Phasenbeziehungen und Natriumionenleitung im quasi-binären System Na2SiF6/Na3AlF6

Phase Relations and Sodium Ion Conductivity within the Quasi-binary System Na₂SiF₆/Na₂AIF₆ . The phase diagram of the Na₂SiF₆/Na₃AlF₆ system has been determined by means of x-ray powder diffraction, thermal analysis and conductivity measurements in the sub-solidus region. Na₃AlF₆ accomodates up to 73 mol.-% Na₂SiF₆ maintaining the crystal structure type. The sodium ion conductivity increases by about five orders of magnitude upon doping Na₃AlF₆ with Na₂SiF₆.     

On a new calcium vanadate: synthesis, structure and Li insertion behavior

A synthetic form of the mineral hewettite was prepared via a new route in aqueous medium, starting either from the crystalline compound Li_1.1V₃O₈, or from its amorphous precursor. The anhydrous, crystalline derivative Ca_0.5V₃O₈ was obtained by heating the synthetic hewettite at 250°C under dynamic vacuum. The diffraction studies show that the 2D structure of Ca_0.5V₃O₈ involves the same V₃O₈ layers as in the hewettite or in Li_1+αV₃O₈. The stacking of the layers is similar to that in the metahewettite. A structural model is proposed, where the Ca²⁺ ions occupy octahedral sites in the interlayer space. The electrochemical behavior of Ca_0.5V₃O₈ vs. lithium insertion is presented. It is original and reveals particularly good performances in terms of stability during cycling at C/5 rate. The homologues obtained with Mg or Ba, instead of Ca, are briefly presented.     

Effect of borohydride as reducing agent on the structures and electrochemical properties of Pt/C catalyst

In this paper, we found that boron deposited on the surface of support when sodium borohydride used as reducing agent during the preparation of Pt/C catalyst. The deposition of boron markedly reduces particle size of Pt, raises electrochemical active surface (EAS) area of catalyst and electrochemical activity for hydrogen evolution or oxygen reduction reaction (ORR) compared with which prepared using other reducing agents (hydrogen and formaldehyde).     

无K1,r图中的哈密顿圈（英文）

本文借助对图的本质独立集和图的部分平方图的独立集的研究，对于K1,r图中哈密顿圈的存在性给出了八个充分条件。我们将利用T－插点技术对这八个充分条件给出统一的证明，本文的结果从本质上改进了C－Q.Zhang于1988年利用次形条件给出的k-连通无爪图是哈密顿图的次型充分条件，同时。G.Chen和R.H.Schelp在1995年利用次型条件给出的关于k-连通无K1，4图是哈密顿图的充分条件也被我们的结果改进并推广到无K1,r图。     

电子储存环中插入元件的非线性束流动力学的Lie代数方法

介绍了用能保证哈密顿系统“辛”性质的Lie映射方法来研究电子储存环中的插入元件对束流动力学的影响.并以此方法对合肥光源中将要安装的波荡器UD?–?1对储存环的影响作了初步的研究     

硫酰胺的快速分析（Ⅱ） 

硫酰胺生产过程中副产的大量氯化铵要干扰硫酰胺的测定，采用四苯硼钠将全部氯化铵呈沉淀析出，再用次溴酸钠把滤液中的硫酰胺分解成氮气，测其体积，计算出硫酰胺的含量。对样品进行测定的结果表明，该法重现性好、准确度高、分析周期在３５ｍｉｎ内，相对误差在±１％以内。     

Microperforated insertion units: An alternative strategy to design microperforated panels

Microperforated panels (MPPs) coupled to a rigid wall have been proposed recently as an alternative to porous absorbers in situations having concerns with bacterial contamination and small particles discharge, like food, pharmaceutical and microelectronic industries. There exists also an increasing interest for MPP absorbers in the transportation industry and civil engineering. In general, an optimally designed MPP with good broadband absorption requires many submillimetric holes distributed over a panel of also submillimetric thickness. Such thin plates or foils become so fragile that they need to be protected from mechanical damage. In this paper, an alternative strategy is investigated which allows the design of MPPs with panels of millimetric thickness while maintaining their acoustic performance. These absorbers, named microperforated insertion units (MIUs), avoid the structural problems of the classical MPPs. An assessment of the sound absorption properties of these structures is presented. Comparisons between calculations and measurements are also made under two experimental conditions: plane waves at normal incidence (impedance tube) and free field (anechoic room).     

Difference in micellar properties of sodium dodecyl sulfonate from sodium 4-decyl naphthalene sulfonate in D2O solution studied by 1H NMR relaxation and 2D NOESY

¹H chemical shift changes of sodium 4-decyl naphthalene sulfonate (SDNS) at 313 K show that its critical micellar concentration lies between 0.82 and 0.92 mmol/dm³, which is in the same range as that of the previous study at 298 K. The spin–lattice relaxation time, spin–spin relaxation time and two-dimensional nuclear Overhauser enhancement spectroscopy experiments give information about the structure of the SDNS micelle and the dynamics of the molecules in the micelle. The size of the SDNS micelle remains almost unchanged in the temperature range from 298 to 313 K as deduced by analyzing the self-diffusion coefficient. Special arrangement of the naphthyl rings of SDNS in the micelles affects the packing of these hydrophobic chains. The methylene groups of the alkyl chain nearest the naphthalene groups penetrate into the aromatic region, which results in a more tightly packed hydrophobic micellar core than that of sodium dodecyl sulfonate.     

Ab initio study of sodium intercalation into metal oxides

Using the full-potential linearized augmented plane wave (FP-LAPW) method, we have studied the effect of chemistry on the average intercalation voltage (AIV) caused by the Na ions intercalating into transition metal oxides. The effect of transition metal was systematically studied by varying M=Co, Ni and Mn in NaMO₂ and fixing the α-NaFeO₂ layered structure. The effect of the guest atoms into the host material is discussed in terms of the structural and electronic properties. Comparatively to Li intercalation, a significant electron transfer towards transition metal was found. This observation suggests that the transition metal contribute to the AIV determination and confirms the common assumption that intercalated electron reduces M⁴⁺ to M³⁺.     

Oxidative Coupling of Thiols to Disulfides with Ti(IV) in the Presence of NaI under Air Atmosphere

Ti(IV) as TiCl₃(O₃SCF₃) and TiO(O₂CCF₃)₂ are used as efficient catalysts for oxidative coupling of aliphatic, aromatic and heteroaromatic thiols to their disulfides in the presence of NaI under air atmosphere.