Proton conductivity of phosphoric acid derivative of fullerene

The proton conductive property of methano [60] fullerene diphosphoric acid has been investigated under various humidity conditions at the temperature range between 15 and 45 °C. It shows proton conductivity as high as 10⁻² S cm⁻¹ at 25 °C under relative humidity of 95%. Thermal analyses including TG–DTA and thermal desorption mass spectroscopy (TDS) confirm that the compound is thermally stable up to 200 °C. Proton conduction of the compound depends very much on humidity or water content. The logarithmic conductivity at 25 °C is increased linearly with increasing relative humidity. The activation energy (E_a) estimated from the slope of log(σT) vs. 1/T is decreased from 1.08 to 0.52 eV, as the relative humidity is increased from 40% to 75%. The humidity dependence of conductivity is discussed in the light of the observed hydration isotherm.     

New protonic solid electrolyte with tetragonal tungsten bronze structure obtained through ionic exchange

Proton exchange reactions have been performed on tetragonal tungsten bronze-like NaNbWO₆ by using nitric acid as an exchanging agent. The characterization of the exchange reaction products has been made by means of chemical analysis, X-ray diffraction, thermal analysis, and IR spectroscopy. The exchange reaction takes place topotactically and the following formula is proposed for the obtained phase of variable composition: Na_1−xH_xNbWO₆·yH₂O (0<x?0.46 and 0?y?0.12). Impedance spectroscopy on the present proton exchanged samples indicated that these samples behaved as solid electrolytes under high humidity. As an example, the compound with the composition Na_0.68H_0.32NbWO₆·0.1 H₂O exhibits ionic conductivity of 8×10⁻³ and 1×10⁻² S cm⁻¹ at 70°C and 90°C, respectively.     

强流四脉冲电子束源实验研究

 为了进行强流多电子束源研究，对现有2MeV LIA 注入器进行了四脉冲改造，二极管脉冲电压约500kV。实验研究了天鹅绒阴极在四脉冲条件下的发射能力、传导电流负载效应以及阴极等离子体运动对阴极电子发射和束能量的影响。利用空间电荷限制流模型推算出阴极等离子体膨胀速率在1 ~4cm/μs之间。     

Preliminary design of high-power wave-guide/transmission system for multimegawatt CW requirements of 100 MeV proton LINAC

Development of a 100 MeV CW proton LINAC has been planned at CAT. This LINAC will be needing CW rf power in the frequency ranges of 350 MHz and 700 MHz for its RFQ and DTL/CCDTL/SFDTL structures respectively. The power to the accelerating structures will be produced by either 1 MW CW or 250 kW CW klystrons/inductive output tubes (HOM IOTs). The power needed by respective feed points in the structure is max. 250 kW which will be powered by splitting the power from 1 MW klystron/klystrode into four channels by using a wave-guide system. In case of using 250 kW tubes the power to the structures will be provided directly from each tube. Two types of wave-guide transmission system have been considered, viz, WR 2300 for 350 MHz rf needs and WR 1500 for 700 MHz rf needs. The typical wave-guide system has been designed using the 1 MW CW klystron followed by wave-guide filter, dual directional coupler, high-power circulator, three 3 dB magic TEE power dividers to split the main channel into four equal channels of 250 kW each. Each individual channel has dual directional couplers, flexible wave-guide sections and high power ceramic vacuum window. The circulator and each power divider is terminated into the isolated ports by high power CW loads. Out of the four channels three channels have phase shifters. Present paper describes the technological aspects and design specifications-considerations for these stringent requirements.     

Proton-exchanged optical waveguides fabricated by glutaric acid

In this paper, we first report that a new proton source, glutaric acid, has been used to fabricate optical waveguides in Z-cut lithium niobate crystals. The relationship was experimentally established between proton-exchanged (PE) waveguide parameters and fabrication conditions. It is shown that this new organic acid can be used to obtain deep PE waveguides in fast diffusion speed (0.275 μm²/h at 221°C) and with low loss (0.2 dB/cm). It provides an alternative approach for fabricating PE waveguides in lithium niobate substrate.     

BF3-doped polyaniline: A novel conducting polymer

We review the unusual structural, transport and magnetic properties of highly conducting polyaniline, doped with boron trifluoride. Our studies establish the unique conducting state of this system, which is in distinct contrast with the conventional proton-doped polyaniline samples.     

Schiff碱水杨醛苯甲酰腙的特性

研究了 Schiff碱水杨醛苯甲酰腙 (简称 SBH)晶体在 DMSO及其 DMSO- H2 O的混合溶剂中的红外光谱 ,通过 SBH氘代前后的 IR对比发现 ,羟基氢质子与混合溶剂 DMSO- H2 O(3∶ 1 ,V/ V)产生较大的相互作用。向溶有 SBH的 75 % DMSO- 2 5 % H2 O的溶液滴加 KOH发现 ,SBH分子上的 C O羰基基团先与 KOH作用 ,其后与 O H 羟基基团作用     

高压下某些导电高分子色散关系的研究

利用晶格动力学方法,研究在高压下几种导电高分子具有不同晶格链时的色散关系及其曲线的变化.链间耦合作用的减弱使横波与纵波的ω差值相应增大,且在BZ边界处拉开一个间隙,这是维度作用的结果.     

60keV质子辐照对TiNi记忆合金薄膜马氏体相变的影响

 利用磁控溅射的方法在氧化后的单晶Si基片上制备了TiNi形状记忆合金薄膜，利用示差扫描量热法和原位X射线衍射研究了薄膜的马氏体相变特征。通过60keV质子注入（辐照）薄膜样品研究了H+离子对合金薄膜马氏体相变特征的影响，结果表明氢离子注入后引起了马氏体相变开始Ms和结束点Mf以及逆马氏体相变开始As和结束温度Af的下降，而对R相变开始Rs和结束温度Rf影响不大。掠入射X射线衍射表明H+离子注入后有氢化物形成。H⁺离子注入形成的氢化物是引起相变点的变化的主要因素。     

Mannich bases as model compounds for intramolecular hydrogen bonding I. Solid state structures and molecular calculations

Summary A survey of the structures and the properties of the hydrogen bonds inortho-aminomethylphenols and -naphthols in the solid state is presented. The results are compared with molecular structure calculations. The solid state complexes can exist in the molecular or in zwitterionic form. In the last case, only intermolecular hydrogen bonds forming cyclic dimers or linear chains were detected.

---

Mannich-Basen als Modelle für Intramolekulare Wasserstoffbrücken, 1. Mitt. Festkörperstrukturen und Molekülrechnungen

Zusammenfassung Eine Übersicht über Strukturen und Eigenschaften von Wasserstoffbrücken inortho-Aminomethylphenolen und -naphtholen wird präsentiert. Die Ergebnisse werden mit Molekülrechnungen verglichen. Im Festkörper existieren diese Verbindungen in neutraler oder in zwitterionischer Form. Für den zweiten Fall können nur intermolekulare Wasserstoffbrücken nachgewiesen werden, und zwar in Dimeren oder in linearen Ketten.