基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Chiral Interlocked Corrole Dimers Directly Linked at Inner Carbon Atoms of Confused Pyrrole Rings

A facile synthetic strategy towards conformationally stable chiral chromophores based on dimeric porphyrinoids has been established. A peculiar class of face-to-face intramolecularly interlocked corrole dimers were formed by the oxidative C−C coupling linked at the inner carbon sites upon simple treatment of copper(II) ions. Their intrinsic electronic structures were modulated by the peripheral corrole ring annulations, which lead to distinct optical properties and redox profiles. The stereogenic carbon centers implemented in the confused corrole skeleton provided a rationale for designing novel chiral materials.     

Photochemical attachment of polymers on planar surfaces with a covalently anchored monolayer of a novel naphthyl ketone photochemical radical generator

A monolayer of covalently anchored, novel, binaphthyl ketone is used as a surface‐confined photochemical radical generator (PRG) for anchoring a variety of polymers to silicon surfaces. The precursor PRG is synthesized by the application of a facile and novel method for the oxidation of sterically hindered benzylic hydrocarbons to carbonyl compounds. Oxidation was carried out with a stoichiometric amount of potassium peroxydisulfate, in the presence of a catalytic amount of copper sulfate in an acetonitrile/water mixture. The PRG synthesized is characterized by ¹H NMR, UV, and Fourier transform infrared (FTIR). The covalently attached monolayers are characterized by X‐ray photoelectron spectroscopy, ellipsometry, and water contact angle measurements. The method developed is applicable to the preparation of a monolayer of a variety of polymers on a wide range of substrates carrying surface hydroxyl groups. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5413–5423, 2004     

Tetrafunctional initiators for cationic polymerization of olefins

3,3′,5,5′‐Tetrakis(2‐chloro‐2‐propyl)biphenyl (biphenyl tetracumyl chloride, BPTCC) and 1,3‐bis[3,5‐bis(2‐chloro‐2‐propyl)phenoxy]propane (diphenoxypropane tetracumyl chloride, DPPTCC) were synthesized as initiators for quasiliving cationic polymerization of isobutylene (IB). In the synthesis of BPTCC, tetrafunctionality was achieved via the coupling of dimethyl 5‐bromoisophthalate (DMBI) using nickel dibromide bis(triphenylphosphine) and zinc in the presence of a base; in the synthesis of DPPTCC, two equivalents of dimethyl 5‐hydroxyisophthalate were linked via reaction with 1,3‐dibromopropane in the presence of potassium carbonate. Both initiators were used to initiate the polymerization of IB under quasiliving cationic polymerization conditions. PIB initiated from BPTCC revealed a chain end/molecule value (as determined by ¹H‐NMR) of 3.85, verifying the nearly exclusive production of 4‐arm polyisobutylene (PIB). GPC analysis revealed a narrow peak representing the target four‐arm PIB, with a slight shoulder at high elution volumes (low molecular weights). GPC analysis of the PIB initiated by DPPTCC revealed multimodal distributions, suggesting the formation of two‐, three‐, and four‐arm star polymers during the polymerization. This behavior was attributed to Friedel–Crafts alkylation of the initiator core after the addition of one IB unit, which was activated by the electron‐donating oxytrimethyleneoxy linking moiety. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5942–5953, 2004     

Trovacenchemie. 13 [1] Weg und Irrweg zu Di([5]trovacenyl)keton

Trovacene Chemistry. 13 [1] On Being Lead and Mislead in the Synthesis of Di([5]trovacenyl)ketone Di([5]trovacenyl)ketone ( 3¨ ) has been prepared from lithio‐[5]trovacene and dimethylcarbamoyl chloride and studied by X‐ray diffraction, cyclic voltammetry, magnetic susceptometry and EPR spectroscopy. Slight variation of the synthetic protocol affords an unusual trinuclear complex 5 ? that is also fully characterized. Spin‐spin exchange interaction is smaller in 3¨ than in 1,1‐di([5]trovacenylethene ( 2¨ ), which differs from 3¨ by a replacement of O for CH₂. The novel trinuclear complex 5 ? , however, displays exchange coupling very similar to that observed in 1‐methoxy‐2,5,6‐tri([5]trovacenyl)benzene ( 7 ? ). In both cases, an unsymmetrical triangular arrangement of S = 1/2 centers is encountered. These findings are discussed in terms of the nature of the respective spacers.     

Thermal isomerization of trifluoromethyl trifluorovinyl ether to pentafluoropropionyl fluoride

The thermal rearrangement of trifluoromethyl trifluorovinyl ether (MVE) to pentafluoropropionyl fluoride (PPF) under pressure with and without radical initiators has been studied. The reaction typically gives a mixture of different acyl fluorides. The influence of the reaction parameters (pressure, temperature, concentration, type of initiator and contact time) on the conversion and the selectivity of the process has been carefully examined. In addition, a mechanism which accounts for the formation of all the products has been proposed.     

Study of the spontaneous formation of organic layers on carbon and metal surfaces from diazonium salts

This study investigates the spontaneous grafting of different para-substituted phenyl groups on carbon and metallic surfaces from diazonium salts solutions. Glassy carbon, nickel, zinc and iron plates were allowed to react with an acetonitrile solution of aryldiazonium tetrafluoroborate salt by simple dipping. The surfaces were characterized before and after their immersion by XPS and AFM to evidence the formation of a coating on the different materials. The results are indicative of the presence of substituted phenyl groups on all the investigated surfaces. This study also aims at correlating grafting efficiency with metal reactivities and diazonium salt electronic properties by means of AFM and FT-IRRAS. For this purpose, zinc and nickel were chosen due to their opposite reducing properties and two diazonium salts were selected with electron-donor or -withdrawing para-substituents. The results tend to indicate that redox properties of both partners (diazonium + metal) are of prime importance for grafting to occur.     

Synthesis of A2B star block copolymers from a heterotrifunctional initiator

We described the obtention of A₂B star block copolymers through the use of a new heterotrifunctional initiator. That way, well‐defined (PCL)₂‐arm‐PtBuMA and (PCL)₂‐arm‐PS star block copolymers have been synthesized from a heterotrifunctional initiator bearing two hydroxyl groups able to initiate ROP of CL (with AlEt₃ or Sn(Oct)₂ as coinitiator) and a bromide function able to initiate ATRP of tBuMA or styrene. Firstly, we have proceeded using a sequential process (two‐steps), leading to an intermediate macroinitiator. Secondly, attempt to polymerize these two monomers in a simultaneous process (one‐step), that is directly from the mixture of monomers, initiator, coinitiators, and solvent, has been realized and has shown that some interferences between the two polymerizations occurred, leading to an inhibition of ATRP when Sn(Oct)₂ was used and an unexpected increase in control when AlEt₃ was used as catalyst for the ROP (obtention of well‐defined (PCL)₂‐arm‐PtBuMA with pdi of 1.18). © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1796–1806, 2006     

乙酰丙酮稀土四苯基卟啉配合物的电化学研究

本文指出我国环境保护产业发展中存在的问题，论述了“入关“对我国环境保护产业的影响及应采取的经济和税收政策。     

六甲氧基甲基三聚氰胺-多元醇-丙烯酸酯混杂聚合体系的研究

六甲氧基甲基三聚氰胺 (HMMM) 多元醇 丙烯酸酯 酸催化剂混杂聚合体系在高温下同时进行缩聚和自由基聚合并表现出协同效应 .体系中的活泼亚甲基在HMMM的催化下被空气氧化成过氧化氢物 ;过氧化氢物在酸催化下分解成自由基进而引发自由基聚合反应 .研究结果表明 ,体系中存在固化加速的协同效应 ;同时体系中还存在热互补效应 ,丙烯酸酯的自由基聚合反应放出的热可以传递给缩聚反应 ,满足缩聚反应吸热的要求 .混杂聚合得到的高分子合金膜具有优良的机械性能和耐溶剂性能 ,这是由于在混杂聚合过程中形成了互穿聚合物网络 (IPN)结构 .使用潜酸催化剂作为酸的来源 ,可以提高体系的储存稳定性 ;交联 引发剂的使用可以拓宽它的使用范围 ;对超枝化聚合物在混杂体系中的应用也进行了初步研究