A technical review of face mask wearing in preventing respiratory COVID-19 transmission

Since the outbreak of the COVID-19 pandemic, most countries have recommended their citizens to adopt social distance, hand hygiene, and face mask wearing. However, wearing face masks has not been well adopted by many citizens. While the reasons are complex, there is a general perception that the evidence to support face mask wearing is lacking, especially for the general public in a community setting. Face mask wearing can block or filter airborne virus-carrying particles through the working of colloid and interface science. This paper assesses current knowledge behind the design and functioning of face masks by reviewing the selection of materials, mask specifications, relevant laboratory tests, and respiratory virus transmission trials, with an overview of future development of reusable masks for the general public. This review highlights the effectiveness of face mask wearing in the prevention of COVID-19 infection.     

Bimetallic Covalent Organic Frameworks for Constructing Multifunctional Electrocatalyst

Covalent organic frameworks (COFs) are a new class of crystalline porous polymers comprised mainly of carbon atoms, and are versatile for the integration of heteroatoms such as B, O, and N into the skeletons. The designable structure and abundant composition render COFs useful as precursors for heteroatom-doped porous carbons for energy storage and conversion. Herein, we describe a multifunctional electrochemical catalyst obtained through pyrolysis of a bimetallic COF. The catalyst possesses hierarchical pores and abundant iron and cobalt nanoparticles embedded with standing carbon layers. By integrating these features, the catalyst exhibits excellent electrochemical catalytic activity in the oxygen reduction reaction (ORR), with a 50 mV positive half-wave potential, a higher limited diffusion current density, and a much smaller Tafel slope than a Pt-C catalyst. Moreover, the catalyst displays superior electrochemical performance toward the hydrogen evolution reaction (HER), with overpotentials of −0.26 V and −0.33 V in acidic and alkaline aqueous solution, respectively, at a current density of 10 mA cm⁻². The overpotential in the catalysis of the oxygen evolution reaction (OER) was 1.59 V at the same current density.     

Transport of Neutrally Buoyant and Dense Variably Sized Colloids in a Two-Dimensional Fracture with Anisotropic Aperture

The transport of monodisperse as well as polydisperse colloid suspensions in a two-dimensional, water saturated fracture with spatially variable and anisotropic aperture is investigated with a particle tracking model. Both neutrally buoyant and dense colloid suspensions are considered. Although flow and transport in fractured subsurface formations have been studied extensively by numerous investigators, the transport of dense, polydisperse colloid suspensions in a fracture with spatially variable and anisotropic aperture has not been previously explored. Simulated snapshots and breakthrough curves of ensemble averages of several realizations of a log-normally distributed aperture field show that polydisperse colloids exhibit greater spreading than monodisperse colloids, and dense colloids show greater retardation than neutrally buoyant colloids. Moreover, it is demonstrated that aperture anisotropy oriented along the flow direction substantially increases colloid spreading; whereas, aperture anisotropy oriented transverse to the flow direction retards colloid movement.     

Magnetic poly(N‐isopropylacrylamide) microspheres by dispersion and inverse emulsion polymerization

The aim of this study was to develop novel thermally responsive polymer microspheres with magnetic properties. Dispersion and inverse emulsion copolymerization of N‐isopropylacrylamide (NIPAAm) and N,N′‐methylenebisacrylamide (MBAAm) was investigated in the presence of γ‐Fe₂O₃ nanoparticles. The resulting microspheres were characterized in terms of morphology, size, polydispersity, iron content, and temperature‐dependent swelling using optical microscopy, transmission electron microscopy, scanning electron microscopy, QELS, and AAS. The effects of several variables, such as the concentration of γ‐Fe₂O₃, MBAAm crosslinking agent, Span 80 surfactant, 2,2′‐azobis(2‐methyloctanenitrile) (AMON) initiator, and polymerization temperature on the properties of the microspheres were studied. Swelling and thermoresponsive behavior of the microspheres containing γ‐Fe₂O₃ nanoparticles were also investigated. The microspheres contained about 8 wt % of iron. The presence of magnetic nanoparticles and their concentration changes did not have any significant effect on the temperature sensitivity of the composites. The particles gradually shrink into an increasingly collapsed state when the temperature is raised to 40 °C since the increase in temperature weakens the hydration and PNIPAAm chains gradually become more hydrophobic, which leads to the collapse of the particles. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5884–5898, 2007     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

Effects of Polymer Bridging and Electrostatics on the Rheological Behavior of Aqueous Colloidal Dispersions†

Effects of a low molecular weight physically adsorbed polyethylene oxide (PEO) and the range of the electrostatic repulsion on the rheological behavior of silica dispersions (as a model system) has been investigated. Particular attention is given to the evolution of the rheological behavior with increasing the polymer concentration in the system and also effectiveness of the polymer as a dispersant under extreme conditions (high ionic strength). Results indicate that at small separation distances and low polymer coverage, the polymer chains are long enough to adsorb on the surface of two particles simultaneously causing bridging flocculation in the system and hence increasing the viscosity and linear viscoelastic functions of the dispersion. A significant increase was observed in the viscosity of the dispersion at salt concentrations high enough to eliminate electrostatics between the particles. Under these conditions,the viscosity of the system increased significantly when PEO was added to the dispersion showing that at high electrolyte concentrations, a neutral polymer such as PEO is not able to stabilize the system.     

Nitroxide‐mediated radical polymerization in miniemulsion: Bimolecular termination in monomer‐free model systems

Bimolecular termination in nitroxide‐mediated radical polymerization in miniemulsion has been investigated through the heating of a polystyrene–2,2,6,6‐tetramethylpiperidinyl‐1‐oxy macroinitiator and its 4‐hydroxy‐2,2,6,6‐tetramethylpiperidinyl‐1‐oxy analogue in an aqueous toluene dispersion with sodium dodecyl benzenesulfonate as a surfactant at 125 °C. The level of bimolecular termination by combination, evaluated from the high‐molecular‐weight shoulder, was higher in miniemulsion than in solution and increased with decreasing particle size. Quantitative analysis revealed that these results cannot be rationalized solely by nitroxide partitioning to the aqueous phase. The results are explained by an interface effect, by which nitroxide is adsorbed or located at the aqueous–organic interface. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4995–5004, 2007     

Solvothermal Synthesis of Molybdenum Disulfide Hollow Spheres Modified by Cyanex 301 in Water–Ethanol Medium

Hollow spherical molybdenum disulfide has been successfully synthesized via a solvothermal method using Cyanex 301 as sulfur source and modification agent. The hollow spheres are characterized by transmission electron microscopy, scanning electron microscopy, X-ray diffraction and Energy-Dispersive X-ray analysis. The influences of reaction conditions are also discussed while a mechanism is proposed to explain the formation of the peculiar morphology.     

Magnetic silica colloids for catalysis

Monodisperse magnetizable colloidal silica particles in a stable dispersion have been functionalized with a homogeneous catalyst: a PCP–pincer Pd-complex. In a proof-of-principle experiment we demonstrate the catalytic activity of the colloids in a C–C bond formation reaction. Advantages of the magnetic silica carriers are the large surface-to-volume ratio and the easy recovery by magnetic separation. After magnetic separation, the catalyst-loaded particles are readily redispersed for further use.