Electron transfer induced dissociations of 2- and 4-alkyl cyclohexadienones

Several 2- and 4-alkylcyclohexadienones were prepared and shown to accept electrons to produce ketyl radical anions that dissociated rapidly at room temperature to release carbon-centered radicals and an aromatic phenoxide type anion. In the PET process with benzyl-substituted cyclohexadienones, initiated with triethylamine, the benzyl radicals dimerised or abstracted an H-atom from solvent. In electrochemical reductions, and in reductions with alkali metals in liquid ammonia, the benzyl radicals were further reduced to anions.     

钴（Ⅱ）—丁二酮单肟烟酰腙—亚硝酸盐体系的伏安行为及其应用

在氨性介质中(pH=9.0),钴(Ⅱ)-丁二酮单肟烟酰腙(DMNH)-亚硝酸盐体系可产生灵敏度很高的催化波。从体系的伏安行为可知,吸附于汞电极上的是混配的配盐NH_4[Co(Ⅱ)(DMNH)·(NO_2)_2],在-1.0 V(相对SCE)处,Co(Ⅱ)被还原至Co(0),DMNH被还原成自由基,由于NO_2~-的存在,自由基可参与再生反应而形成催化波。羟氨的存在可使产生催化波的最佳pH值移至8.2.用此体系进行了生物样品中钴的测定,其检出限为1×10~(-10)mol/L。     

Synthesis of a new and versatile macrocyclic NADH model

A new macrocyclic NADH model 1 has been designed and synthesised. The new model consists of the same subunits as previously reported models. However, the present model is designed as such that the pyridine nitrogen of the nicotinamide units are not incorporated in the macrocyclic framework. Thus, properties such as solubility can easily be varied by alkylation with an appropriate agent. The macrocyclic framework was prepared in 7 steps. Methylation of the pyridine nitrogens followed by reduction gave the desired model. This model compound was found to reduce methyl benzoylformate stereoselectively in good yield with 48% enantiomeric excess.     

Study of Factors Affecting the Performance of Voltammetric Copper Sensors Based on Gly‐Gly‐His Modified Glassy Carbon and Gold Electrodes

This paper reports a study of the factors affecting the analytical performance of gold and glassy carbon electrodes modified with the tripeptide Gly‐Gly‐His for the detection of copper ions. Gly‐Gly‐His is attached to a glassy carbon (GC) surface modified with 4‐carboxyphenyl moieties or a gold surface modified with 3‐mercaptopropionic acid by the reaction of the N‐terminal amine group of the peptide with the carboxylic acid groups of the monolayer via carbodiimide activation. X‐ray photoelectron spectroscopy was used to characterize the steps in the biosensor fabrication. It was found that the analytical performance of a sensor prepared with Gly‐Gly‐His on a GC electrode was similar to that on a gold electrode under the same conditions. The performance was greatly enhanced at higher temperature, no added salt during copper accumulation and longer accumulation time within a pH range of 7–9. Interference studies and investigations of stability of the Gly‐Gly‐His sensor are reported. Analysis of natural water samples show that the sensors measure only copper ions that can complex at the sensor surface. Strongly complexed copper in natural water is not measured. Despite greater stability of diazonium salt derived monolayers on carbon surfaces compared with alkanethiols self‐assembled monolayers on gold, the stability of the sensors was essentially the same regardless of the modification procedure.     

Voltammetric Detector for Liquid Chromatography: Determination of Triclosan in Rabbit Urine and Serum

A flow-electrolytic cell containing a strand of carbon fibers has been designed and characterized for use in a voltammetric detector for high-performance liquid chromatography. The detector was used for determination of triclosan (2,4,4-trichloro-2-hydroxydiphenyl ether) in rabbit serum and urine. Analysis of rabbit serum and urine 1 day and 1 to 5 days, respectively, after ingestion of oral triclosan revealed that the concentration of triclosan was higher than for control serum and urine. The concentration reached maximum levels after 6 h and 34 h or 44 h in serum and urine, respectively. When triclosan was determined in rabbit samples with the method proposed the results obtained were comparable with those obtained by high-performance liquid chromatography with ultraviolet detection.     

Voltammetric Behavior of Water‐Soluble Endohedral Metallofullerene Derivatives

Voltammetric behavior of water‐soluble endohedral metallofullerene derivatives Gd@C₈₂(OH)₅(NHCH₂COOH)₉ (GN) and Gd@C₈₂(OH)₆(NHCH₂CH₂SO₃H)₈ (GS) was characterized in 0.1 M KCl solution by CV and DPV. They showed similar redox behavior, that is, a reversible electroreduction process on HMDE was found; in the mean time, an irreversible oxidation process and an irreversible reduction process on GC electrodes were also observed. The results reveal that these two water‐soluble endohedral metallofullerene derivatives have good electron donating ability and poor electron accepting ability due to hydroxy groups, aminoacetic acid and aminoethyl sulfonic acid connected to the C₈₂ cage in comparison with Gd@C₈₂.     

Copper corrosion in buffered and non-buffered synthetic seawater: a comparative study

The electrochemical behaviour of copper in neutral buffered and non-buffered synthetic seawater and in pure chloride solutions has been studied by cyclic voltammetry, weight loss measurements, open circuit potential and scanning electron microscopy (SEM). Values of the repassivation potentials of Cu in non-buffered and buffered synthetic seawater, at 50 mV s^–1, were 0.12 and 0.46 V vs. SCE, respectively. The sharpness, heights and location of the different peaks as well as their charges were shown to be influenced by the composition of the solution, buffering conditions, deoxygenation, polarization potential and time. High chloride concentrations lead to higher oxidation charges. The anodic and the cathodic charges were shown to increase as the chloride concentration increases. The open circuit potential transients of copper in non-deoxygenated, non-buffered synthetic seawater indicate pitting from the beginning of the exposure, while in buffered solutions the pitting appeared only after a quite long exposure period, i.e. after 40 days. Corrosion rates of Cu samples after 3 months of immersion were higher in solutions of pure chloride (0.5 M) than in synthetic seawater. After six months the differences were even more noticeable. SEM images have showed a somewhat higher density of pits on copper samples immersed in the chloride solution (0.5 M), in comparison with those in synthetic seawater.     

Study of cork (from Quercus suber L.)-wine model interactions based on voltammetric multivariate analysis

The cork from Quercus suber L. is the premium raw material used to produce wine-bottling stoppers; however, being a natural product, cork can be contaminated and attacked in different ways that could promote differences in its proprieties. A specific contamination is the defect known in the industry as “Mancha Amarela—Yellow spot” (MA). This cork shows modifications in its mechanical, structural and optical properties and is potentially able to cause off-flavours in wine. In this study, a new analytical approach is proposed for the rapid screening of cork-wine model interactions in order to determine if the cork were able to contaminate a wine. Cork samples classified as standard (S) and cork MA were put in contact with a wine model matrix. The model matrix was analysed by cyclic voltammetry and square wave voltammetry in function of different contact times. Considering that matrices in contact with cork S and MA exhibited different pH, the influence of this parameter on the distinction power was also evaluated. The data sets obtained from the different techniques were treated by principal component analysis (PCA) and PLS_Cluster. The major difference between samples S and MA is the occurrence of an important peak at ca. 580 mV in the MA voltammograms. This more positive peak may be assigned to lignin related phenolics; therefore, it can be proposed as a possible marker to follow lignin degradation.