催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

Chromatographic characterization of high‐boiling petroleum fractions

Detailed investigation of solvent‐separated fractions of petroleum vacuum residues is necessary for understanding the separation mechanism using different solvents and to prepare better feedstocks for secondary conversion processes. The efficiency of different solvents to remove polars and insolubles from vacuum residues (of two Indian crude oils) has been studied. The solvents used were n‐heptane, n‐hexane, and n‐pentane (non‐polar) and ethyl acetate (polar). Soluble fractions were characterized for hydrocarbon group type analysis using high performance liquid chromatography (HPLC), average molecular weights using size exclusion chromatography (SEC), and boiling point distribution using high temperature gas chromatography (HTGC). Method development for HPLC analysis involved the study of parameters such as columns, solvent polarity, detectors, model compounds study, calibration, flow, and solvent gradient programming. The study demonstrated that ultimate soluble fractions have the least content of polar structures of the kind which can cause problems, during cracking and are least prone to cracking. The HPLC, SEC, and simulated distillation (SIMDIS) methods developed and standardized are simple, accurate, and suitable for the rapid assay needed for quick compositional surveys.     

Internal standardization for the determination of cadmium,cobalt, chromium and manganese in saline produced water from petroleum industry by inductively coupled plasma optical emission spectrometry after cloud point extraction

In the present paper a procedure is proposed for the determination of traces of Cd, Co, Mn and Cr in petroleum industry produced water by inductively coupled plasma optical emission spectrometry. The procedure is based on cloud point extraction of these metals, as their dithizonate complexes, into the surfactant-rich phase of octylphenoxypolyethoxyethanol surfactant (Triton X-114). Extractions were carried out in solutions with salinities between 10‰ and 70‰. Since residual salinity in the surfactant-rich phase caused differences in its transport to the plasma, yttrium was used as an internal standard to correct for this effect. The simultaneous metal extraction procedure was optimized by response surface methodology using a Doehlert design and desirability function. Enhancement factors of 21, 21, 9 and 19, along with limits of quantification of 0.093, 0.20, 0.73 and 1.2 μg L^− 1, and precision expressed as relative standard deviation (n = 8, 20.0 μg L^− 1) of 5.8, 1.2, 1.7 and 5.7% were obtained for Cd, Co, Mn and Cr, respectively. The accuracy was evaluated by spike recovery tests on the high salinity water samples with salinity of 40 and 63‰.     

CO_2 Reforming of CH_4 over Ni/CeO_2-ZrO_2-Al_2O_3 Prepared by Hydrothermal Synthesis Method

The Ni/CeO2-ZrO2-Al2O3 catalyst with different Al2O3 and NiO contents were prepared by hydrothermal synthesis method. The catalytic performance for CO2 reforming of CH4 reaction, the interaction among components and the relation between Ni content and catalyst surface basicity were investigated. Results show that the interaction between NiO and Al2O3 is stronger than that between NiO and CeO2-ZrO2.The addition of Al2O3 can prevent the formation of large metallic Ni ensembles, increase the dispersion of Ni, and improve catalytic activity, but excess Al2O3 causes the catalyst to deactivate easily. The interaction between NiO and CeO2 results in more facile reduction of surface CeO2. The existence of a small amount of metallic Ni can increase the number of basic sites. As metallic Ni may preferentially reside on the strong basic sites, increasing Ni content can weaken the catalyst basicity.     

稀土添加剂对烃类水蒸汽重整镍催化剂性能的影响——水蒸汽吸附的TPD研究

用程序升温脱附技术,研究了添加稀土的烃类水蒸汽重整催化剂(Ni/α-Al_2O_3)对水蒸汽的吸附性能,同未加稀土的镍催化剂作了对比。结果表明,加有稀土的镍催化剂对水蒸汽的吸附能力主要是稀土的贡献。还原态催化剂对水蒸汽的吸附量比相应的氧化态多1.4倍。发现催化剂对水蒸汽的吸附能力不仅取决于浸渍方式,而且同稀土含量有关。当稀土含量较多时,催化剂表面上呈现出三个能量不同的吸附位。稀土含量少于1.3%时。对提高催化剂吸附水蒸汽的能力已作用不大。含稀土的镍催化剂吸附水蒸汽的能力大,正是其抗结炭性能耐硫性能好的原因。     

Preparation and catalytic performance of superfine Ni/BaTiO3 catalyst

Superfine Ni/BaTiO₃ catalysts were prepared by impregnation method and used successfully for CO₂ reforming CH₄ to syngas. The effects of preparation method and the temperatures of calcination, reduction and reaction on the catalytic activity of the Ni/BaTiO₃ system were investigated. This revised version was published online in June 2006 with corrections to the Cover Date.     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

COMBINED PARTIAL OXIDATION AND CARBONDIOXIDE REFORMING OF METHANE PROCESS TO SYNTHESIS GAS

IntroductionIthasbccndcmonstratcdthatmcthancrcformingt"ithcarbondioxidcpr0ducessynthcsisgasrichincarbonmonoxidc-x"hichisuscfulforthcs}nthcsisofaccticacid'dimcthylcthcrando.o-alcoholsll'2].Carbondioxidcref0rmingismorccndothcrmicthanstcamrcformingfCH4 CO2,'2CO 2H2Ai/'2,,=2473kJ..ol-1(l)Accordingl\"thisrcact1onnccdshighcrtcmpcraturcandlimitsspaccvclocityoffccdgas,Wehavcprct'ious1\studicdmcthancrcformingt"lthC02inthcmonotubcproccssl3J.Inordertoconvcrtmcthancinfccdgascomplctcl}',thcspaccvcloci…     

Supercritical fluid chromatography of petroleum products using flameless sulfur chemiluminescence detection

Supercritical fluid chromatography using flameless sulfur chemiluminescence detection has been investigated for the analysis of sulfur compounds in petroleum products. The chromatography and detection system was easy to implement and exhibited good precision, linearity, selectivity, and sensitivity. A minimum detectable limit of 0.3 pg sulfur/s was obtained, and response to sulfur in different sulfur species was nearly equimolar.     

Parametric study of catalytic reforming process?

Summary A parametric study of catalytic reforming process in a pilot plant was carried out by varying the pressure, H₂/HC ratio, and space velocity. The results show that lower aromatics and higher hydrogen yields can be accomplished by increasing the space velocity in existing reformers, which will also result in better C₅⁺yield.