Preparation and properties of surface modified ceramic membranes. Part III. Gas permeation of 5 nm alumina membranes modified by trichloro-octadecylsilane

Stable trichloro-octadecyl silane (ODS) derivatives of a 5 nm γ-alumina ceramic membrane were prepared. Gas permeabilities of the untreated membrane did not show Knudsen diffusion at 20°C. Gas permeabilities of the ODS membrane were three orders of magnitude lower; He, Ne, Ar, CO₂, C₃H₈ have near constant permeabilities 360 mol s⁻¹ m⁻² bar⁻¹, except methane which has the highest permeability of the group, 481 mol s⁻¹ m⁻² bar⁻¹. The mechanism of diffusion is solution/diffusion. Remarkably, permeabilities of ODS-alumina membrane were reduced by 5 X after exposure to a pressure difference of 1 atm (active layer side) against vacuum for only 10 min. The effect was metastable but could be reversed on standing for several hours, reversal of pressure difference or after washing with (hydrocarbon solvent) toluene. The mechanism was presumed to be due to movement of the octadecyl-hydrocarbon chains of the silane monolayer causing a partially blocked pore structure; perhaps a unique example of self-fouling.     

Preparation and characterization of octadecylsilane monolayers on indium–tin oxide (ITO) surfaces

The preparation and characterization of octadecylsilane, C₁₈, monolayers on indium–tin oxide (ITO) have been studied carefully. A reproducible procedure was developed for the formation of C₁₈/ITO employing octadecyltrimethoxysilane (OTMS) as a monomer. The films were studied by means of electrochemistry, wettability, infrared and atomic force microscopy. All these measurements provide evidence for the formation of a disorganized, ‘brush-type’ monolayer with a maximum surface fractional coverage of 0.90±0.04. The surface coverage can be controlled through the silanization time. The applications and implications of such disorganized monolayers in electroanalytical chemistry are discussed.     

A Comparative Study of Pentafluorophenyl and Octadecylsilane Columns in High‐throughput Profiling of Biological Fluids

In high‐throughput metabolomic profiling, chromatographic separation is crucial because a well‐performed chromatographic separation may reduce signal suppression from complex biological matrices and improve the discoverability of low‐abundance metabolites. We compared the performance of pentafluorophenyl (PFP )‐ and octadecylsilane (ODS )‐based columns in profiling biological fluids. Peak resolutions and consistencies were acquired using several reversed‐phase columns and were evaluated. Total and extracted ion chromatograms demonstrated that the PFP column achieved better analyte separations than the ODS column. Low relative standard deviations on peak areas and retention times (<10.2 and <0.9%, respectively) acquired using the PFP column evidenced the high reproducibility and consistency of this column. In our study, a PFP column was used for profiling metabolomes extracted from urine and serum samples. Metabolomic study revealed a metabolome difference in normal and overweight participants. In total, 26 lipid species were significantly perturbed and further identified. Choline‐containing lipids were the most abundant perturbed lipidome in overweight participants, followed by sphingolipids and various phospholipids. We recommend the use of PFP columns in high‐throughput metabolomic analysis to promote the development of basic biological and clinical research in the future.     

Octadecylsilane/Nylon‐6 composite as a thin‐film microextraction sorbent for the determination of bisphenol A in water samples

We report on the fabrication of a thin‐film composite for the extraction of bisphenol A from aqueous solutions. Nylon‐6, C₁₈ particles, and polyethylene glycol were used to prepare the thin film sorbent. Bisphenol A was used as a model compound to evaluate the extraction efficiency of the sorbent. High‐performance liquid chromatography with UV detection was used for the analysis. The extraction yield of the sorbent was compared with other thin films fabricated using different sorbents including nanoclay, LiChrolut EN, and multiwalled carbon nanotubes. Experimental parameters affecting the extraction performance (extraction time, desorption condition, sample stirring, and ionic strength of the sample solution) were investigated. The detection limit and the dynamic range of the method were 0.05 and 0.15–50 μg/L, respectively. The relative standard deviation of the method at two concentration levels (0.5 and 20 μg/L) was less than 7.2%. Finally, a polycarbonate baby bottle, river water, and wastewater samples were analyzed by the method.     

One-dimensional silicone nanofilaments

A decade ago one-dimensional silicone nanofilaments (1D-SNF) such as fibres and wires were described for the first time. Since then, the exploration of 1D-SNF has led to remarkable advancements with respect to material science and surface science: one-, two- and three-dimensional nanostructures of silicone were unknown before. The discovery of silicone nanostructures marks a turning point in the research on the silicone material at the nanoscale. Coatings made of 1D-SNF are among the most superhydrophobic surfaces known today. They are free of fluorine, can be applied to a large range of technologically important materials and their properties can be modified chemically. This opens the way to many interesting applications such as water harvesting, superoleophobicity, separation of oil and water, patterned wettability and storage and manipulation of data on a surface. Because of their high surface area, coatings consisting of 1D-SNF are used for protein adsorption experiments and as carrier systems for catalytically active nanoparticles.     

Simple water analysis of golf link pesticides by means of batch-wise adsorption and supercritical fluid extraction

Here, a simple new method is proposed to evaluate water for the presence of pesticides. Specifically, pesticides for golf link maintenance were used as the targets for this investigation. Water samples containing the pesticides were mixed with particulate adsorbent, after which the pesticides were extracted from the adsorbents using supercritical fluid carbon dioxide and then analyzed by gas chromatography-mass spectrometry. The recoveries of pesticides were examined with several types of adsorbents and found to be related to their octanol/water partition coefficients (K_ow) for most of the adsorbents. Good recoveries were obtained when the water samples were mixed with octadecylsilane (ODS) and stylene-divinylbenzene copolymer (XAD) resins for 15 and 30 min, respectively. In the supercritical fluid extraction, extraction pressure affected the efficiency of extraction from XAD while a little effect on extraction from ODS, probably due to the internal structure of the adsorbents. The limit of detection ranged from 0.002 to 2.3 μg L⁻¹ and the method is suitable for the measurement of golf link pesticides in μg L⁻¹ order to 100 μg L⁻¹. The procedure of the proposed method was simpler than the conventional solid-phase extraction method. Finally, the method presented here was used to identify pesticides present in actual wastewater from golf links.     

A novel octadecylsilane functionalized graphene oxide/silica composite stationary phase for high performance liquid chromatography

An octadecylsilane functionalized graphene oxide/silica stationary phase was fabricated by assembling graphene oxide onto the silica particles through an amide bond and subsequent immobilization of octadecylsilane. The chromatographic properties of the stationary phase were investigated by reversed-phase chromatography with alkylbenzenes, polycyclic aromatic hydrocarbons, amines, and phenolic compounds as the analytes. All the compounds achieved good separation on the column. The comparison between a C18 commercial column and the new stationary phase indicated that the existence of π-electron system of graphene oxide allows π-π interaction between analyte and octadecylsilane functionalized graphene oxide/silica stationary phase except for hydrophobic interaction, while only hydrophobic interaction presented between analyte and C18 commercial column. This suggests that some analytes can be better separated on the octadecylsilane functionalized graphene oxide/silica column.     

Modified QuEChERS method for phenolic compounds determination in mustard greens (Brassica juncea) using UHPLC-MS/MS

A modified QuEChERS method (Quick, Easy, Cheap, Effective, Rugged, and Safe) for the determination of fifteen phenolic compounds in mustard greens (Brassica juncea) using ultra-high-performance liquid chromatography coupled to tandem mass spectrometry (UHPLC-MS/MS) analysis was developed. The QuEChERS partitioning step and dispersive solid phase extraction (d-SPE) clean-up sorbents were investigated, aimed at phenolic compound extraction and pigment removal, respectively. QuEChERS acetate version combined with 25 mg of diatomaceous earth (DE) and 5.0 mg of graphitized carbon black (GCB) provided the best conditions for sample preparation of the target compounds. Under the optimized conditions, all phenolic compounds showed good linearity (r ≥ 0.99) over the concentration range of 0.1 to 8000 μg kg⁻¹, and the quantification limits were in the range of 0.06–230 μg kg⁻¹. The spectrophotometric analysis showed that the clean-up step promoted a significant removal of chlorophyll, which is the major pigment present in the sample. Furthermore, antioxidant activity analysis was also carried out after the clean-up step and, together with chromatographic data, showed that no significant retention of the phenolic compounds occurs in the clean-up step. Two mustard greens varieties – Southern Giant Curled (SGC) and Florida Broadleaf (FB) - were analyzed with the proposed method. Seven phenolic compounds (4-hydroxybenzoic, p-coumaric, ferulic and sinapic acids, naringenin, apigenin and kaempferol) were found in both varieties, the greatest abundance being for sinapic acid (1261.5 ± 23 μg kg⁻¹ in SGC and 1235.5 ± 26 μg kg⁻¹ in FB) and ferulic acid (2861 ± 24 μg kg⁻¹ in SGC and 3204.5 ± 45 μg kg⁻¹ in FB).     

Application of derivatized magnetic materials to the separation and the preconcentration of pollutants in water samples

Monitoring pollutants in water samples is a challenge to analysts. In recent years, separation technology based on magnetic materials has received considerable attention. This article reviews the literature dealing with the application of magnetic materials, combined with other materials (e.g., silica, octadecylsilane, polymers and surfactants), to the separation and the preconcentration of pollutants in water samples. The magnetic extraction method is not only convenient, economical and highly efficient, but it also overcomes problems with conventional solid-phase extraction, (e.g., packing of sorbent into the column and time-consuming loading of large-volume samples).