A short note on the entrainment and exit boundary conditions

An attempt is made to find out the suitable entrainment and exit boundary conditions in laminar flow situations. Streamfunction vorticity formulation of the Navier–Stokes equations are solved by ADI method. Two‐dimensional laminar plane wall jet flow is used to test different forms of the boundary conditions. Results are compared with the experimental and similarity solution and the proper boundary condition is suggested. The Kind 1 boundary condition is recommended. It consists of zero first derivative condition for velocity variable and for streamfunction equation, mixed derivative at the entrainment and exit boundaries. Copyright © 2005 John Wiley & Sons, Ltd.     

溶胶-凝胶制备技术与新型催化材料Ⅲ.溶胶粒子表面修饰方法制备催化膜

提出用溶胶粒子表面修饰方法，结合溶胶凝胶技术制备无机催化膜．该方法的基本原理是利用合适的金属配合物在胶粒表面的吸附作用，经溶胶凝胶过程，将活性组分结合到无机膜中．实验测定结果表明：（ＮｉＥＤＴＡ）２－，ＶＯ－３，ＭｏＯ２－４，（Ｐｄ（ＮＨ３）４）２＋，ＰｄＣｌ２－４，ＰｔＣｌ２－６和ＲｈＣｌ３－６可用来修饰ＡｌＯＯＨ溶胶．以Ｐｄ／γＡｌ２Ｏ３催化膜的制备为例，经三次溶胶凝胶过程，可制得无裂缺的厚度为９μｍ的Ｐｄ／γＡｌ２Ｏ３催化膜，膜材料的平均孔直径为６ｎｍ，Ｐｄ被均匀地分布在膜的顶层，其平均粒径为２３ｎｍ．     

Micro enzymatic assay coupled to capillary electrophoresis via liquid junction

Summary A system for capillary electrophoresis combined with enzymatic assay has been evaluated for the two enzymes glucose-6-phosphate dehydrogenase and 6-phosphogluconate dehydrogenase. Instrumentation included a post-column reactor coupled to the separation capillary by a liquid junction. A technique for generating a substrate solution flow into the reactor by utilizing two high voltage supplies is proposed. This method offers a high degree of freedom in optimizing the separation and enzymatic reaction conditions individually. Possibilities for improving the enzymatic assay sensitivity were also examined.     

A subdomain boundary element method for high‐Reynolds laminar flow using stream function‐vorticity formulation

The paper presents a new formulation of the integral boundary element method (BEM) using subdomain technique. A continuous approximation of the function and the function derivative in the direction normal to the boundary element (further ‘normal flux’) is introduced for solving the general form of a parabolic diffusion‐convective equation. Double nodes for normal flux approximation are used. The gradient continuity is required at the interior subdomain corners where compatibility and equilibrium interface conditions are prescribed. The obtained system matrix with more equations than unknowns is solved using the fast iterative linear least squares based solver. The robustness and stability of the developed formulation is shown on the cases of a backward‐facing step flow and a square‐driven cavity flow up to the Reynolds number value 50 000. Copyright © 2004 John Wiley & Sons, Ltd.     

Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.     

超声速等离子体射流的数值模拟

基于可压缩的全Naiver-Stokes方程，利用PHOENICS程序对由会聚 辐射阳极形状等离子体炬产生的超声速等离子体射流进行了数值模拟.考虑了等离子体的黏性、可压缩性以及变物性对等离子体射流特性影响.研究了超声速等离子体射流的流场结构特性以及不同环境压力对等离子体射流产生激波结构的影响.结果表明，超声速等离子体射流在喷口附近形成的周期性激波结构是其和环境气体相互作用的结果. 关键词： 等离子体炬 超声速等离子体射流 PHOENICS     

横向射流式单重态氧发生器的性能实验研究

 对氧碘化学激光器的单重态氧发生器（SOG）进行了改进，采用横向射流方式，并对该横向射流式单重态氧发生器的性能进行了检测。实验中过氧化氢碱溶液温度控制在－16℃左右,氯气流量为530mmol/s，He与氯气的流量比为3;采用PS法测量单重态氧分子的产率,吸收法测量氯气的利用率和相对水含量。得出如下结论:在不使用冷阱和分离器的情况下，最高单重态氧分子产率达到58%, 氯气利用率在80%以上,相对水含量小于等于0.5;气体达到最大流量时,发生器仍然能稳定地工作。     

Flow-injection determination of 3-hdroxybutyrate in serum with an immobilized 3-hydroxybutyrate dehydrogenase reactor and chemiluminescence detection

A flow-injection system for the determination of 3-hydroxybutyrate in serum is described. 3-Hydroxybutyrate dehydrogenase is immobilized on poly(vinyl alcohol) beads and incorporated in a flow-injection system. 1-Methoxy-5-methylphenazinium methylsulphate reacts with enzymatically generated NADH to give H₂O₂, which is detected chemiluminometrically with the reaction of luminol and hexacynoferrate(III). Serum is diluted and filtered through an ultrafiltration membrane. The system responds linearly to injected samples (80 μl) in the concentration range 0.5–300 μM; the detection limit is 0.1 μM. The within-day relative standard deviation (n = 90) for 58 μM 3-hydroxybutyrate in serum is 0.8%. The maximum throughout is 20 samples per hour. The immobilized enzyme is stable for at least 1 month.     

e-A深度非弹性散射中胶子辐射振幅的新计算方法

在e-A深度非弹性散射过程中, 喷注穿过冷核介质时, 多重散射诱导胶子辐射会导致对碎裂函数的修正及喷注的能量损失.前期研究中关于计算e-A深度非弹性散射中胶子辐射振幅的两种方法: 螺旋振幅近似和微扰QCD严格计算都异常繁杂. 本文发展了一种新的方法, 可以方便计算出多重散射导致胶子辐射的振幅, 得到的碎裂函数的修正以及能量损失与严格计算的结果一致.