Overloaded elution band profiles of ionizable compounds in reversed‐phase liquid chromatography: Influence of the competition between the neutral and the ionic species

The parameters that affect the shape of the band profiles of acido‐basic compounds under moderately overloaded conditions (sample size less than 500 nmol for a conventional column) in RPLC are discussed. Only analytes that have a single pK_a are considered. In the buffer mobile phase used for their elution, their dissociation may, under certain conditions, cause a significant pH perturbation during the passage of the band. Two consecutive injections (3.3 and 10 μL) of each one of three sample solutions (0.5, 5, and 50 mM) of ten compounds were injected on five C₁₈‐bonded packing materials, including the 5 μm Xterra‐C₁₈ (121 Å), 5 μm Gemini‐C₁₈ (110 Å), 5 μm Luna‐C₁₈(2) (93 Å), 3.5 μm Extend‐C₁₈ (80 Å), and 2.7 μm Halo‐C₁₈ (90 Å). The mobile phase was an aqueous solution of methanol buffered at a constant _W^WpH of 6, with a phosphate buffer. The total concentration of the phosphate groups was constant at 50 mM. The methanol concentration was adjusted to keep all the retention factors between 1 and 10. The compounds injected were phenol, caffeine, 3‐phenyl 1‐propanol, 2‐phenyl butyric acid, amphetamine, aniline, benzylamine, p‐toluidine, procainamidium chloride, and propranololium chloride. Depending on the relative values of the analyte pK_a and the buffer solution pH, these analytes elute as the neutral, the cationic, or the anionic species. The influence of structural parameters such as the charge, the size, and the hydrophobicity of the analytes on the shape of its overloaded band profile is discussed. Simple but general rules predict these shapes. An original adsorption model is proposed that accounts for the unusual peak shapes observed when the analyte is partially dissociated in the buffer solution during its elution.     

Studies of a new series of ion-pair complexes [Mo(dtc)_4][Ln(dtc)_4] (Ln=La-Er,exp.Pm)

A new series of ion-pair complexes [Mo(dtc)4][Ln(dtc)4] (Ln=La-Er, exp. Pm) were synthesized from MoCl5, LnCl3 and Nadtc in anhydrous methanol. The crystal structures of the four complexes, [Mo(dtc)4][Ln(dtc)4] (Ln=Nd, Sm, Ho and Er) have been determined by X-ray diffraction. Spectroscopic properties of all these complexes are also discussed here.     

白菜DNA甲基化水平的反相离子对高效液相色谱法研究

建立了反相离子对液相色谱测定白菜的DNA甲基化水平的方法。采用的色谱柱为HypersilBDSC18柱(200mm×4.0mm,5μm),以pH4.0的甲醇-5mmol·L-1庚烷磺酸钠-三乙胺(10:90:0.2,体积比)的混合液为流动相,UV检测器波长为273nm。通过测定DNA水样所产生的胞嘧啶和甲基胞嘧啶的含量,即可得知DNA甲基化程度。胞嘧啶和甲基胞嘧啶回收率分别为99.6%及103.3%,RSD为3.7%(日内)及5.2%(日间)。     

氨基酚异构体的离子对反相液相色谱分析的研究

本文研究了离子对反相液相色谱分析氨基酚异构体的可能性、影响因素和色谱条件，发现以含４×１０－８ｍｏｌ／Ｌ四丁基碘化铵、０．１８４ｍｏｌ／Ｌ醋酸钠的甲醇水溶液（２３：７７）作为流动相，ＯＤＳ为固定相时可以实现氨基酚异构体的良好分离。     

Effect of ionic additives on the elution of sodium aryl sulfonates in supercritical fluid chromatography

Addition of a small amount of polar solvent (i.e., modifier) to CO2 in packed column supercritical fluid chromatography (SFC) has shown major improvements in both polar analyte solubility and interaction of the polar analyte with the stationary phase. Recently, the addition of an ionic component (i.e., additive) to the primary modifier by one of us has been shown to extend even further the application of SFC to polar analytes. In this work, the effect of various ionic additives on the elution of ionic compounds, such as sodium 4-dodecylbenzene sulfonate and sodium 4-octylbenene sulfonate, has been studied. The additives were lithium acetate, ammonium acetate, tetramethylammonium acetate, tetrabutylammonium acetate, and ammonium chloride dissolved in methanol. Three stationary phases with different degrees of deactivation were considered: conventional cyanopropyl, deltabond cyanopropyl, and bare silica. The effect of additive concentration and additive functionality on analyte retention was investigated. Sodium 4-dodecylbenzene sulfonate was successfully eluted using all the additives with good peak shape under isocratic/isobaric/isothermal conditions. Different additives, however, yielded different retention times and in some cases different peak shapes.     

Analysis of Zoledronic Acid and Its Related Substances by Ion-Pair RP-LC

A simple high-performance liquid chromatographic method – ion-pair reversed- phase high performance liquid chromatography (RPIC) has been developed and employed for the analysis of zoledronic acid and its related substances in bulk material and commercial dosage forms. The mobile phase was a mixture of methanol (20%) and 5 mmol L^–1 phosphate buffer (80%) containing 6 mmol L^–1 tetrabutylammonium bromide, adjusted to pH 7.0 with sodium hydroxide. C₈ column was used as the stationary phase. The chromatographic conditions were optimized. The active ingredient – zoledronic acid was successfully separated from its related substances, including remained imidazol-1-yiacetic acid in the synthesis of zoledronic acid and other possible impurities of oxidation and decomposition. The excipients did not interfere with the determination of zoledronic acid in commercial dosage formulations. The method was rapid, simple, accurate and reproducible. It was not only successfully employed for the assay of zoledronic acid in bulk material and pharmaceutical dosage forms but also for the determination of its related substances.     

Determination of paraquat in human blood plasma using reversed-phase ion-pair high-performance liquid chromatography with direct sample injection

This report describes the determination of paraquat (PQ) in human blood plasma samples by a direct-injection reversed-phase ion-pair chromatographic method. Blood plasma filtrate was injected directly into the LiChrospher® RP-18 alkyl-diol silica (ADS) precolumn integrated in a column switching system using a mixture of 3% 2-propanol and 10 mM sodium octane sulfonate (SOS) in a 0.05 M phosphate buffer (pH 2.8). After washing with this phase, the ADS precolumn was back-flushed with the analytical mobile phase consisting of 40% of methanol and 10 mM SOS in a 0.05 M phosphate buffer (pH 2.8) at a flow rate of 1.0 ml min⁻¹, in order to carry the analyte to a conventional reversed-phase analytical column, where the separation of PQ was achieved and finally detected by UV at 258 nm. The recoveries of PQ from human blood plasma samples ranged between 95.0 and 99.5% at nine different concentrations (from 0.05 to 3.00 μg of PQ ml⁻¹) with coefficients of variation <2.5% (n=3). The precision expressed as relative standard deviation was below 3.5% for between-day and below 4.3% for within-day measurements (n=5). The detection limit (signal-to-noise ratio, S/N>3) was 0.005 μg ml⁻¹ with an injection volume of 200 μl. The proposed method is promising for the identification and quantification of PQ at low concentration levels and is suitable for its analysis in human blood plasma samples from intentional or accidental poisonings cases with a sample throughput of 5 samples per hour.     

A quantitative evaluation of the electrostatic theory for ion pair chromatography

Summary A quantitative model for ion pair chromatography based on the electrostatic theory is described. The model is based on the solution of the linearised Poisson-Boltzmann equation in a cylinder. The obtained equations are compared with experimental data from a number of different systems. The agreement between theory and experiments is satisfactorily. Systematic deviations due to the use of the linearised equation and ion correlation effects are discussed.     

Reversed-phase liquid chromatographic method for the analysis of aminoglycoside antibiotics using pre-column derivatization with phenylisocyanate

A pre-column derivatization liquid chromatographic method has been developed for the analysis of aminoglycoside antibiotics using phenylisocyanate as a derivatization reagent. Derivatives including kanamycin, neomycin and gentamicin were formed by reaction of the analytes with phenylisocyanate in the presence of triethylamine. Phenylisocyanato groups were attached to corresponding amino groups of aminoglycoside and their molecular mass was confirmed by liquid chromatography-electrospray ionization-mass spectrometry (LC-ESI-MS). The experimental conditions for derivatization and separation of aminoglycoside derivatives were optimized and validated. A simple liquid chromatographic method for the determination of aminoglycoside antibiotics was demonstrated.     

Insights into the Retention Mechanisms on Perfluorohexylpropylsiloxane-Bonded (Fluophase-RP) and Octadecylsiloxane-Bonded (Betasil C18) Stationary Phases Based on the Same Silica Substrate in RP-LC

The solvation parameter model is used to elucidate the retention mechanism on a perfluorohexylpropylsiloxane-bonded (Fluophase RP) and octadecylsiloxane-bonded (Betasil C18) stationary phases based on the same silica substrate with acetonitrile–water and methanol–water mobile phase compositions. Dewetting affects the retention properties of Fluophase RP at mobile phase compositions containing less than 20% (v/v) acetonitrile or 40% (v/v) methanol. It results in a loss of retention due to an unfavorable change in the phase ratio as well as changes in specific intermolecular interactions. Steric repulsion reduces retention of bulky solutes on fully solvated Betasil C18 with methanol–water (but not acetonitrile–water) mobile phase compositions but is not important for Fluophase RP. The retention of weak bases is affected by ion-exchange interactions on Fluophase RP with acetonitrile–water, and to a lesser extent, methanol-water mobile phases but these are weak at best for Betasil C18. The system constants of the solvation parameter model and retention factor scatter plots are used to compare selectivity differences for Fluophase RP, Betasil C18 and a perfluorophenylpropylsiloxane-bonded silica stationary phase Discovery HS F5 for conditions where incomplete solvation, steric repulsion and ion-exchange do not significantly contribute to the retention mechanism. Lower retention on Fluophase RP results from weaker dispersion and/or higher cohesion moderated to different extents by polar interactions since solvated Fluophase RP is a stronger hydrogen-bond acid and more dipolar/polarizable than Betasil C18. Retention factors for acetonitrile–water mobile phases are highly correlated for Fluophase RP and Betasil C18 except for compounds with a large excess molar refraction and weak hydrogen-bonding capability. Selectivity differences are more significant for methanol–water mobile phases. Retention factors on Fluophase RP are strongly correlated with those on Discovery HSF5 for acetonitrile–water mobile phases while methanol–water mobile phases retention on Fluophase RP is a poor predictor of the retention order on Discovery HS F5.