Het(aryl)isatin to het(aryl)aminoindoline scaffold hopping: A route to selective inhibitors of matrix metalloproteinases

Matrix metalloproteinases (MMPs) are a large family of zinc-dependent endoproteases known to exert multiple regulatory roles in tumor progression. A variety of chemical classes have been explored for targeting individual MMP isoforms. In the present study, we further developed our isatin based scaffold BB0223107 capable of binding to and inactivating MMP-2 in a zinc-independent manner (Agamennone et al., 2016). Forty four new compounds were synthesized based on the modified BB0223107. All compounds were tested in enzyme inhibition assays against MMP-2, ?8 and ?13. SAR studies demonstrated that 5-het(aryl)-3-aminoindolin-2-ones (37–39) were active toward MMP-2 and MMP-13. The most potent compounds 33 and 37 displayed an IC₅₀ of 3 µM against MMP-13 and showed a negligible activity toward MMP-8; almost all new compounds were inactive toward MMP-8. Replacement of the isatin ring with a biaryl system (compound 33) did not decrease the potency against MMP-13 but reduced the selectivity. Structure-based computational studies were carried out to rationalize the inhibitory activity data. The analysis of binding geometries confirmed that all fragments occupied the S1′ site in the three enzymes while no ligand was able to bind the catalytic zinc ion. To the best of our knowledge, this is the first example of 3-aminoindolin-2-one-based MMP inhibitors that, based on the computer modeling study, do not coordinate the zinc ion. Thus, the het(aryl)-3-aminoindolin-2-one derivatives emerge as a drug-like and promising chemotype that, along with the hetaryl variations, represents an alternative and thrifty tool for chemical space exploration aimed at MMP inhibitor design.     

Formal proofs of operator identities by a single formal computation

A formal computation proving a new operator identity from known ones is, in principle, restricted by domains and codomains of linear operators involved, since not any two operators can be added or composed. Algebraically, identities can be modelled by noncommutative polynomials and such a formal computation proves that the polynomial corresponding to the new identity lies in the ideal generated by the polynomials corresponding to the known identities. In order to prove an operator identity, however, just proving membership of the polynomial in the ideal is not enough, since the ring of noncommutative polynomials ignores domains and codomains. We show that it suffices to additionally verify compatibility of this polynomial and of the generators of the ideal with the labelled quiver that encodes which polynomials can be realized as linear operators. Then, for every consistent representation of such a quiver in a linear category, there exists a computation in the category that proves the corresponding instance of the identity. Moreover, by assigning the same label to several edges of the quiver, the algebraic framework developed allows to model different versions of an operator by the same indeterminate in the noncommutative polynomials.     

3D‐morphology reconstruction of nanoscale phase‐separation in polymer memory blends

In many organic electronic devices functionality is achieved by blending two or more materials, typically polymers or molecules, with distinctly different optical or electrical properties in a single film. The local scale morphology of such blends is vital for the device performance. Here, a simple approach to study the full 3D morphology of phase‐separated blends, taking advantage of the possibility to selectively dissolve the different components is introduced. This method is applied in combination with AFM to investigate a blend of a semiconducting and ferroelectric polymer typically used as active layer in organic ferroelectric resistive switches. It is found that the blend consists of a ferroelectric matrix with three types of embedded semiconductor domains and a thin wetting layer at the bottom electrode. Statistical analysis of the obtained images excludes the presence of a fourth type of domains. The criteria for the applicability of the presented technique are discussed. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1231–1237     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Formation of porous polymer morphology by microsyneresis during divinylbenzene polymerization

This article describes the investigation of the importance of various reaction conditions on microsyneretic pore formation during polymerization of divinylbenzene (DVB) under so‐called “solvothermal” conditions. To induce microsyneretic pore formation, the most important parameter is an unusually high dilution of monomers with a “good” porogen solvating the polymer chains. High dilution and solvation of the growing poly(DVB) chains promote the prolongation of the polymer chains rather than their interconnection by crosslinking. Consequently, when the polymer gel density reaches the point where syneresis starts, the polymer network is geometrically too extensive to be broken up into precipitating entities and, instead, porogen droplets are formed within the continuous polymer gel. The pore geometry created by microsyneresis offers high surface area in wide mesopores and hence, high capacity for supporting functional groups or reactions with much better accessibility than narrow pores between polymer microspheres produced by macrosyneresis in conventional styrenic polymer supports. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 774–781     

Crosslinked poly(ethylene oxide) containing siloxanes fabricated through thiol‐ene photochemistry

Homogenous amphiphilic crosslinked polymer films comprising of poly(ethylene oxide) and polysiloxane were synthesized utilizing thiol‐ene “ click ” photochemistry. A systematic variation in polymer composition was Carried out to obtain high quality films with varied amount of siloxane and poly(ethylene oxide). These films showed improved gas separation performance with high gas permeabilities with good CO₂/N₂ selectivity. Furthermore, the resulting films were also tested for its biocompatibility, as a carrier media which allow human adult mesenchymal stem cells to retain their capacity for osteoblastic differentiation after transplantation. The obtained crosslinked films were characterized using differential scanning calorimetry, dynamic mechanical analysis, thermogravimetric analysis, FTIR, Raman‐IR , and small angle X‐ray scattering. The synthesis ease and commercial availability of the starting materials suggests that these new crosslinked polymer networks could find applications in wide range of applications. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1548–1557     

矩阵方程A^TXB=C的正定和半正定解

给出了矩阵方程Ａ＾ＴＸＢ＝Ｃ在正定和半正定矩阵类中有解的充要条件及解的一般表达式。     

Interlaboratory comparisons and improvements of methods for acid number determination in used motor oils

The results of two interlaboratory comparisons of acid number determinations in used motor oils are discussed. It is shown that the comparability of the measurement results is not as good as that required by known standards for petroleum products. The problem is motor oil contaminants which accumulated during use, and which are the source of a matrix effect in the acid number determination. The standard methods’ drawbacks are analyzed and some improvements are proposed. Repeatability and accuracy of the improved methods are evaluated. Received: 11 December 2001 Accepted: 15 February 2002     

Economic Equilibrium: Optimality and Price Decentralization

Mathematical economics has a long history and covers many interdisciplinary areas between mathematics and economics. At its center lies the theory of market equilibrium. The purpose of this expository article is to introduce mathematicians to price decentralization in general equilibrium theory. In particular, it concentrates on the role of positivity in the theory of convex economic analysis and the role of normal cones in the theory of non-convex economies.