Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

An easy preparation of per- and poly-fluoroalkyl propenyl sulfones

Sodium tridecafluorohexanesulfinate (1a) and sodium 1-chloro-2,2,2-trifluoroethanesulfinate (1b) were prepared by the treatment of 1-iodo-tridecafluorohexane and 1-bromo-1-chloro-2,2,2-trifluoroethane with sodium dithionite in a water-acetonitrile solution. Prolonged reaction of 1a with allyl bromide in DMF afforded tridecafluorohexane 1-propenyl sulfone 2 as the only product in good yield. A similar treatment of 1b gave exclusively 1-chloro-2,2,2-trifluoroethane 3-propenyl sulfone 4. Bromination of 4 followed by dehydrobromination with Et₃N resulted in a mixture of 1-chloro-2,2,2-trifluoroethane 3-bromo-1-propenyl sulfone 6 and 1-chloro-2,2,2-trifluoroethane 2-bromo-3-propenyl sulfone 7, while dehydrobromination with pyridine gave sulfone 6 practically as the only product. α,β-Unsaturated sulfones 2 and 6 were shown to be active dienophiles.     

Effect of Neck Formation on the Measurement of Dynamic Interfacial Tension in a Drop Volume Tensiometer

Dynamic interfacial tension values obtained by drop volume tensiometry will be affected under certain experimental conditions by the formation of a neck between the drop and the capillary tip. This phenomenon must be accounted for to obtain accurate values of interfacial tension. In this work, neck formation for a water–mineral oil system is studied under conditions where hydrodynamic effects can be neglected. A model originally developed for the determination of the surface tension of a suspended drop is modified for application to dynamic interfacial tensions of surfactant-containing liquids. The model relates apparent values of interfacial tension calculated from drops possessing necks to actual values. Experiments with Span 80 (sorbitan monooleate) and sodium dodecyl sulfate (SDS) surfactants in a mineral oil–water system are used to test the validity of the developed model. For the small tip diameter used, good agreement is obtained for Span 80 up to the critical micelle concentration, and for low concentrations of SDS, when the surfactant adsorption is diffusion-limited. In both cases, the neck diameter of the growing drop can be considered constant over the range of dynamic interfacial tensions tested.     

导数光谱法测定污水中十二烷基苯磺酸钠

本文介绍了用导数分光光度法直接定量分析污水中十二烷基苯磺酸钠的方法。本法消除了混浊背景干扰，操作简便快速。应用于实际污水样品的分析，获得了良好的结果，十二烷基苯磺酸钠的校准曲线线性范围为0－82mg/L。     

原子吸收光谱法和ICP-AES测定水中钠的比较

测定水中钠的含量,ICP-AES具有直接进样、测量稳定、校准曲线线性范围宽等特点;而原子吸收光谱法需要加入消电离剂硝酸铯或氯化铯,实际操作麻烦.该方法经过t检验证明与标准方法无显著性差异,加标回收率为96.9%-104%,可以代替原子吸收光谱法,相对标准偏差各为0.7%、0.8%.     

头孢噻肟钠与牛血清蛋白相互作用的光谱特征

用光谱法研究头孢噻肟钠（CS）和牛血清蛋白（BSA）在模拟生命体生理条件下相互作用的特征.结果表明CS主要以静态猝灭方式使BSA的荧光强度显著降低;利用同步荧光法研究了CS和BSA作用后牛血清蛋白的构象发生了变化;求得不同温度下二者的结合常数和结合位点数,探讨了微量金属离子对实验体系结合常数的影响,并根据热力学参数确定了CS和BSA之间主要依靠静电力结合.根据Froester非辐射能量转移机理,测定了CS与BSA相互结合时的作用距离2.56nm,表明BSA与CS之间发生了非辐射能量转移.     

火焰原子吸收光谱法测定血浆代用品中钾和钠

本文报道了火争原子吸收光谱法测定血浆代用品中钾，钠，使用镧和氯化铯，消除了电离干扰和共存元素干扰，本法简便，快速，本法的准确度和精密度均令人满意。     

The corrosion properties of phosphate coating on AZ31 magnesium alloy: The effect of sodium dodecyl sulfate (SDS) as an eco-friendly accelerating agent

Sodium nitrite has been used as an accelerating agent in phosphating bath to improve its properties. However, it is well known that sodium nitrite is a carcinogenic component in phosphating sludge. In this study, it has been aimed to replace sodium nitrite by an environmentally friendly accelerating agent. To this end, sodium dodecyl sulfate (SDS) was used in phosphating bath to improve the phosphate coating formation on an AZ31 magnesium alloy. The effect of SDS/sodium nitrite ratio on the phosphated samples properties was also studied. Using field emission scanning electron microscope (FE-SEM), X-ray diffraction (XRD), direct current (DC) polarization and electrochemical impedance spectroscopy (EIS) the properties of phosphated magnesium samples were studied.Results showed uniform phosphate coating formation on the magnesium sample mostly in hopeite phase composition. In addition, a denser and less permeable coating can be obtained at these conditions. The corrosion resistance of the phosphated samples was superiorly improved using higher SDS concentration in the phosphating bath.     

Studies on poly(vinylidene fluoride-co-hexafluoropropylene) based gel electrolyte nanocomposite for sodium-sulfur batteries

Experimental investigations on a sodium ion conducting gel polymer electrolyte nanocomposite based on poly(vinylidene fluoride-co-hexafluoropropylene) (PVdF-HFP), dispersed with silica nanoparticles are reported. The gel nanocomposites have been obtained in the form of dimensionally stable, transparent and free-standing thick films. Physical characterization by X-ray diffraction (XRD), Fourier transform Infra-red (FTIR) spectroscopy and Scanning electron microscopy (SEM) have been performed to study the structural changes and the ion-filler-polymer interactions due to the dispersion of SiO₂ nanoparticles in gel electrolytes. The highest ionic conductivity of the electrolyte has been observed to be 4.1 × 10⁻³ S cm^− 1 at room temperature with ~ 3 wt.% of SiO₂ particles. The temperature dependence of the ionic conductivity has been found to be consistent with Vogel-Tammen-Fulcher (VTF) relationship in the temperature range from 40 to 70 °C. The sodium ion conduction in the gel electrolyte film is confirmed from the cyclic voltammetry, impedance analysis and transport number measurements. The value of sodium ion transport number (t_Na+) of the gel electrolyte is significantly enhanced to a maximum value of 0.52 on the 15 wt.% SiO₂ dispersion. The physical and electrochemical analyses indicate the suitability of the gel electrolyte films in the sodium batteries. A prototype sodium-sulfur battery, fabricated using optimized gel electrolyte, offers the first discharge capacity of ~165 mAh g^− 1 of sulfur.