The “Fingerprint” of a freshwater microalga Scenedesmus sp. LX1: Visualizing the composition of its soluble algal products

The composition of soluble algal products was visualized by a fingerprint analytical method.     

Single Chlamydomonas reinhardtii cell separation from bacterial cells and auto-fluorescence tracking with a nanosieve device

A planar, transparent, and adaptable nanosieve device is developed for efficient microalgae/bacteria separation. In the proposed method, a sacrificial layer is applied with dual photolithography patterning to achieve a 1D channel with a very low aspect ratio (1:10 000). A microalgae/bacteria mixture is then introduced into the deformable PDMS nanochannel. The hydrodynamic deformation of the nanochannel is regulated to allow the bacteria cells to pass through while leaving the microalgae cells trapped in the device. At a flow rate of 4 μL/min, the supernatant collected from the device is indistinguishable from a control solution, indicating that nearly all the microalgae cells are trapped in the device. Additionally, this device is capable of single cell auto-fluorescence tracking. These microalgae cells demonstrate minimal photobleaching over 250 s laser exposure and could be used to monitor hazardous compounds in the sample with a continuous flow. This method will be valuable to purify microalgae samples containing contaminations and study single-cell heterogeneity.     

Microalgae separation by inertia-enhanced pinched flow fractionation

To improve the accuracy and efficiency of ships’ ballast water detection, the separation of microalgae according to size is significant. In this article, a method to separate microalgae based on inertia-enhanced pinched flow fractionation (iPFF) was reported. The method utilized the inertial lift force induced by flow to separate microalgae according to size continuously. The experimental results show that, as the Reynolds number increases, the separation effect becomes better at first, but then stays unchanged. The best separation effect can be obtained when the Reynolds number is 12.3. In addition, with the increase of the flow rate ratio between sheath fluid and microalgae mixture, the separation effect becomes better and the best separation effect can be obtained when the flow rate ratio reaches 10. In this case, the recovery rate of Tetraselmis sp. is about 90%, and the purity is about 86%; the recovery rate of Chlorella sp. is as high as 99%, and the purity is about 99%. After that, the separation effect keeps getting better but very slowly. In general, this study provides a simple method for the separation of microalgae with different sizes, and lays a foundation for the accurate detection of microalgae in the ballast water.     

改性ZSM-5分子筛催化裂解湛江等鞭金藻制取低碳烯烃(英)

研究了湛江等鞭金藻(Isochrysis zhanjiangensis)在改性ZSM-5分子筛上催化裂解制取低碳烯烃的过程.与热裂解过程相比,湛江等鞭金藻催化裂解可以得到更高的低碳烯烃选择性和收率.同时还研究了湛江等鞭金藻中不同油脂和藻渣的催化裂解.结果表明,微藻中的油脂能有效转化为烯烃,其中中性脂的烯烃收率最高,可达36.7%.不同溶剂抽提后得到的藻渣也可转化为低碳烯烃,但收率远低于微藻中的油脂.微藻中的油脂,特别是中性脂,是烯烃的主要贡献者,提高微藻中的中性脂含量能够得到更高的低碳烯烃收率.     

Unexpected acceleration of Ultrasonic-Assisted iodide dosimetry in the catalytic presence of ionic liquids

This study investigates the potential of using small amounts of ionic liquids (IL) to enhance ultrasound-assisted extraction of lipids content from green microalgae. Three imidazolium-based ILs (butyl, octyl and dodecyl), each of them with two anions (bromide and acetate) were tested as additives. Viscosity and surface tension of the ILs aqueous mixtures were analyzed to determine the influence of ILs’ anions and alkyl chain length, whereas KI dosimetry experiments were used as an indicator of radicals formation. A key finding suggests that the small addition of ILs improves the ultrasonication either by enhancing the viscosity and reducing the water surface tension, leading to a more powerful acoustic cavitation process or by increasing HO° production likely to oxidize the microalgae cells membranes, and consequently disrupting them on a more efficient manner. KI dosimetry also revealed that long ILs alkyl chain is detrimental. This experimental observation is confirmed thus strengthened as the yield of extracted lipids from green microalgae has shown an incremental trend when the IL concentration also increased. These hypotheses are currently under investigation to spot detailed impact of ILs on cavitation process.     

Introducing nonlinear,multivariate ‘Predictor Surfaces’ for quantitative modeling of chemical systems with higher-order,coupled predictor variables

Innovations in chemometrics are required for studies of chemical systems which are governed by nonlinear responses to chemical parameters and/or interdependencies (coupling) among these parameters. Conventional and linear multivariate models have limited use for quantitative and qualitative investigations of such systems because they are based on the assumption that the measured data are simple superpositions of several input parameters. ‘Predictor Surfaces’ were developed for studies of more chemically complex systems such as biological materials in order to ensure accurate quantitative analyses and proper chemical modeling for in-depth studies of such systems. Predictor Surfaces are based on approximating nonlinear multivariate model functions by multivariate Taylor expansions which inherently introduce the required coupled and higher-order predictor variables.     

甲酸处理对微藻油脂提取的影响

采用易于回收的有机酸处理微藻细胞,以微藻Chlorella protothecoides为原料,系统研究了甲酸处理对微藻油脂提取的影响.结果表明,甲酸能有效破碎微藻细胞,最终油脂得率和脂肪酸甲酯(FAME)得率均与传统无机酸热法相当.甲酸浓度、温度和处理时间对油脂提取有显著影响.当甲酸浓度为88%,液固比为6 m L/g,100℃下处理30 min,Chlorella protothecoides油脂得率为49.2%,FAME得率高达92.1%.甲酸处理提取到的微藻油脂脂肪酸组成与无机酸热法结果无明显区别.Chlorella protothecoides油脂主要含有5种脂肪酸,其中C18∶1含量最高.实验还考察了甲酸处理对Nannochlorum sp和Nannochloropsis oceanic的适用性,结果表明,对于不同微藻原料,甲酸处理提取到的微藻油脂得率和FAME得率均与无机酸热法结果相当.     

Separation of triacylglycerols and free fatty acids in microalgal lipids by solid-phase extraction for separate fatty acid profiling analysis by gas chromatography

Microalgal lipids were separated into two fractions, triacylglycerols (TAGs) and free fatty acids (FFAs), by solid-phase extraction employing sodium carbonate as the sorbent and dichloromethane (20% by volume) in n-hexane as the extracting solvent. The TAG fraction was then saponified, followed by acidification, extraction and tert-butyldimethylsilyl esterification. The FFA fraction was directly acidified, extracted and derivatized. From the lipid extracts of eight microalgal species examined, a total of 13 fatty acids were detected in the TAG fractions and nine were found in the FFA fractions, with at much higher total TAG content in all microalgae. Oleic acid was the most prominent fatty acid in three species, α-linolenic acid was more abundant in two others, and palmitic acid was present in highest concentration in the remaining three species.     

Production of methyl ester fuel from microalgae

Microalgae are unique photosynthetic organisms that are known to accumulate storage lipids in large quantitites and thrive in saline waters. Before these storage lipids can be used, they must be extracted from the microalgae and converted into usable fuel. Transesterification of lipids produces fatty acid methyl esters that can be used as a diesel fuel substitute. Three solvents, 1-butanol, ethanol, and hexane/2-propanol, were evaluated for extraction efficiency of microalgal lipids. Type of catalyst, concentration of catalyst, time of reaction, temperature of reaction, and quality of lipid were examined as variables for transesterification. The most efficient solvent of the three for extraction was 1-butanol (90% efficiency), followed by hexane/2-propanol and ethanol. Optimal yield of fatty acid methyl esters was obtained using 0.6N hydrochloric acid in methanol for 0.1 h at 70°C.     

Characterization of proteins from Spirulina platensis microalga using capillary electrophoresis-ion trap-mass spectrometry and capillary electrophoresis-time of flight-mass spectrometry

In this work, a new capillary electrophoresis-mass spectrometry (CE-MS) procedure is developed to analyze proteins in Spirulina platensis microalgae. It is demonstrated that a fine optimization of several separation parameters is essential in order to achieve suitable CE-MS analysis of these proteins in natural extracts from microalgae. Namely, optimization of the composition of the separation buffer, electrospray conditions, and washing routine between runs are required in order to obtain reliable and reproducible CE-MS analyses of the main proteins found in this microalga (namely, allophycocyanin-alpha chain, allophycocyanin-beta, c-phycocyanin-alpha, and c-phycocyanin-beta). The relative molecular mass of these biopolymers is determined using two different MS instruments coupled to CE, i.e., CE-ion trap-MS and CE-time of flight-MS (CE-TOF-MS). A comparison between the results obtained with both instruments is carried out. The high resolution of the TOF-MS enables the distinction of small modifications in proteins and, thus, a more accurate mass determination. Interestingly, molecular mass values obtained by both CE-MS procedures agree very well while these experimental values are only in partial agreement with those theoretically expected (i.e., genetically derived masses). Some protein modifications due to amino acids exchange induced by nucleotide codon mutations are proposed to explain this difference.