Wide‐angle X‐ray diffraction and differential scanning calorimetry study of the crystallization of poly(ethylene naphthalate), poly(butylene naphthalate), and their copolymers

The crystallization behavior of a series of poly(ethylene‐co‐butylene naphthalate) (PEBN) random copolymers was studied. Wide‐angle X‐ray diffraction (WAXD) patterns showed that the crystallization of these copolymers could occur over the entire range of compositions. This resulted in the formation of poly(ethylene naphthalate) or poly(butylene naphthalate) crystals, depending on the composition of the copolymers. Sharp diffraction peaks were observed, except for 50/50 PEBN. Eutectic behavior was also observed. This showed isodimorphic cocrystallization of the PEBN copolymers. The variation of the enthalpy of fusion of the copolymers with the composition was estimated. The isothermal and nonisothermal crystallization kinetics were studied. The crystallization rates were found to decrease as the comonomer unit content increased. The tensile properties were also measured and were found to decrease as the butylene naphthalate content of the copolymers increased. For initially amorphous specimens, orientation was proved by WAXD patterns after drawing, but no crystalline reflections were observed. However, the fast crystallization of drawn specimens occurred when they were heated above the glass‐transition temperature. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 843–860, 2004     

Rheooptical investigation of the crystallization of poly(ethylene terephthalate) under tensile strain

The crystallization of poly(ethylene terephthalate) under uniaxial tensile strain at different extension rates was investigated with optical polarimetry in a temperature range between the glass-transition temperature and the quiescent crystallization temperature. The evolution of the optical properties of the polymer, including the turbidity, birefringence, and dichroism, were monitored simultaneously with the mechanical parameters. To complete the semicrystalline microstructure characterization of the polymer under strain, an online wide-angle X-ray diffraction (WAXD) technique was used in separate experiments, which were performed under the same thermomechanical conditions. For real-time measurements, a high-energy synchrotron radiation source was used. The optical properties provided information about both the crystalline and amorphous phases, whereas the WAXD patterns essentially gave information about the crystalline phase. The two experimental techniques were then used in a complementary way to characterize the semicrystalline microstructure. Significant deviations from the stress-optical rule were found. This was attributed to both transient effects and the appearance of crystallites, which consisted of highly oriented molecular segments that could contribute to the optical anisotropy but not necessarily to the stress. The behavior of the optical dichroism was found to be qualitatively different from that of the birefringence. The latter monotonically increased with the strain, whereas the former first increased with the strain, passed through a maximum, and then decreased to a steady-state value. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1915–1927, 2004     

Time-resolved synchrotron X-ray study of crystalline phase transition in poly(aryl ether ketone ketone) containing alternated terephthalic/isophthalic moieties

Unique crystallization and melting behavior in poly(aryl ether ketone ketone) containing alternated terephthalic and isophthalic moieties were studied by time-resolved synchrotron x-ray methods. Recently, this material has been shown to exhibit three polymorphs (forms I, II, and III). In this work, we further investigated their distinctive thermal properties and found that form I is the dominating and the most thermally stable phase while form II is favored by fast nucleation conditions and is the least stable phase. On the other hand, form III represents a minor intermediate phase that usually coexists with form I and can be transferred from form II and to form I. Structural and morphological changes in form I have been followed by simultaneous wide-angle x-ray diffraction (WAXD)/small-angle x-ray scattering (SAXS) measurements during cold- or melt-crystallization and subsequent melting. In all cases, a larger dimensional change was found in the crystallographic a-axis than the b-axis during heating and cooling. This may be due to the greater lateral stress variation with respect to temperature along the a direction of the primary lamellae which is induced by either the formation of secondary lamellae or the preferential chain-folding direction in poly(aryl ether ketone ketone)s. During the phase transitions of form II ← III in the cold-crystallized specimen and form III ← I in the melt-crystallized samples, lamellar variables (long period, lamellar thickness, and invariant) obtained from SAXS remain almost constant. This indicates that the density distribution in the long spacing is independent of the melting in form II or III. For melt-crystallization, the corresponding changes in unit-cell dimensions and lamellar morphology during the annealing-induced low endotherm are most consistent with the argument that these changes are due to the melting of thin lamellar population. © 1995 John Wiley & Sons, Inc.     

聚乙烯与聚乙烯-乙丙橡胶(聚乙烯-乙丙橡胶-聚乙烯)共混物X-射线衍射谱分析

近年来将因子分析这一多变量统计分析技术成功地用于具有加和性的谱分析中。因子分析法可正确定出混合物中含有的物种(因子)数和各物种的含量(浓度),同时可将各组分的纯光谱由混合物的光谱中分离开。聚乙烯(PE)和乙丙橡胶(EPR)的二、三元嵌段共聚物(PE-EPR、PE-EPR-PE)构成的共混物结构、形态与结晶过程研究已有     

Study of the Crystallization of an Aromatic Poly-ether-ketone (PK99) by Calorimetric and X-ray Analysis

An analysis of the crystallization behaviour of a new poly(aryl-ether-ether-ketone-ketone), PK99, by differential scanning calorimetry (DSC) and wide-angle X-ray diffraction (WAXD) is presented. Isothermal crystallization TG were obtained in the whole range between the glass transition temperature (T _g) and the melting temperature (T _m) as a consequence of the slow crystallization kinetics stemming from the closeness of these transitions. The calorimetric results, compared with WAXD data, were applied to determine the theoretical melting temperature and crystallization enthalpy. The DSC and WAXD data were combined in order to calculate the total amount of the crystallizable fraction of the polymer, and a model was proposed to explain the difference between the fractions of crystallinity observed with these techniques. The thermal and X-ray data were also correlated with different lamellar morphologies arising from the crystallization conditions. Finally, DSC experiments on the crystallized sample were used to detect the presence of a rigid amorphous phase which does not relax at T _g. This revised version was published online in July 2006 with corrections to the Cover Date.     

PEO／PBHE共混体系X射线散射研究

在聚环氧乙烷(PEO)/聚双酚A羟基醚(PBHE)共混体系中PEO是一个强质子受体,而PBHE是一个强质子给体,两者极易形成氢键,十分有利于形成互容对。笔者研究了PEO/PBHE共混体系的相容性,等温及非等温结晶动力学,本文根据Vonk提出的一维电子密度相关函数,分析了PEO/PBHE的SAXS现象,求得了共混体系的结晶度,片晶层厚度,过渡层厚度及长周期等结构参数。     

Rigid aromatic fractal polyamides

The preparation of rigid aromatic, highly branched polyamides is described. Owing to the method of preparation and the chosen ratio of difunctional to trifunctional monomers, these entities are highly porous and not dendrimeric in nature. They better conform with the fractal model and are therefore called fractal polyamides (FPs). The effects of variations in the polymerization procedure, in total monomer concentration, in the ratio of amine to carboxyl groups and in the duration of the polycondensation reaction are investigated. Some characterization was performed and the results are presented and briefly discussed.     

乙烯-α-烯烃共聚物的结晶性能及其临界序列结晶长度的研究

本文用DSC、WAXD及偏光显微镜(PLM)方法,研究了化学反应法催化剂合成的乙烯-α-烯烃共聚物的结晶性能及其临界序列结晶长度。结果表明,随共聚物中α-烯烃含量增大,共聚物的微晶尺寸、结晶度及熔点均逐渐减小,而晶胞参数增大。变化的辐度戊烯>辛烯。共聚物的临界结晶序列长度(n)和k值均戊烯<辛烯。上述结果表明影响支链进入晶格的主要因素是α-烯烃支链长度和结构。     

尼龙－1010的聚集态结构

用ＷＡＸＤ、ＤＳＣ、方差－范围函数．密度测量等方法，研究了经不同热处理的尼龙－１０１０的聚集态结构．发现退火处理更有利于尼龙－１０１０结晶的生成和稳定，且尼龙－１０１０的结晶，有一个最佳的热处理温度．在该温度附近，尼龙－１０１０的结晶度和微晶尺寸里最大值．     

热致液晶共聚酯／Nylon－1010共混物的研究

利用偏光显微镜（ＰＬＭ），差示扫描量热计及广角Ｘ－射线衍射等手段研究了热致液晶共聚酯／Ｎｙｌｏｎ－１０１０共混体系．发现当热致液晶共聚酯（ＨＴＨ１０）含量达到３０％时共混物微结构与纯ＨＴＨ１０相似．尼龙－１０１０的结晶度先是随ＨＴＨ１０含量增加而增加，随后又随之下降，但其结晶温度却随ＨＴＨ１０加入而单调下降，共混物的熔融热焓△Ｈｍ在ＨＴＨ１０含量为３０％时与计算值有较大的偏差，广角Ｘ－射线衍射结果表明，此时共混物结构发生了较为明显的变化，两组份之间在此时存在一定的相互作用．