Electronic structure of Ti metal and TiO2 powder studied by hard and soft (Cu Kα1 and Al Kα1) X-ray photoelectron and Auger spectroscopy

High-energy X-ray photoelectron spectroscopy (XPS) is of particular importance for minimizing the effects of surface contamination by increasing photoelectron escape depths. In this study high-resolution high-energy Cu Kα₁ and soft Al Kα₁ XPS and Auger electron spectroscopy were used to compare the electronic structure of Ti in TiO₂ powder and Ti metal. The Ti 1s in TiO₂ XPS line is narrower and more symmetric than in Ti metal. A comparison of the relative intensities of the L₂₃M₂₃M₄₅ and L₂₃M₂₃M₂₃ Auger transitions in Ti metal and TiO₂ is consistent with the expected transfer of Ti 3d electrons away from the Ti site in the oxide. The satellites accompanying the Ti 1s XPS line excited by Cu Kα₁ X-rays occur at the same energies as the satellites accompanying the Ti 2s and 2p XPS lines excited by Al Kα₁ X-rays indicating that they do not depend on the core-level, the experimental resolution or inelastic scattering processes.     

A biocatalytic route to enantioenriched, sulfanyl aldol products

The aldol products derived from sulfur- or selenium containing acceptors were prepared by kinetic resolution in the presence of antibody 84G3 with enantiomeric excesses ranging from 56 to 70%. Much higher level of enantioselectivity was obtained (enantiomeric excesses all superior to 96%) for sulfanyl aldol products derived from thiomethoxyacetone with three different acceptors.     

CID-ICP-AES检测煤中不同形态的硫

研究了CID-ICP-AES检测煤中硫酸盐和硫铁矿形态硫的方法。较现有国标方法快速、简便，常见元素不干扰，加标回收率在98．5％-103．0％之间，10次测定的RSD在0．76％-1．59％之间。     

Preparation and properties of homogeneous V2O5-SiO2 xerogel composite based on interpenetrating polymer network

In this paper, we report the conducting and electrochemical properties of a homogeneous V₂O₅-SiO₂ xerogel composite obtained from the simultaneous polymerization in both inorganic components (Si-O and V-O based polymers) forming an interpenetrating polymer network, where a mutual “solubility” due to cross-links and entanglements was observed. The presence of V₂O₅ inside the silica matrix has a strong effect on electrical conductivity; measurements showed room temperature conductivity almost 1000 times higher than what is found in the literature. In addition, the electrochemical behavior is quite similar to that found in V₂O₅ xerogel. Moreover, the effects of thermal treatment on the conducting and electrochemical properties were investigated. It was found that both properties were improved with no significant effect on V₂O₅ xerogel layered structure.     

Determination of the boiling point distribution of sulfur compounds in light cycle oil using GC with a flame photometric detector and pyrolyzer

A method has been developed to determine the boiling point distribution of sulfur compounds in light cycle oils (LCO'S). The method chosen for this analysis was GC with a flame photometric detector (FPD) and pyrolyzer. Tests were carried out to evaluate the recovery efficiency, repeatability, and accuracy of the method. Repeatabilities within 2% were obtained. The recovery of benzothiophenes and dibenzothiophenes was close to 100%; this was important because these are the major sulfur components in LCO's. No hydrocarbon or solvent interferences were observed with the use of the pyrolyzer, even for a 95% solvent level. Comparison with results from other techniques showed that the method accurately determined the levels of sulfur compounds in the LCO boiling point range.     

Band bending at the Si(1 1 1)–SiO2 interface induced by low-energy ion bombardment

Experiments employing photoreflectance spectroscopy have uncovered band bending due to electrically active defects at the Si(1 1 1)–SiO₂ interface after sub-keV Ar⁺ ion bombardment. The band bending of about 0.5 eV resembles that for Si(1 0 0)–SiO₂, and both interfaces exhibit two kinetic regimes for the evolution of band bending upon annealing due to defects healing. The healing takes place about an order of magnitude more quickly at the (1 1 1) interface, however, probably because of less fully saturated bonding and higher compressive stress.     

Ab initio study of sodium intercalation into metal oxides

Using the full-potential linearized augmented plane wave (FP-LAPW) method, we have studied the effect of chemistry on the average intercalation voltage (AIV) caused by the Na ions intercalating into transition metal oxides. The effect of transition metal was systematically studied by varying M=Co, Ni and Mn in NaMO₂ and fixing the α-NaFeO₂ layered structure. The effect of the guest atoms into the host material is discussed in terms of the structural and electronic properties. Comparatively to Li intercalation, a significant electron transfer towards transition metal was found. This observation suggests that the transition metal contribute to the AIV determination and confirms the common assumption that intercalated electron reduces M⁴⁺ to M³⁺.     

Superconductivity and normal state resistivity of Ba0.6K0.4BiO3: an optical phonon approach

We discuss the nature of the pairing mechanism and the physical properties associated with the normal as well as the superconducting state of cubic perovskites Ba_0.6K_0.4BiO₃using the strong coupling theory. An interaction potential which includes the Coulomb, electron–optical phonon and electron–plasmon interactions is developed to elucidate the superconducting state. A model dielectric function is constructed with these interactions fulfilling thef-sum rule. The screening parameter (μ^* = 0.26) infers the poor screening of charge carriers. The electron–optical phonon strength (λ) estimated as 0.98 is consistent with an attractive electron–electron interaction and supports the moderate to strong coupling theory. The superconducting transition temperature of Ba_0.6K_0.4BiO₃is then estimated as 32 K. Ziman's formula of resistivity is employed to analyse and compare this with the temperature-dependent resistivity of a single crystal. The estimated contribution from the electron–optical phonon together with the residual resistivity clearly infers a difference when a comparison is made with experimental data. The subtracted data infer a quadratic temperature dependence in the temperature domain (30 ≤ T ≤ 200 K). The quadratic temperature dependence of ρ [ = ρ_exp − (ρ₀ + ρ_e–ph)] is understood in terms of 3D electron–electron inelastic scattering. The presence of these el–el and el–ph interactions allows a coherent interpretation of the physical properties. Analysis reveals that a moderate to strong coupling exists in the Ba_0.6K_0.4BiO₃system and the coupling of electrons with the high-energy optical phonons of the oxygen breathing mode will be a reason for superconductivity. The implications of the above analysis are discussed.