A WKB analysis of the buckling condition for a cylindrical shell of arbitrary thickness subjected to an external pressure

We consider the plane-strain buckling of a cylindrical shellof arbitrary thickness which is made of a Varga material andis subjected to an external hydrostatic pressure on its outersurface. The WKB method is used to solve the eigenvalue problemthat results from the linear bifurcation analysis. We show thatthe circular cross-section buckles into a non-circular shapeat a value of µ₁ which depends on A₁/A₂ and a mode number,where A₁ and A₂ are the undeformed inner and outer radii, andµ₁ is the ratio of the deformed inner radius to A₁. Inthe large mode number limit, we find that the dependence ofµ₁ on A₁/A₂ has a boundary layer structure: it is constantover almost the entire region of 0 < A₁/A₂ < 1 and decreasessharply from this constant value to unity as A₁/A₂ tends tounity. Our asymptotic results for A₁ – 1 = O(1) and A₁– 1 = O(1/n) are shown to agree with the numerical resultsobtained by using the compound matrix method.     

Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid

Fully developed laminar mixed convection of a nanofluid consists of water and Al₂O₃ in horizontal and inclined tubes has been studied numerically. Three-dimensional elliptic governing equations have been solved to investigate the flow behaviors over a wide range of the Grashof and Reynolds numbers. Comparisons with previously published experimental and numerical works on mixed convection in a horizontal and inclined tube are performed and good agreements between the results are observed. Effects of nanoparticles concentration and tube inclinations on the hydrodynamics and thermal parameters are presented and discussed. It is shown that the nanoparticles concentration does not have significant effects on the hydrodynamics parameters. Heat transfer coefficient increases by 15% at 4 Vol.% Al₂O₃. Skin friction coefficient continually increases with the tube inclination, but the heat transfer coefficient reaches a maximum at the inclination angle of 45°.     

Letter: Models of Relativistic Particle with Curvature and Torsion Revisited

Models, describing relativistic particles, where Lagrangian densities depend linearly on both the curvature and the torsion of the trajectories, are revisited in D=3 space forms. The moduli spaces of trajectories are completely and explicitly determined using the Lancret program. The moduli subspaces of closed solitons in the three sphere are also determined.     

三维内肋管内插入螺旋扭带的强化传热实验

本文分别以水和乙二醇为工质，在Ｒｅ数范围为：６００～４００００，Ｐｒ数范围为：５．５～１１０之间，对四根分别插入三种不同扭率螺旋扭带的三维内助管内的换热和流阻特性进行了实验研究。结果表明：三维内肋管内加装扭带的强化传热技术适用于低Ｒｅ数下高Ｐｒ数工质的管内对流换热强化。根据实验值得到了流阻和换热关联式。     

SPE电极上Pt单组分及Pt-Au双组分还原态CO_2阳极剥离电化学氧化行为研究

采用循环伏安法，对ＳＰＥＰｔ电极以及ＳＰＥＡｕ－Ｐｔ电极上还原态ＣＯ２的电化学氧化行为研究表明，此类电极的电化学特性与光滑Ｐｔ电极一致：ＣＯ２在氢原子吸附电位区０～２５０ｍＶ（ｖｓ．ＲＨＥ）处，可与电极上化学吸附的氢反应，生成还原态的ＣＯ２，通过线性扫描，还原态ＣＯ２即发生一不可逆电化学氧化过程（阳极剥离）．在ＳＰＥＰｔ系列及ＳＰＥＡｕ－Ｐｔ系列上ＣＯ２的电化学行为表明，当ＳＰＥＰｔ系列上Ｐｔ的载量为２．５ｍＬ的０．０１ｍｏｌ·Ｌ－１Ｈ２ＰｔＣｌ６的Ｐｔ时，对还原态ＣＯ２的电催化活性最好，当Ｐｔ的载量相同时，在ＳＰＥＡｕ－Ｐｔ上，催化剂对还原态ＣＯ２的电化学氧化行为比ＳＰＥＰｔ电极更强，这是由于预先沉积的Ａｕ对后沉积的Ｐｔ有调制作用．     

Averaged molecular weight of complex mixtures as determined by rapid measurements of diffusion

Summary The concept of a diffusion-averaged molecular weight, M_d is presented, and M_d is defined for polydisperse samples. It is shown via oligostyrene mixtures that M_d can be determined in 20 minutes with common chromatographic equipment. If M_d is measured and M_n or M_w is known, the polydispersity can be obtained.     

高效液相色谱-串联质谱法同时测定表层水体中5类40种抗生素

建立了固相萃取-高效液相色谱-串联质谱（SPE-HPLC-MS/MS）同时检测表层水中5类40种抗生素的分析方法。水样经过滤、固相萃取柱富集净化后，以乙腈-0.2%（v/v）甲酸水溶液为流动相进行梯度洗脱，采用电喷雾电离源，在多反应监测、正离子模式进行定性定量分析。结果显示，40种抗生素在1~200 μg/L水平下线性关系良好，平均加标回收率为41.3%~112.6%。采用该方法对长江南京段表层水体进行检测，共检出13种抗生素，含量为13.4~780.5 ng/L，其中喹诺酮类抗生素恩诺沙星检出率达100%，大环内酯类抗生素克林霉素最高检出水平达739.4 ng/L。该法高效、灵敏、可靠，可用于实际水样中多种抗生素的分析。     

Stabilization of a standard gas mixture generator with diffusion tubes

Summary The generator contains diffusion tubes of known length and internal diameter. Once produced, the mixture of the carrier gas and acetone, the reference material, is sent through a chromatographic flame ionisation detector. Its signal reaches a constant level after a time corresponding to the stabilization time of the generator. The technique described is simple and gives repeatable results.     

Rapid Protein Hydrolysis by Microwave Irradiation Using Heat-Resistant Teflon-Pyrex Tubes

A rapid peptide-bond hydrolysis by means of microwave irradiation is introduced for the facile preparation of protein hydrolysates used for amino acid analysis. The optimal hydrolysis condition has been determined using several enzymes with known amino acid compositions. The effects of hydrolysis time on the recovery of various labile and hydrophobic amino acids are also exemplified in the microwave heating of standard amino acids. The method has been applied to the complete amino acid analysis with a single nonvolatile solvent of methanesulfonic acid with good recovery of tryptophan and half-cystine. It provides a radical expedition of protein and peptide hydrolysis via commercial microwave ovens and specially-designed Teflon-Pyrex tubes, circumventing the tedious procedures using vacuum-sealed pyrex lubes heating at 110°C for more than 24 h. This novel type of microwave chemistry associated with rapid peptide-bond cleavage is of great potential in the automation of the complete process of amino acid analysis starting from the preparation of protein hydrolysates.