Caesium carbonate supported on hydroxyapatite‐encapsulated Ni0.5Zn0.5Fe2O4 nanocrystallites as a novel magnetically basic catalyst for the one‐pot synthesis of pyrazolo[1,2‐b]phthalazine‐5,10‐diones

A novel nanomagnetic basic catalyst of caesium carbonate supported on hydroxyapatite‐coated Ni_0.5Zn_0.5Fe₂O₄ magnetic nanoparticles (Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃) was prepared. This new catalyst was fully characterized using Fourier transform infrared spectroscopy, transmission and scanning electron microscopy, X‐ray diffraction and vibrating sample magnetometry techniques, and then the catalytic activity of this catalyst was investigated in the synthesis of 1H‐pyrazolo[1,2‐b]phthalazine‐5,10‐dione derivatives. Also, Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃ could be reused at least five times without significant loss of activity and could be recovered easily by applying an external magnet. Thus, the developed nanomagnetic catalyst is potentially useful for the green and economic production of organic compounds. Copyright © 2015 John Wiley & Sons, Ltd.     

Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

Ni(111)表面一氧化碳和氢共吸附的密度泛函理论研究

本文用密度泛函理论(DFT)的总能计算研究了一氧化碳和氢原子在Ni(111)表面上p(2×2)共吸附系统的原子结构和电子态，结果表明CO和H原子分别被吸附于两个对角p(1×1)元胞的hcp和fcc位置.以氢分子和CO分子作为能量参考点，总吸附能为2.81 eV，相应的共吸附表面功函数φ为6.28 eV.计算得到的C—O，C—Ni和H—Ni的键长分别是1.19?, 1.96?和 1.71?，并且CO分子以C原子处于hcp的谷位与金属衬底原子结合.衬底Ni(111)的最外两层的晶面间距在吸附后的相对变化分别是 关键词： Fisher-Tropsch反应 催化作用 Ni(111) p(2×2)/(CO+H) 共吸附     

(Ni0.8Zn0.2Fe2O4)epoxy-PZT双层膜中的磁电效应

讨论了Ni_0.8Zn_0.2Fe₂O₄ (NZFO)与锆钛酸铅(PZT)的双层膜结构样品的磁电(ME)效应.NZFO粉料由溶胶-凝胶法制成，再经900℃热压，并高温烧结.在该双层膜中测量到了很强的磁电相互作用.发现横向的磁电效应比纵向效应大一个数量级，并且随NZFO烧结温度的提高而增加.当烧结温度从950℃上升到1380℃时，横向ME电压系数(α_E)的最大值变化范围为25.6 mV Am^-2≤α_E≤199.6 mV Am^-2.理论分析显示NZFO-PZT双层膜样品中ME效应源于NZFO与PZT之间相对良好的磁电耦合. 关键词： 镍铁氧体 PZT 热压法 ME效应     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

成分和厚度的依赖

通过调整Mn的成分，系统地研究了Ni81Fe19/Ni100-xMnx双层膜的磁学性质，特别是交换偏置场(Hex)的变化.当Ni100-xMnx中Mn的原子百分比在534%到600%之间时，对于150nm的Ni81Fe19，得到了最大的交换偏置场175kA/m，同时由于Mn对Ni81Fe19层的扩散所造成的磁矩的降低小于20%；高角x射线衍射证明Ni100-xMnx的晶格常数随着Mn成分的改变而变化，Mn含量越多，其晶格常数越大；制备态Ni100-xMnx膜晶格常数与θ相NiMn膜晶格常数的接近程度与NiMn膜θ相形成的容易程度相对应.也研究了交换偏置场随着Ni１００-xMnx厚度的变化，第一次得到了当Ni100-xMnx中Mn的原子百分比为706%时，Ni81Fe19(150nm)/Ni100-xMnx(90nm)双层膜在经过240℃，5h退火后，可以有80kA/m的交换偏置场，此时铁磁层磁矩的大小几乎不变. 关键词： Ni81Fe19/Ni100-xMnx 交换偏置场     

Investigation of thin-film electroluminescent structures on rough subsrates

Results of experimental investigations of the volt-brightness characteristics, frequency dependences of brightness, and the directional radiation pattern of electroluminescent MSDM, MSCM, and MSDCM emitters, where M stands for the first transparent and second nontransparent electrodes, S is a semiconductor, D is a thin-film dielectric, and C is a silicone-based composite liquid dielectric with a powdered segnetoelectric filler, developed on conventional “smooth” and rough glass substrates are presented. It is shown that electroluminescent structures on rough surfaces have a brightness approximately two times higher than that of similar structures developed on a “smooth” substrate. Ul’yanovsk State University, 42, L. Tolstoi St., Ul’yanovsk, 432700, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 4, pp. 507–512, July–August, 1997.     

Si衬底上ZnSe外延膜的低压MOCVD生长

以硒化氢（H2Se）和二甲基锌为源材料，生长温度是300℃时，用低压金属有机化学气相沉积（LP－MOCVD）系统在Si(111)衬底上外延生长了ZnSe薄膜。通过X射线衍射（XRD）、扫描电子显微镜的能量色散（EDS）以及光致发光（PL）实验验证ZnSe外延膜的质量，在X射线衍射谱中只有一个强的ZnSe(111)面衍射峰，这说明外延膜是（111）取向的单晶薄膜，在能量色散谱中除了Si,Zn和Se原子外，没有观测到其他原子，说明ZnSe外延膜中杂质含量较少。ZnSe外延膜中Zn/Se原子比接近1，有较好的化学配比。在ZnSe外延膜的77K光致发光谱中没有观测到与深中心发射相关的发光峰，表明ZnSe外延膜的晶格缺陷密度较小。77K时的近带边发射峰447nm在室温时移至465nm附近。     

High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayers

High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayer (ML) up to 600 °C have been studied and reported in this paper. Ti/Ni multilayer samples having constant layer thicknesses of 50 Å each are deposited on float glass and Si(1 1 1) substrates using electron-beam evaporation technique under ultra-high vacuum (UHV) conditions at room temperatures. The micro-structural parameters and their evolution with temperature for as-deposited as well as annealed multilayer samples up to 600 °C in a step of 100 °C for 1 h are determined by using X-ray diffraction (XRD) and grazing incidence X-ray reflectivity techniques. The X-ray diffraction pattern recorded at 300 °C annealed multilayer sample shows interesting structural transformation (from crystalline to amorphous) because of the solid-state reaction (SSR) and subsequent re-crystallization at higher temperatures of annealing, particularly at ≥400 °C due to the formation of TiNi₃ and Ti₂Ni alloy phases. Sample quality and surface morphology are examined by using atomic force microscopy (AFM) technique for both as-deposited as well as annealed multilayer samples. In addition to this, a temperature dependent dc resistivity measurement is also used to study the structural transformation and subsequent alloy phase formation due to annealing treatment. The corresponding magnetization behavior of multilayer samples after each stage of annealing has been investigated by using Magneto-Optical Kerr Effect (MOKE) technique and results are interpreted in terms of observed micro-structural changes.     

Vibrational EELS and DFT study of propionic acid and pyruvic acid on Ni(1 0 0): Effects of keto group substitution on room-temperature adsorption and thermal chemistry

The room-temperature adsorption and thermally induced processes of propionic acid and pyruvic acid on Ni(1 0 0) have been investigated by electron energy loss spectroscopy (EELS). Computational vibrational analysis of the optimized bidentate structures for acid-Ni model complexes (involving the organic acid and a Ni atom) has been performed by using the two-layer ONIOM method with the Density Functional Theory and used to interpret the vibrational EELS data. Dehydrogenation of the hydroxyl group is found to result in bonding of the carboxylate group in the propionate and pyruvate adspecies to either a single Ni surface atom in a bidentate configuration or two neighbouring Ni atoms in a bridge configuration. Given the similarities in the total energies and related vibrational frequencies obtained by the calculations in the case of pyruvate adspecies, it is difficult to differentiate the alternate adsorption structure, in which the keto O and hydroxyl O atoms are bonded to a Ni atom in a five-member chelate ring configuration. Furthermore, temperature-dependent EELS studies show that both the propionate and pyruvate adspecies could decompose upon annealing to above 400 K and further dissociate to CO adspecies above 550 K and to C and/or O above 600 K.