How I Do It: Miniplate Reconstruction of the Lateral Thyroid Lamina: One-Stage Restoration of Voice After Teflon Granuloma Resection

This case report describes a one-stage technique for long-term voice restoration and laryngeal reconstruction in the treatment of Teflon (Dupont, Wilmington, Delaware) granuloma. A patient who presented with severe dysphonia underwent resection of a Teflon granuloma via a lateral laryngotomy. A pedicled strap muscle flap was used to reconstruct the paraglottic space. The muscle flap was positioned through the lateral laryngotomy with direct endoscopic visualization of the endolarynx to ensure correct vertical positioning and medialization of the vocal fold. The muscle flap was secured in this position with suture fixation. The trapdoor piece of cartilage that was elevated to create the window in the lateral thyroid lamina was repositioned over the pedicled muscle flap and reinforced with a titanium miniplate, which was secured to the remaining thyroid cartilage. The patient had excellent voice results and has not required revision or augmentation. Reinforcement of the lateral thyroid lamina using titanium miniplate fixation helps to stabilize the muscle pedicle flap and the position of the vocal fold, in this case resulting in good long-term voice results after a single-stage reconstruction.     

Efficient synthesis of p-bis-(chlorodifluoromethyl)benzene

Selective, high yield partial fluorination of p-bis-(trichloromethyl)benzene to p-bis-(chlorodifluoromethyl)benzene has been accomplished by warming a slurry of the p-bis-(trichloromethyl)benzene in anhydrous HF which also contains a small quantity of inert solvent, such as 1,2-dichloroethane.     

Determination of Chlorinated Hydrocarbon Species in Aqueous Solution Using Teflon Coated ATR Waveguide/FTIR Spectroscopy

The potential of an optical sensor based on mid-infrared spectroscopy, utilising a zinc selenide (ZnSe) attenuated total reflectance (ATR) element coated with an amorphous Teflon polymer, to determine chlorinated hydrocarbon species (CHC) in an aqueous environment is examined. The polymer coating concentrates the analytes within the penetration depth of the Fourier transform infrared (FTIR) evanescent wave and excludes water from the region. Teflon AF (Amorphous Fluoropolymer) is a family of amorphous copolymers based on polytetrafluoroethylene (PTFE), and is commercially available in two polymeric grades. Teflon AF is highly amorphous in nature with a large 'void volume', exhibits excellent chemical resistance and low water absorption. Such properties identify it as an excellent candidate for enrichment coating on an ATR/FTIR sensor. The potential of both polymeric grades of Teflon AF as enrichment membranes for ATR/FTIR analysis of CHC species was examined and contrasted. A rapid, repeatable, reversible response was observed with both grades to a range of CHC species. Linear responses in the mg/L region, with detection limits in the low mg/L region were achieved with the system used.     

Magnetically Enhanced 15 kHz Glow Discharge of Methane

This work deals with the luminous chemical vapour deposition (plasma polymerization) of hydrocarbon polymeric thin films in a magnetic field enhanced discharge of methane. The films were deposited on 4″ <111> single crystal silicon substrates. We investigated the influence of the different glow discharge parameters (e.g. pressure, flow rate, power input, etc.) on the deposition rate of methane and the refractive index of the resulting polymeric films, as well as the distribution of these parameters across the wafer. We used a Shinko Seiki Plasma Polymerization equipment with a bell jar reactor comprising two electrodes connected to a symmetric AC power supply of 15 kHz. Two magnetrons were formed by placing two circular shaped concentric magnetic poles behind each electrode. The substrates were attached on both sides of a rotating wheel held at a floating potential in the middle of the two electrodes. This equipment allowed us to vary a single parameter and keep the other parameters constant over the whole process. We measured the thickness and the refractive index and their distribution over the wafer. The effect of the system pressure, decoupled from the effect of flow rate, is explained by the characteristic nature of luminous gas phase and by the polymerization/deposition mechanism of luminous chemical vapour deposition.     

高压密闭消解-电感耦合等离子体质谱法测定青藏高原气溶胶样品中磷及其他18种元素

气溶胶中磷（P）的准确测定是评估磷沉降对青藏高原生态效应及磷的生物地球化学循环的重要前提。针对青藏高原气溶胶中磷含量低及滤膜单个样品量有限的特征,本文建立了高压密闭消解-电感耦合等离子体质谱法测定气溶胶中磷及其他元素含量的方法。电感耦合等离子体质谱法（ICP-MS）测得P元素的检出限为3.5 μg/L,优于电感耦合等离子体发射光谱仪（ICP-OES）的检测限（89 μg/L）,其他元素检出限均达到μg/L（ppb）级（0.013-36 μg/L）,部分元素如Co、Cd、Pb等达到ng/L（ppt）级（2-7 ng/L）。各元素线性关系良好,测定结果的相对标准偏差(RSD) < 5%,磷的加标回收在90-103%, 方法准确度和精密度满足分析要求。该方法成功地测定了青藏高原实际气溶胶样品中磷及其他元素,具有良好的可靠性和实用性。     

Comparative study of pretreatment methods for the determination of metals in atmospheric aerosol by electrothermal atomic absorption spectrometry

A comparative study of pretreatment methods for the determination of 10 elements (As, Cd, Pb, V, Ni, Mn, Cr, Cu, Fe, Al) in atmospheric aerosols by electrothermal atomic absorption spectrometry (ETAAS) was conducted. For the digestion of the particulates collected in filters, six methods were compared using a mixture of HNO₃ and HF with or without the addition of various oxidative agents (HClO₄ or H₂O₂) or acids (HCl). The comparative study was performed using loaded cellulose filter samples, which were digested in Parr bombs and heated in a conventional oven at 170 °C for 5 h. The extraction efficiency and blanks were compared and it was proved that the digestion method using only HNO₃–HF extracted most of the metals and gave the lowest blanks. The HNO₃–HF mixture was selected for the development of an improved microwave digestion method specific for aerosol-loaded filters. The operating parameters were optimized, so that quantitative recovery of the reference materials NIST 1649a urban dust and NIST 1648 urban particulate matter was achieved. The blank of cellulose and teflon filters were also determined and compared. Teflon filters present the lowest blanks for all the elements. The obtained limits of detection for each type of filters were adequate for environmental monitoring purposes. ETAAS instrumental operation was also optimized for the compensation and the elimination of interferences. The temperature optimization was performed for each metal in every type of filter and optimized parameters are proposed for 10 elements.     

热拉伸和化学腐蚀相结合制备弯曲光纤探针

提出了原子力/光子扫描隧道显微镜(AF/PSTM)系统的关键部分——双功能弯曲光纤探针的制作方法.采用热拉伸与动态、静态两步化学腐蚀相结合的方法制作出AF/PSTM弯曲光纤探针，弯曲角度约为150°，尖端曲率半径优于100nm，锥角范围为60°—90°.将这种双功能弯曲光纤探针应用在新研制的AF/PSTM系统上，同时获得了样品的光学与形貌图像，实现了图像分解. 关键词： 原子力/光子扫描隧道显微镜 光纤探针 热拉伸 化学腐蚀     

The structure dependence of exchange bias in ferromagnetic/antiferromagnetic bilayers

The structure dependence of exchange bias in ferromagnetic/antiferromagnetic （FM/AF） bilayers has been investigated in detail by extending Slonczewski＇s ＇proximity magnetism＇ idea. Here three important parameters are discussed for FM/AF bilayers, i.e. interracial bilinear exchange coupling J1, interracial biquadratic （spin-flop） exchange coupling J2 and antiferromagnetic layer thickness tAF. The results show that both the occurrence and the variety of the exchange bias strongly depend on the above parameters. More importantly, the small spin-flop exchange coupling may result in an exchange bias without the interracial bilinear exchange coupling. However, in general, the spin-flop exchange coupling cannot result in the exchange bias. The corresponding critical parameters in which the exchange bias will occur or approach saturation are also presented.     

Novel ring-cleaving reaction of 4-nitro-1,1,2,2,9,9,10,10-octafluoro[2.2]paracyclophane with nucleophiles

When 4-nitro-AF4 is treated with nucleophiles such as alkoxides and cyanide, a novel ring opening, cyclophane destroying reaction is observed whereby, via an S_NAr mechanism, the nucleophile attacks the bridgehead aryl carbon vicinal to the nitro group with subsequent aryl-CF₂ bond cleavage.     

Liposomal structure: A comparative study on light scattering and chromatography techniques

Liposomes play an important role in medical and pharmaceutical science as, nanoscale drug carriers. One of the most important features is their size and size distribution, influencing both their bio-distribution and their targeting efficiency to tumors and also therapeutic activity of liposomal antitumor drugs. In this study, the effect of preparation method and molecular interaction on size and shape of liposome was studied. The size and shape characterization of liposomes was performed by asymmetrical flow field-flow fractionation coupled online with multi-angle light scattering (AF4-MALS). The size distributions obtained by AF4-MALS were compared to mean particle sizes and size distribution measured with other standard method such as Photon Correlation Spectroscopy (PCS). Furthermore, the effect of molecular interaction (hydrophilic and hydrophobic model drugs) on liposomal structure was assessed.