高生长速度条件下的“层片↔棒状”共晶转变机理研究

低速生长条件下, 共晶“层片↔棒状”转变只由两相的体积分数控制. 高速情况下, 这种转变有时亦发生, 其转变机理不清楚. 本文应用竞争生长准则, 结合高速生长条件下层片共晶和棒状共晶生长模型研究了生长速度引起的“层片↔棒状”转变机理. 结果显示: 体积分数在临界值附近很小的范围内, 生长速度和溶质配分系数的增大可引起“棒状→ 层片”共晶转变; 而当体积分数远离临界值时, 转变不发生. 生长速度名义上引起“层片↔棒状”共晶转变实际上是由生长速度变化引起的体积分数的变化导致的. 关键词： “层片↔棒状”共晶转变 竞争生长 生长速度 体积分数     

Parametric study on a compound-drop spray flame

The introduction of compound-drop spray in a combustion system is a new concept. These droplets bear two gasification stages to cause an integral positive or negative effect on a premixed flame to raise or lower the local temperature of the gasification region. In this paper, we adopt a compound drop which contains a water core encased by a layer of shell fuel. A one-dimensional homogeneous lean or rich premixed flame with the dilute compound-drop spray was investigated by using large activation energy asymptotic analysis. The compound-drop spray burning mode was defined and divided into completely pre-vaporised burning (CPB), shell pre-vaporised burning (SPB) and shell partially pre-vaporised (SPP) burning modes by way of the gasification zones of the shell fuel and the core water relative to the flame position. The influences of the initial droplet radius, the shell-fuel mass fraction and the liquid loading of the compound-drop spray on the lean and rich flames were analysed. By means of the normalisation parameter of flame propagation mass flux (), enhancement, suppression or extinction of the compound-drop spray flame can be represented clearly. Furthermore, from the observation of extinction, the necessary conditions of extinction of a lean spray flame by the internal heat transfer are that the spray is a negative effect and causes a sufficient heat loss rate at flame sheet downstream side. For a rich spray flame, three extinction patterns were observed; they occur in SPP, SPB or at the critical SPB mode, but do not in CPB. The extinction maps of the compound-drop spray demarcate the patterns and also indicate the limitations and corresponding conditions of the flame extinction.     

Influence of Vertical Foam Flow Liquid Drainage on Tube Bundle Heat Transfer Intensity

The results of an experimental investigation of staggered tube bundle heat transfer to upward and downward moving vertical foam flow are presented in this article. It was determined that a dependency exists between tube bundle heat transfer intensity on foam volumetric void fraction, foam flow velocity and direction, and liquid drainage from foam. In addition to this, the influence of tube position of the bundle on heat transfer was investigated. Experimental results were summarized by criterion equations, which can be applied in the design of foam type heat exchangers.     

An experimental study on effects of solid concentration and ζ-potential on pseudoplastic flow of suspensions

The pseudoplastic flow of suspensions, alumina or styrene-acrylamide copolymer particles in water or an aqueous solution of glycerin has been studied by the step-shear-rate method. The relation between the shear rate,D, and the shear stress,, in the step-shear-rate measurements, where the state of dispersion was considered to be constant, was expressed as = AD ^1/2 +CD. The effective solid volume fraction,ø _F, andA were dependent on the shear rate and expressed byø _F =aD ^b andA = D . Combining the above relations, the steady flow curve was expressed by = D ^{1/2 +} + ₀ (1 – a D ^b/0.74)^–1.85 D, where ₀ is the viscosity of the medium.With an increase in solid volume fraction and a decreases in the absolute value of the-potential, the flow behavior of the suspensions changed from Newtonian ( = = b = 0), slightly pseudoplastic ( = b = 0), pseudoplastic ( = 0) to a Bingham-like behavior.The change in viscosity of the medium had an effect on the change in the effective volume fraction.     

Brownian motion of nonlinear oscillators: The projection operator method and its application to a double-well-potential oscillator

A projection operator method is presented, which provides the most efficient way for calculating the stationary behavior of nonlinear Brownian motion. A continued-fraction expansion of the Fourier-Laplace transform of the displacement correlation function or the spectral density is used. This method utilizes a successive optimization procedure on the nonlinear terms and includes the method of statistical linearization as the lowest order approximation. A systematic way to calculate the continued fraction numerically up to sufficient order for convergence is developed, which enables us to obtain the spectral density of a system previously uncomputable.Numerical computations of the spectral density of a nonlinear oscillator with a double-well potential are presented and compared with the results obtained by statistical linearization.This work was supported in part by the National Science Foundation under Grant CHE 75-20624.     

B物理中的难题

讨论单举B介子衰变中的难题, 包括直接CP非对称性及纵向极化分支比, 这些难题可能皆归因于量子色动力学的不准确度, 并非新物理的讯号.     

倾斜下降管气液两相分层流截面含气率的计算与液层高度的预测

分层流是气液两相流中常见的流动型式，分层流中液层高度是计算的基本数据，由于界面波的存在，对液层的测量和预测都很困难．Ｖｌａｃｈｏｓ提出了预测气液两相分层流液层厚度的关系式，但这一关系式并不适用于倾斜下降管气液两相流．本文提出了计算倾斜下降管气液两相分层流截面含气率的理论模型，在这种模型下得到的截面含气率和实验结果符合良好．在大量实验的基础上，考虑了倾角、管径、气液各相折算速度的影响，根据实验数据提出了预测液层厚度的关系式。     

不同入射角度下强流脉冲电子束能量沉积剖面和束流传输系数模拟计算

 强流脉冲电子束在材料中的能量沉积剖面、能量沉积系数和束流传输系数受其入射角的影响很大，理论计算了0.5~2.0MeV的电子束以不同的入射角在Al材料中的能量沉积剖面和能量沉积系数，并且还计算了0.4~1.4MeV电子束以不同入射角穿透不同厚度C靶的束流传输系数。计算结果表明，随着入射角的增大，靶材表面层单位质量中沉积的能量增大，电子在靶材料中穿透深度减小，能量沉积系数减小，相应的束流传输系数也减小；能量为0.5~2.0MeV的电子束当入射角在60°~70°时在材料表面层单位质量中沉积的能量较大。     

Ψ(2S)粒子及粲夸克偶素物理实验研究——2001年度国家自然科学奖获奖项目介绍

文章介绍2001年度国家自然科学奖二等奖获奖成果，在北京正负电子对撞机上采集了Ψ（2S）粒子大数据样本，开展了粲偶素物理的广泛研究：完成了6个粲偶素涉及质量，宽度和衰变化支比等大批重要参数的首次测量或高精度测量；通过对Ψ（2S）和J／Ψ强衰变性质的比较研究，观察到一系列反常现象，挑战现有理论图像。该项研究成果对量子色动力学的检验与发展具有重要意义，为我国粲偶素物理实验研究的继续发展并保持先进水平奠定坚实基础。     

A New Higher Order Shear Deformation Model for Static Behavior of Functionally Graded Plates

In this paper, a new displacement based high-order shear deformation theory is introduced for the static response of functionally graded plate. Unlike any other theory, the number of unknown functions involved is only four, as against five in case of other shear deformation theories. The theory presented is variationally consistent, has strong similarity with classical plate theory in many aspects, does not require shear correction factor, and gives rise to transverse shear stress variation such that the transverse shear stresses vary parabolically across the thickness satisfying shear stress free surface conditions. The mechanical properties of the plate are assumed to vary continuously in the thickness direction by a simple power-law distribution in terms of the volume fractions of the constituents. Numerical illustrations concerned flexural behavior of FG plates with Metal-Ceramic composition. Parametric studies are performed for varying ceramic volume fraction, volume fraction profiles, aspect ratios and length to thickness ratios. The validity of the present theory is investigated by comparing some of the present results with those of the classical, the first-order and the other higher-order theories. It can be concluded that the proposed theory is accurate and simple in solving the static behavior of functionally graded plates.