The glow curve structure for the LiF:Mg,Cu,Na,Si TL detector with dopants concentrations and sintering temperatures

The glow curve structures for LiF:Mg,Cu,Na,Si TL detectors with various dopant concentrations and sintering temperatures were investigated for the improvement of the glow curve structure and sensitivity of the TL detector. The dopant concentrations were varied over the following ranges: Mg (0–0.25 mol%), Cu (0–0.07 mol%), Na and Si (0–1.5 mol%). With increasing Cu concentration, the intensity of the main peak was intensified and reached a maximum at a concentration of 0.05 mol%. The high-temperature peak was reduced. The dependency of the main peak intensity on the Mg concentration exhibits a sharp maximum at 0.2 mol%. The intensity of the high-temperature peak tends to rise slightly with increasing Mg concentration. It was found that the optimum concentrations of the dopants in the LiF:Mg,Cu,Na,Si TL material are Mg: 0.2 mol%, Cu: 0.05 mol%, Na and Si: 0.9 mol%. The dependency of the main peak intensity on sintering temperature exhibits a very sharp maximum at 830°C. The high-temperature peak was rapidly reduced after 825°C.     

Si1－xGex/Si量子阱发光材料的分子束外延生长及其结构研究

采用固源Si分子束外延,在较高的生长温度于Si(100)衬底上制备出Si1－xGex/Si量子阱发光材料。发光样品的质量和特性通过卢瑟福背散射、X射线双晶衍射及光致发光评估。背散射实验中观察到应变超晶格的反常沟道效应;X射线分析表明材料的生长是共度的、无应力释放的,结晶完整性好。低温光致发光主要是外延合金量子阱中带边激子的无声发射和横光学声子参与的激子复合。并讨论了生长温度对量于阱发光的影响。     

Luminescence enhancement by hydrogenation of Si:Er,O

Erbium (Er)- and oxygen (O)-doped Cz–Si was additionally doped with hydrogen, using plasma enhanced chemical vapour deposition. Photoluminescence (PL) spectra show a large enhancement especially for samples treated with solid phase epitaxy before hydrogenation and annealing at 900°C later. Secondary ion mass spectroscopy measurements give evidence for an enhanced diffusion of O and Er at this temperature towards the surface. Etching shows that the PL does not stem from the heavily doped surface layer but from a deeper region with lower Er concentration. This conclusion is supported by the appearance of the so-called “cubic” centre with low solubility. Comparing the PL yield of the hydrogenated samples to that of samples with similar Er volume concentration but without hydrogenation still gives a large enhancement. We thus conclude that hydrogen can enhance the solubility of the cubic centre in Si:Er,O.     

Theoretical Studies on the Si（001）-SiO2 Interface Structure

1 INTRODUCTION Silicon and its alloy have been widely applied in such fields as electronic industry, high-temperature structural ceramics, etc. In addition, the researches on silicon and its relevant materials greatly promote the rapid development of modern optics and infor- mation technology. Therefore, more and more at- tention is focused on the structure of silicon, oxide of silicon and the interfaces between silicon and metal or nonmetal. As an ideal passive film on the Si surface, S…     

Hybrid organosilazane/organosilylamine telechelic oligomers—I. Two-dimensional NMR spectroscopy characterization of dimethylsilylethylenediamine oligomers

The detailed characterization of multifunctional hybrid organosilazane/organosilylamine telechelic oligomers by IR and ¹H, ¹³C and ²⁹Si NMR spectroscopy in one and two dimenions has been undertaken. The specific multifunctional oligomers, comprising NH/NH₂ or SiCl functionalities depending on the monomer feed-ratio, were prepared from mono- and di-functionally reacted dichlorodimethylsilane (DDS) and mono-, di-, tri- and tetra-functionally reacted ethylenediamine (EDA). Varying the feed-ratio afforded control of the microstructures of the oligomers and the preparation of oligomers with, in some cases, conterminously located silicon–chlorine (SiCl) groups. The combination of the NMR methods with the IR technique has enabled the detailed microstructural characterization of the oligomers and the identification of the functionalities therein. This approach and the knowledge gained from the DDS/EDA system has been applied to the microstructural characterization of other hybrid organosilazane/silylamine preceramic telechelic oligomers.     

Theoretical STM images of alkaline-earth metal adsorbed Si(1 1 1)3 × 2 surfaces

We have performed total-energy calculations to study theoretical scanning tunneling microscopy (STM) images of the Si(1 1 1)3 × 2 surfaces induced by the adsorption of alkaline-earth metals (AEMs). Previously, in a series of works on Ba/Si(1 1 1) system, we have found that the observed Si(1 1 1)3 × 1-Ba LEED phase indeed has a 3 × 2 periodicity with a Ba coverage of 1/6 ML and the HCC substrate structure. Based on results of the Ba case, we proposed that the HCC structure is also adopted for other AEM atoms, which was confirmed by our recent work. In this paper, we mainly report the STM simulations for different AEM systems to compare with existing experimental data. We discuss the difference in the detailed STM images for different AEM adsorbates. Especially, the difference in filled-state images between Mg and other AEM atoms is attributed to the strong Mg-Si interaction.     

Assignment of chemical shifts in benzohydroxamic acid and structure of its silylated derivatives by 15N enrichment

¹⁵N isotopic enrichment was necessary for the unequivocal assignment of the ¹H NMR lines to the protons in the NH–OH fragment of benzohydroxamic acid, BHXA, C₆H₅CONHOH, in dry dimethyl sulfoxide solutions. The assignment [δ(NH) = 11.21, δ(OH) = 9.01, ¹J(¹⁵N,¹H) = 102.2 Hz, ²J(¹⁵N,¹H) <1.5 Hz], which is opposite to that used by other authors, confirms the assignment extended to BHXA by Brown and co‐workers from the spectra of acetohydroxamic acid. The enrichment allowed also assignment of the ²⁹Si lines in the spectra of disilylated benzohydroxamic acid, (Z)‐tert‐butyldimethylsilyl N‐tert‐butyldimethylsilyloxybenzoimidate (2) and (Z)‐tert‐butyldiphenylsilyl N‐tert‐butyldiphenylsilyloxybenzoimidate (3), and confirmed structure of the monosilylated products, N‐tert‐butyldiphenylsilyloxybenzamide (4) and N‐tert‐butyldiphenylsilyloxy benzoimidic acid (5). Copyright © 2003 John Wiley & Sons, Ltd.     

Nuclear spin-lattice relaxation mechanisms in kaolinite confirmed by magic-angle spinning

Spin-lattice relaxation mechanisms in kaolinite have been reinvestigated by magic-angle spinning (MAS) of the sample. MAS is useful to distinguish between relaxation mechanisms: the direct relaxation rate caused by the dipole-dipole interaction with electron spins is not affected by spinning while the spin diffusion-assisted relaxation rate is. Spin diffusion plays a dominant role in ¹H relaxation. MAS causes only a slight change in the relaxation behavior, because the dipolar coupling between ¹H spins is strong. ²⁹Si relaxes directly through the dipole-dipole interaction with electron spins under spinning conditions higher than 2 kHz. A spin diffusion effect has been clearly observed in the ²⁹Si relaxation of relatively pure samples under static and slow-spinning conditions. ²⁷Al relaxes through three mechanisms: phonon-coupled quadrupole interaction, spin diffusion and dipole-dipole interaction with electron spins. The first mechanism is dominant, while the last is negligibly small. Spin diffusion between ²⁷Al spins is suppressed completely at a spinning rate of 2.5 kHz. We have analyzed the relaxation behavior theoretically and discussed quantitatively. Concentrations of paramagnetic impurities, electron spin-lattice relaxation times and spin diffusion rates have been estimated.