy

This article presents the utilization of “molecular amplification” to visualize the molecular architecture of “arborescent” (tree‐like) polystyrenes (arbPSs) using atomic force microscopy (AFM). arbPSs with M_n > 80,000 g/mol were synthesized via initiator‐monomer‐type (inimer) RAFT polymerization of styrene mediated by 4‐vinylbenzyl dithiobenzoate in bulk. These arbPS were then used as macrochain transfer agents for polymerization of vinylbenzyl chloride (VBCl) to give arborescent poly(styrene‐block‐vinylbenzyl chloride) (arbPS‐b‐VBCl). Poly(styryl) diphenylethyl lithium (M_n = 11,000 g/mol) was then grafted onto the VBCl units of the arbPS‐b‐VBCl. The M_n of the amplified arbPSs increased over >10 million g/mol, exceeding the exclusion limit of our size exclusion chromatography equipment. AFM confirmed the proposed branches on branches architecture in the samples, together with lesser branched species. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012