An AFM, XPS and electrochemical study of molecular electroactive monolayers formed by wet chemistry functionalization of H-terminated Si(1 0 0) with vinylferrocene

Molecular electroactive monolayers have been produced from vinylferrocene (VFC) via light-assisted surface anchoring to H-terminated n- and p-Si(1 0 0) wafers prepared via wet chemistry, in a controlled atmosphere. The resulting Si-C bound hybrids have been characterized by means of XPS and AFM. Their performance as semiconductor functionalized electrodes and their surface composition have been followed by combining electrochemical and XPS measurements on the same samples, before and after use in an electrochemical cell. White-light photoactivated anchoring at short (1 h) exposure times has resulted in a mild route, with a very limited impact on the initial quality of the silicon substrate. In fact, the functionalized Si surface results negligibly oxidized, and the C/Fe atomic ratio is close to the value expected for the pure molecular species. The VFC/Si hybrids can be described as (η⁵-C₅H₅)Fe²⁺(η⁵-C₅H₄)-CH₂-CH₂-Si species, on the basis of XPS results. Electrochemical methods have been applied in order to investigate the role played by a robust, covalent Si-C anchoring mode towards substrate-molecule electronic communication, a crucial issue for a perspective development of molecular electronics devices. The response found from cyclic voltammograms for p-Si(1 0 0) functionalized electrodes, run in the dark and under illumination, has shown that the electron transfer is not limited by the number of charge carriers, confirming the occurrence of electron transfer via the Si valence band. The hybrids have shown a noticeable electrochemical stability and reversibility under cyclic voltammetry (cv), and the trend in peak current intensity vs. the scan rate was linear. The molecule-Si bond is preserved even after thousands of voltammetric cycles, although the surface coverage, evaluated from cv and XPS, decreases in the same sequence. An increasingly larger surface concentration of Fe³⁺ at the expenses of Fe²⁺ redox centers has been found at increasing number of cv’s, experimentally associated with the growth of silicon oxide. Surface SiO⁻ groups from deprotonated silanol termination, induced by the electrochemical treatments, are proposed as the associated counterions for the Fe³⁺ species. They could be responsible for the observed decrease in the electron transfer rate constant with electrode ageing.     

Ceramic Films via Organometallic Complex as Single Source Precursor

Fe2(CO)6(μ-S2) was used as a single source precursor in attempt to produce FeS film via MOCVD. Pyrolysis of Fe2(CO)6(μ-S2) at temperature below 500℃ produced Fe1-xS or Fe7S8 powder as indicated by its powder X-ray spectra. At 750 ℃, polycrystalline FeS powder was obtained. In film deposition, polycrystalline Fe1-xS or Fe7Ss films were obtained on Si(100) and Ag/Si(100) substrates below 500 ℃. SEM micrographs showed the film on Si(100) substrate containing whisker like grains. However, pillar like grains were obtained on Ag/Si(100) substrate.Deposition rates are also different for different substrates as evaluated by the thickness of the films, which were obtained by SEM micrographs of the cross section of the films. At 750℃, similar polycrystalline Fe1-xS or Fe7S8 film was obtained.     

Hydroxylation-induced modifications of the Al2O3/NiAl(0 0 1) surface at low water vapour pressure

STM, STS, LEED and XPS data for crystalline θ-Al₂O₃ and non-crystalline Al₂O₃ ultra-thin films grown on NiAl(0 0 1) at 1025 K and exposed to water vapour at low pressure (1 × 10⁻⁷-1 × 10⁻⁵ mbar) and room temperature are reported. Water dissociation is observed at low pressure. This reactivity is assigned to the presence of a high density of coordinatively unsaturated cationic sites at the surface of the oxide film. The hydroxyl/hydroxide groups cannot be directly identify by their XPS binding energy, which is interpreted as resulting from the high BE positions of the oxide anions (O_1s signal at 532.5-532.8 eV). However the XPS intensities give evidence of an uptake of oxygen accompanied by an increase of the surface coverage by Al³⁺ cations, and a decrease of the concentration in metallic Al at the alloy interface. A value of ∼2 for the oxygen to aluminium ions surface concentration ratio indicates the formation of an oxy-hydroxide (AlO_xOH_y with x + y ∼ 2) hydroxylation product. STM and LEED show the amorphisation and roughening of the oxide film. At P(H₂O) = 1 × 10⁻⁷ mbar, only the surface of the oxide film is modified, with formation of nodules of ∼2 nm lateral size covering homogeneously the surface. STS shows that essentially the valence band is modified with an increase of the density of states at the band edge. With increasing pressure, hydroxylation is amplified, leading to an increased coverage of the alloy by oxy-hydroxide products and to the formation of larger nodules (∼7 nm) of amorphous oxy-hydroxide. Roughening and loss of the nanostructure indicate a propagation of the reaction that modifies the bulk structure of the oxide film. Amorphisation can be reverted to crystallization by annealing under UHV at 1025 K when the surface of the oxide film has been modified, but not when the bulk structure has been modified.     

Ⅰ类超晶格势阱中能级分布及电子跃迁规律研究

在研究大量实验曲线的基础上,指出势阱所有能级均有一定的宽度,电子或空穴在各能级中出现的概率符合正态分布,从理论上分析了I类超晶格和双势垒单势阱的发光光谱与吸收光谱·解释了GaAs/Ga1-xAlxAs多量子阱和超晶格吸收光谱吸收边及量子阱变窄时各吸收峰的“蓝移现象”及GaAs/Ga1-xAlxAs双势垒单量子阱样品的电流—电压特性曲线及电导—电压特性曲线的特征和出现的“负阻效应”·     

Synthesis and Properties of a Heteronuclear Ag（Ⅰ）/Ni（Ⅱ） Complex

Introduction Itiswell knownthatcyanogroupsincyanometa latessuchas[Ag(CN)2]-unitscanbeusedasbridg ingligandsandapolymericstructurecanbeformed throughsilver silver(argentophilic)interactions.This propertyhasbeenexploredintheconstructionofmany oligomericandp…     

Polarization inscription in ferroelectric (111) PZT and (100) SBT films

Ferroelectric thin films form an equilibrium domain structure compatible with their respective crystallographic symmetry. In tetragonal (111) PZT, 90° domains prevail; in (pseudo-tetragonal) (100) SBT both 90° and 180° domains are present. The size of 90° domains has been measured for e.g., PZT as slabs of 15 nm width. Domain size is a result of stress minimization in the film during the paraelectric (PE) → ferroelectric (FE) transition. A precise and regular domain pattern for (111) PZT and (100) SBT films has been investigated in detail by TMSFM. Single domains can be addressed mechanically with the tip of an AFM. Such single domain switching corresponds to a data storage density of 200 Gbit/inch². Applications of ferroelectric and high- paraelectric materials for e.g., non-volatile data storage replacing DRAM devices or as sensors in infrared cameras are increasingly becoming popular.     

GS-221高速摄影测量仪测角信息的采集与处理

在GS-221高速摄影测量仪中,测角信息采集与处理速度的快慢是重要性能指标之一。本文讨论了如何在尽可能短的时间内对测角信息进行采集和处理的软件实现方法。     

Cluster and periodic DFT calculations of adsorption and activation of CO2 on the Cu(hkl) surfaces

The adsorption behavior and thermal activation of carbon dioxide on the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces have been investigated by means of density functional theory calculations and cluster models and periodic slabs. According to the cluster models, the optimized results indicate that the basis set of C and O atoms has a distinct effect on the adsorption energy, but an indistinct one on the equilibrium geometry. For the CO₂/Cu(hkl) adsorption systems studied here, the final structure of adsorbed CO₂ is near linear and the preferred modes for the adsorption of CO₂ onto the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces are the side-on adsorption at the cross bridge site with an adsorption energy of 13.06 kJ/mol, the side-on adsorption at the short bridge site (13.54 kJ/mol), and the end-on adsorption on the on-top site with C–O bonds located along the short bridge site (26.01 kJ/mol), respectively. However, the calculated adsorption energies from periodic slabs are lower as compared to the experimental data as well as the cluster model data, indicating that the periodic slab approach of generalized gradient approximation in the density function theory may be not suitable to obtain quantitative information on the interaction of CO₂ with Cu(hkl) surfaces.     

Template atom transfer radical polymerization of a diaminopyrimidine‐derivatized monomer in the presence of a uracil‐containing polymer

Uracil‐derivatized monomer 6‐undecyl‐1‐(4‐vinylbenzyl)uracil and diaminopyrimidine‐derivatized monomer 2,6‐dioctanoylamido‐4‐methacryloyloxypyrimidine (DMP) were synthesized and polymerized by atom transfer radical polymerization (ATRP). A well‐defined, highly soluble, uracil‐containing polymer, poly[6‐undecyl‐1‐(4‐vinylbenzyl)uracil] (PUVU), was prepared in dioxane at 90 °C with CuBr/1,1,4,7,10,10‐hexamethyltriethylenetetramine as the catalyst and methyl α‐bromophenylacetate as the initiator. PUVU was further used as a template for the ATRP of DMP. The enhanced apparent rate constant of the DMP polymerization in the presence of PUVU indicated that the ATRP of DMP occurred along the PUVU template. The template polymerization produced a stable and insoluble macromolecular complex, PUVU/poly(2,6‐dioctanoylamido‐4‐methacryloyloxypyrimidine). An X‐ray diffraction study confirmed that the complex had strandlike domains. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6607–6615, 2006     

Fabrication of hexaphenylsilole nanowires and their morphology-tunable photoluminescence.

Immersion of nanoporous alumina membranes into saturated solutions of hexaphenylsilole with subsequent solvent evaporation affords aligned organic nanowires. The luminescent properties of the hexaphenylsilole nanowires can be manipulated by varying their morphologies, which were controlled by changing the channel sizes of the alumina templates.